Denver HVAC Repair

"Highly recommend! From the time I contacted them to make an appointment, to them showing up, troubleshooting the issue with my a/c unit, them verifying my warranty and driving to Grapevine to get the part, then back to Fort Worth to install it was LESS than 24 hours. Outstanding service, price and knowledge. I will only use this company from now on. Would give ten stars if possible."
In very dry climates, evaporative coolers, sometimes referred to as swamp coolers or desert coolers, are popular for improving coolness during hot weather. An evaporative cooler is a device that draws outside air through a wet pad, such as a large sponge soaked with water. The sensible heat of the incoming air, as measured by a dry bulb thermometer, is reduced. The temperature of the incoming air is reduced, but it is also more humid, so the total heat (sensible heat plus latent heat) is unchanged. Some of the sensible heat of the entering air is converted to latent heat by the evaporation of water in the wet cooler pads. If the entering air is dry enough, the results can be quite substantial.
The contactor (relay) and start/run capacitor(s) (see illustration below) fail most often and are inexpensive. So it’s a safe bet to buy and install those parts right away, especially if your air conditioning service unit is older than five years. The condenser fan motor can also fail, but it runs about $150 — hold off buying that unless you’re sure that’s the culprit.
From Day 1, Alberto walked us through the process, and present us with a variety of options based our budget for the project. His customer service is the best as he did not oversell any services and did not nudge us towards buying a unit that would stretch our budget. On installation day, HVAC Services sent out a crew of 6-7 guys, all of whom were very polite and kept their work areas clean, and installed the whole system the same day.

Architectural acoustics Architectural engineering Architectural technologist Building services engineering Building information modeling (BIM) Deep energy retrofit Duct leakage testing Environmental engineering Hydronic balancing Kitchen exhaust cleaning Mechanical engineering Mechanical, electrical, and plumbing Mold growth, assessment, and remediation Refrigerant reclamation Testing, adjusting, balancing
Ground source, or geothermal, heat pumps are similar to ordinary heat pumps, but instead of transferring heat to or from outside air, they rely on the stable, even temperature of the earth to provide heating and air conditioning. Many regions experience seasonal temperature extremes, which would require large-capacity heating and cooling equipment to heat or cool buildings. For example, a conventional heat pump system used to heat a building in Montana's −70 °F (−57 °C) low temperature or cool a building in the highest temperature ever recorded in the US—134 °F (57 °C) in Death Valley, California, in 1913 would require a large amount of energy due to the extreme difference between inside and outside air temperatures. A few feet below the earth's surface, however, the ground remains at a relatively constant temperature. Utilizing this large source of relatively moderate temperature earth, a heating or cooling system's capacity can often be significantly reduced. Although ground temperatures vary according to latitude, at 6 feet (1.8 m) underground, temperatures generally only range from 45 to 75 °F (7 to 24 °C).

Does your home's temperature need a little adjusting? An HVAC contract is a document that establishes your agreement with the contractor you hire to fix or maintain your heating, ventilation and air conditioning systems. It's best to create a free HVAC contract before the work has even begun. We'll help you take down the details of your project so work can begin and your place will get back to a comfy temperature, fast.
Modern air conditioning emerged from advances in chemistry during the 19th century, and the first large-scale electrical air conditioning was invented and used in 1902 by England inventor Willis Carrier. The introduction of residential air conditioning in the 1920s helped enable the great migration to the Sun Belt in the United States.[citation needed]
In order to get the most out of your equipment, we highly recommend proper preventative HVAC maintenance. You’ll want to make sure from the outset that you have access to skilled and knowledgeable technicians who have been factory-trained to service your particular model, since different systems require different highly specific modifications. It’s advisable to find a reputable HVAC dealer in the Atlanta area that guarantees their work and offers annual service contracts to their customers to ensure necessary seasonal maintenance is always being performed regularly. Many times, timely adjustments and filter changes that are done on a regular basis can wind up saving you from breakdowns that always seem to occur right when you need your system the most.
At Van Haaften Plumbing & Heating, heating and cooling isn’t just our job, it’s our passion. We’re dedicated to providing you with the top HVAC service in Pella. No matter the size of the problem or time of day, you can rely on us to get the job done properly. After all, Van Haaften Plumbing & Heating has been serving the community since 1949, bringing comfort to our customers in every season.
Our technicians have experience repairing furnaces and will make sure your home is back to keeping you comfortable in no time. From training and certifications to our reputation for getting the job done right time and time again, you can be sure that Van Haaften Plumbing & Heating’s furnace repair technicians will have your troubles taken care of and your furnace running smoothly. Whether it’s emergency furnace repair or service you can schedule some time in advance, our team can provide you peace of mind, knowing that your furnace is in skilled hands. Need a furnace repair? When performing a repair, it's vital to source professional HVAC contractors.
They were quick to come out and diagnose the problem with my furnace, but I thought the estimate of $549 a bit high to replace the circuit board.  So called around and found Leo's Appliance in Concord that sells appliance parts and the circuit board was only $90.49 - that is the retail cost to me, so I imagine the wholesale cost is a lot less.  So BEWARE of this company since they wanted $500!!! to replace the circuit board which is located right in the front of the furnace - extremely easy to access.  I hate it that you cannot trust repair companies.
Refrigeration air conditioning equipment usually reduces the absolute humidity of the air processed by the system. The relatively cold (below the dewpoint) evaporator coil condenses water vapor from the processed air, much like an ice-cold drink will condense water on the outside of a glass. Therefore, water vapor is removed from the cooled air and the relative humidity in the room is lowered. The water is usually sent to a drain or may simply drip onto the ground outdoors. The heat is rejected by the condenser which is located outside of room to be cooled.
If you happen to live in a hot and humid area of the country, drainage problems can occur with your unit since moisture can trap itself inside the system. Routine maintenance can cut down on drainage issues by cleaning out any mold or algae from blocking the drain. If you notice moldy smells whenever you turn the thermostat down, check on your system.
If you have an older central air conditioner, you might choose to replace the outdoor compressor with a modern, high-efficiency unit. If you do so, consult a local heating and cooling contractor to assure that the new compressor is properly matched to the indoor unit. However, considering recent changes in refrigerants and air conditioning designs, it might be wiser to replace the entire system.

Was not satisifed with this company.  This person came out and took 10 minutes only to tell me that my unit would not last for a year and that I needed to have it replaced!  I'm not sure if he was very knowlegable or if he was just plain lazy and do not even try to fix the problem.  He just wanted to install a brand new system because he was both and of course, that's much more money for him!
I was able to get a next day appointment with them last week after multiple other providers did not have availability. The tech was on time and did a good job to diagnose and eventually replace the circuit board and get it up running again. The service itself would be 5 stars, although it did take a week to complete the job due to ordering the part.
HVAC equipment is estimated to last about 15 to 20 years. Yet over the years, parts go out and need to be repaired. Heat sensors, exchangers, and ducts can become worn out. Air conditioning motors may need repairing from time to time. For repairs to your heating and air conditioning systems, and even general maintenance, let HomeAdvisor help. Enter your zip code and let us connect you with prescreened HVAC repair services near you.
I needed a replacement for my heater. I called Bill Howe and they promptly fitted me into their schedule. The person who arrived, Laurence C. thoroughly tested my furnace and pointed out the problem. I decided to replace it. They arrived on the day to install it. The two men, Jose Gomez and Javier Diaz promptly went to work. They were clean, efficient and respectful of my home. I would gladly recommend Bill Howe for your heating and plumbing needs. They were great!!​
Living in Chicago's Western Suburbs, you need a quality, reliable air conditioning system. With professional installations and top-of-the-line systems from Bryant, you’ll get a system you can count on for years to come. If you need repairs or maintenance for your existing A/C system, our technicians are ready to serve you. Our team is highly trained and qualified in the most advanced technologies and systems, ensuring you get the most out of your cooling system. Give us a call today to learn more!
When it comes to your heating system, you need a dedicated, knowledgeable technician on the job for service. Our technicians are trained and qualified to provide efficient heating repairs, maintenance, and installations. We focus on dependable Bryant systems to ensure you enjoy complete comfort in your home. Living in Willowbrook, IL, you need Apex Energy, Inc. on the job all winter long!
We moved into a new home and had issues with the heating ducts in one of the rooms. We called HVAC based on other yelp reviews. Overall, everyone we dealt with were friendly, professional and knowledgeable: From the people on the phone managing the schedule to the those performing the work in our house. The day before the scheduled work we asked if additional work could be done (clothes dryer duct cleaning), which they were able to accommodate. The people working at the house were on time, very polite, took great care to keep the house clean during the entire job and explained everything when they were finished. I will certainly use HVAC again.
If you believe that the ac not working or you’re getting little or no cold air, check these three things first. Make sure all the registers in the house are wide open. Then be sure the furnace filter is clean. Then go outside and clean off the condenser coils (Photo 2). If several registers were closed or the filter was clogged, the reduced airflow could have caused the evaporator coil to ice up and stop cooling your home. If you’ve changed the filter and opened all the registers and you’re still not getting airflow at the registers, deice the A-coil. Move the thermostat mode switch from “Cooling” to “Off” and move the fan switch from “Auto” to “On.” Let the blower run for at least 30 minutes or until there’s good airflow at the registers. Then turn the AC back on to test it. If it works for the next 12 hours, you’ve solved the problem.
×