Denver HVAC Repair

HVAC professionals attend to a home's thermal needs as well as air quality. Because of the technical aspects of HVAC work, find out the scope of work your professional can perform. You may only need your heating unit serviced however, if this professional also specializes in energy efficiency, mold assessment, or offer ways for you to save on energy costs, you may want to hire them for future projects. Because some equipment is gas-powered, your professional should be able to answer questions about installing gas lines and permitting.
Evaporative coolers, sometimes called "swamp coolers", do not have a compressor or condenser. Liquid water is evaporated on the cooling fins, releasing the vapor into the cooled area. Evaporating water absorbs a significant amount of heat, the latent heat of vaporisation, cooling the air. Humans and animals use the same mechanism to cool themselves by sweating.
Yes. You should expect to pay a diagnostic fee to cover the cost of the technician's visit, the diagnosis of your air conditioner's problem, and a quote for the repair options. You will be advised of the issue along with recommended options to correct it, which may include a system replacement if your unit is old or significantly damaged. If you decide to replace the system, the diagnostic fee will be credited toward your replacement purchase.
Modern refrigerants have been developed to be more environmentally safe than many of the early chlorofluorocarbon-based refrigerants used in the early- and mid-twentieth century. These include HCFCs (R-22, as used in most U.S. homes before 2011) and HFCs (R-134a, used in most cars) have replaced most CFC use. HCFCs, in turn, are supposed to have been in the process of being phased out under the Montreal Protocol and replaced by HFCs such as R-410A, which lack chlorine.[14] HFCs, however, contribute to climate change problems. Moreover, policy and political influence by corporate executives resisted change.[15][16] Corporations insisted that no alternatives to HFCs existed. The environmental organization Greenpeace provided funding to a former East German refrigerator company to research an alternative ozone- and climate-safe refrigerant in 1992. The company developed a hydrocarbon mix of isopentane and isobutane, but as a condition of the contract with Greenpeace could not patent the technology, which led to its widespread adoption by other firms.[17][18][19] Their activist marketing first in Germany led to companies like Whirlpool, Bosch, and later LG and others to incorporate the technology throughout Europe, then Asia, although the corporate executives resisted in Latin America, so that it arrived in Argentina produced by a domestic firm in 2003, and then finally with giant Bosch's production in Brazil by 2004.[20][21]

We’re located in Lexington and service the surrounding area, so stop on by if you’re looking for a new furnace or want to set up an appointment to have one of our techs do a consultation at your home and help you figure out which system is ideal for your home. Schedule furnace repair or a furnace service appointment with James Heating & A/C, Inc using our online scheduler, or if you need help more quickly, give us a buzz at 336-853-6070. 


Regardless of how far along you are in your air conditioning project, you should start looking for a contractor now. The demand for Portland air conditioning has begun to outstrip the supply of contractors, and homeowners are telling us they've had to fight/wait to schedule an installation date. This may also determine the availability of your preferred contractor, as the best contractors' schedules tend to fill more quickly than the rest. Once you've submitted your online request, you can trust that our contractors are the most reliable professionals in the business. Each and every one our contractors has been put through a rigorous ten-step screening process. Our online customer ratings and reviews section will allow you to see what other homeowners have said, not just about individual contractors, but Portland air conditioning installation in general.
Ground source, or geothermal, heat pumps are similar to ordinary heat pumps, but instead of transferring heat to or from outside air, they rely on the stable, even temperature of the earth to provide heating and air conditioning. Many regions experience seasonal temperature extremes, which would require large-capacity heating and cooling equipment to heat or cool buildings. For example, a conventional heat pump system used to heat a building in Montana's −70 °F (−57 °C) low temperature or cool a building in the highest temperature ever recorded in the US—134 °F (57 °C) in Death Valley, California, in 1913 would require a large amount of energy due to the extreme difference between inside and outside air temperatures. A few feet below the earth's surface, however, the ground remains at a relatively constant temperature. Utilizing this large source of relatively moderate temperature earth, a heating or cooling system's capacity can often be significantly reduced. Although ground temperatures vary according to latitude, at 6 feet (1.8 m) underground, temperatures generally only range from 45 to 75 °F (7 to 24 °C).
"Friendly, professional, responded quickly to my problem. I have called many air conditioning companies about my problem including the maker of the unit and had come to the conclusion that I would not find someone to repair this unit. D's came in and within a short test found the problem and assured me of a fix. They made the fix within 2 days as they needed to get a part and they also checked to see what the cost would be of the fix by putting in the control boarrd from the maker which was very high to the extreme. I now have a unit working and am very pleased."

Heaters exist for various types of fuel, including solid fuels, liquids, and gases. Another type of heat source is electricity, normally heating ribbons composed of high resistance wire (see Nichrome). This principle is also used for baseboard heaters and portable heaters. Electrical heaters are often used as backup or supplemental heat for heat pump systems.
"HVAC Service" has found success throughout the years by evaluating overall system performance, ease of installation, reliability and long term energy consumption costs, and how these variables relate to an owner's needs.  Through innovative engineering, comprehensive design solutions, consistent work quality, and qualified maintenance; "HVAC Service" confidently delivers the best possible solutions for your business.

Outside of your home is an outdoor unit, which is called a condenser. Inside the condenser is a compressor, a condenser coil, and a large fan. The compressor pumps cool refrigerant to an evaporator coil located either in the air handler or just outside the furnace. The evaporator coil gets really cold so that when the blower or furnace pushes warm air past it, the air is cooled. This cool air is then distributed throughout your home through a series of air ducts. Heat is absorbed by the evaporator coil, which warms the refrigerant moving through the coils. This warm refrigerant is then pumped back outside to the condenser coil, where a giant fan cools it off allowing the warm air to escape. This cycle is repeated until your thermostat detects that your home has reached the temperature you set it to.
In a thermodynamically closed system, any power dissipated into the system that is being maintained at a set temperature (which is a standard mode of operation for modern air conditioners) requires that the rate of energy removal by the air conditioner increase. This increase has the effect that, for each unit of energy input into the system (say to power a light bulb in the closed system), the air conditioner removes that energy.[30] To do so, the air conditioner must increase its power consumption by the inverse of its "efficiency" (coefficient of performance) times the amount of power dissipated into the system. As an example, assume that inside the closed system a 100 W heating element is activated, and the air conditioner has a coefficient of performance of 200%. The air conditioner's power consumption will increase by 50 W to compensate for this, thus making the 100 W heating element cost a total of 150 W of power.
Poor dehumidification can also be caused by excessive humidity in the home. This may be caused by water leaks or open windows during humid periods or by a lack of proper condensate drainage from your evaporator coil in the furnace's plenum. A properly functioning cooling unit produces condensate and drains it away. If your unit is not producing condensate its cooling and dehumidification functions are not working properly.

Our A/C was blowing hot air intermittently...it was cold one minute and warm the next. By 8pm I'd have a 90 degree interior temp. After one company just took a cursory glance at our A/C and found nothing wrong, I called HVAC. I called them mostly based on Michael W's post on 8/10/14 where he told us the owner, Alberto, took his feedback and took it SERIOUSLY. That speaks VOLUMES to anyone who has been around long enough to know the characteristics of the serious players are and those who are the wannabes. So HVAC sent Tony Diaz to my house. I was at work so he was subjected to the most excruciatingly exacting woman on the planet (my wife). Tony impressed her with his friendliness, professionalism and the obvious jouneyman-level knowledge of his craft. He found literally --burnt-out-- parts in our system and replaced them. It cost us a bit but I know enough about the parts to see there was no gouging on the parts and a fair rate for the labor. It wasn't cheap but it was fair and worth every dime. And now i have A/C in my house again and a repairman came to my house, actually FIXED something AND managed to do so in a friendly & professional manner. That used to be commonplace...nowadays it deserves a "Wow".. Thank you, Tony!

“Air conditioners contain refrigerant, which allows the system to run efficiently, releasing heat from the air to cool it. Air conditioners are charged with refrigerant upon installation; a poor charge or a refrigerant leak can cause the system’s refrigerant level to fall below the proper amount. To remedy this, the home AC repair which is performed is a refrigerant recharge, accompanied by fixing the leak if that was the source causing low refrigerant levels.
For over 65 years, Jacobs Heating & Air Conditioning has been a Portland HVAC leader. Providing comprehensive heating, cooling and ventilation services to the Portland, OR and Vancouver, WA areas, our clients consistently praise our timely and professional work. From air conditioning repair to cooling and safety system installs, trust the professionals at Jacobs Heating & Air Conditioning.

Good Evening HVAC Team, I deeply appreciate your team for getting back to me quickly yesterday evening so I could schedule an appointment for my gf's place(definitely something has been wrong for a while)-- The technician Alberto showed up within the 2 hour window that was appointed to us (WITHIN the 1st half hour!!!). BIG THANK YOU for being honest, and advising us that for some reason the fuse/switch was in the reverse position so the AC unit would not properly turn on. The unit turned back on immediately, and began cooling the house. And then providing advice that the AC/Heating system needed some TLC, and giving us options to save money by purchasing a maintenance plan that included the filters plus cleaning services since we were already being charged for the service today. My personal thanks for being extremely professional, and personable as you entered our home. Solving the technical issue is only part of the job, but providing great Customer Service, and Cost Effective solutions are reasons to recommend you to the people who are looking for the same type of service. Also, it was very convenient that you were able to take my payment over the Phone(FaceTime) since I was not present at the time. Your company website is well organized, and I had no problem reviewing your capabilities as well as how to contact your team. Most important, Tina spoke very highly of you, and made her feel comfortable through the process. SO BOTTOM LINE to other customers looking for HVAC service: LOOK NO FURTHER!!! If you have a AC/Heater Issue, give this the HVAC company a call, or email-- You won't be disappointed. Kind Regards, Michael
AC units and thermostats have built-in delay features when they’re shut down and then repowered. The delay can be as long as 10 minutes. And, if you’ve subscribed to an energy-saving device from your local power utility, the unit can take even longer to reset. If you’ve installed the parts shown and reinstalled the disconnect block, repowered the circuit breaker, turned on the switch at the furnace, moved the thermostat to AC mode and lowered the temperature below the indoor temperature, and the unit doesn’t fire up after 30 minutes, it’s time to call a pro.
×