Denver HVAC Repair

No one wants to be stuck in the dead of summer with a broken air conditioner, or in the cold of winter with a broken furnace or boiler. That’s why we’re available any time of day to make your emergency heating and air conditioning repair and get your system up and running as quickly as possible. We’ll show up on time, in uniform and ready to make your HVAC repair right the first time.
The main problem when installing a multi-split system is the laying of long refrigerant lines for connecting the external unit to the internal ones. While installing a separate split system, workers try to locate both units opposite to each other, where the length of the line is minimal. Installing a multi-split system creates more difficulties, since some of indoor units can be located far from the outside. The first models of multi-split systems had one common control system that did not allow you to set the air conditioning individually for each room. However, now the market has a wide selection of multi-split systems, in which the functional characteristics of indoor units operate separately from each other.

I have no idea what a barrel is??? In chilled water systems the evaporator and condensers sometimes use what is called a chiller barrel for the evaporator and/or the condenser but for most residential system it is a rarity to find a chilled water system installed. Are you talking about a commercial system chiller. 7.1 KW is not a very big system but they do exist in light commercial and as mentioned in residential.
The heat-exchanger cools the air that is being forced through it by the furnace blower. As the warm air comes in contact with this cool surface the water in the air condenses. By pulling the water molecules from the air. According to the psychometric chart[42] as relative humidity decreases in order to feel cool you will have to lower the temperature even more. A common way to counteract this effect is by installing a whole-home humidifier.[43] Similarly, installing a high efficient system this need to turn the temperature down wont have such and influence on your energy costs.
What type of insurance do you have? Heating, ventilation and air conditioning (HVAC) professionals work on a variety of mechanical areas of the home. You'll want to ask specific questions regarding professional training and licensing, as well as what types of insurance they have (for example, mold, air pollution or worker's compensation). It's fair to ask for the dollar amounts they are covered and a quality professional will show you verification of coverage.
Just like running a marathon, we perform better at full strength. If we’re not feeling great, it’s that much harder to finish the race. Similarly, when you set your thermostat to a certain temperature, the system is tasked with maintaining that temperature throughout the room. Working at full strength, the system can easily maintain that temperature (as long as it’s not below 60 degrees or above 80 degrees). However, when injured, the system may struggle to keep the room at your desired temperature. As such, it’s working harder, which means higher utility bills.
One problem occurred on Monday.  When we called at 2:30 in the afternoon to check on status, we were told that "the tech is on the phone with the parts supplier now".  It seems more likely that they had forgotten about us and our call woke them up.  But even if true, why the heck did they wait until 2:30 to order the part?  Maybe if they had ordered it in the morning they could have had it the same day.  So I'm taking off one star for that.
   As for parts prices, we are a business and factor in profit and overhead into our pricing structure, and frequently research other companies to be sure we are competitive, which we are. Jody, you did not pay $400 for labor, you paid $489 for a flat rate repair which included, travel, labor, diagnostics, parts, tax, shipping, truck charge, fuel charge, overtime rate, profit and overhead. As for the time of the actual repair, if it had taken 2 or 3 hours the cost would have still been the same $489.        

Consequently, this water must exit the air handler—typically through plastic pipe or a drain tube. That drain tube goes directly outside, often terminating near the compressor, or to a floor drain or to a small electric “condensate pump” located by the air handler. Where a condensate pump is used, it connects to a 1/2-inch vinyl or rubber tube that exits outdoors or to a drain.

The main problem when installing a multi-split system is the laying of long refrigerant lines for connecting the external unit to the internal ones. While installing a separate split system, workers try to locate both units opposite to each other, where the length of the line is minimal. Installing a multi-split system creates more difficulties, since some of indoor units can be located far from the outside. The first models of multi-split systems had one common control system that did not allow you to set the air conditioning individually for each room. However, now the market has a wide selection of multi-split systems, in which the functional characteristics of indoor units operate separately from each other.
Camera, Video & SurveillanceAction Cameras & Drones,Camcorders,Dash...3504 Car Electronics & GPSCar Audio,Car Mounts & Accessories,Car S...1802 Cell Phones & AccessoriesBackup Batteries,Bluetooth Devices,Cable...12628 Computers & TabletsComputer Accessories,Desktops, Monitors...5511 Musical InstrumentsAccessories,Amplifiers & Effects,Brass &...1909 Office Electronics & SuppliesNetworking,Printers & Scanners,Scanners...2201 Portable AudioBluetooth & Wireless Speakers,Docks, Rad...3233 Smart HomeCameras & Surveillance,Door Locks,Garage...104
Commercial HVAC equipment is complex, and necessary for running a commercial building. When you call Apex Energy, Inc. for commercial heating and cooling repairs, maintenance, and installations, you won’t be disappointed. We’re proud to serve residents of Willowbrook, IL. We employ knowledgeable, dependable, and qualified HVAC technicians, so you can feel confident in our services. Call today to learn more or to schedule your next appointment!

Your system is 10 - 15 years old: Follow this simple rule of thumb from Energy Star—if your current system is over 10 years old, it's time to start looking into an HVAC replacement. Most HVAC systems last for about 15 years, so there’s no immediate need to replace yours if it’s still functioning properly. But by doing your research now, you’ll know just what you want to do should your HVAC system suddenly stop working properly.
If so, you may want to consider replacing your entire AC system. After your AC system reaches a certain age, it makes more sense to invest in a new AC system altogether rather than repairing it one piece at a time. To learn more about John Moore’s AC replacement program, our warranty, and the cost-advantages of replacing your AC system, visit our AC Replacement page.
The air conditioner's evaporator coil and condenser coil collect dirt over their months and years of service. A clean filter prevents the evaporator coil from soiling quickly. In time, however, the evaporator coil will still collect dirt. This dirt reduces airflow and insulates the coil, reducing its ability to absorb heat. To avoid this problem, check your evaporator coil every year and clean it as necessary.
Replacing a capacitor is easy. Just take a photo of the wires before disconnecting anything (you may need a reference later on). Then discharge the stored energy in the old capacitor (Photo 4). Use needle-nose pliers to pluck one wire at a time from the old capacitor and snap it onto the corresponding tab of the new capacitor. The female crimp connectors should snap tightly onto the capacitor tabs. Wiggle each connector to see if it’s tight. If it’s not, remove the connector and bend the rounded edges of it so it makes a tighter fit on the tab. When you’ve swapped all the wires, secure the new capacitor (Photo 5).
×