Denver HVAC Repair

Brennan’s Heating & Air Conditioning is a Carrier Factory Authorized Dealer (FAD), and we got that way by demonstrating our knowledge and expertise in performing heating repairs and AC installation. We maintain this designation by offering superior service and by meeting stringent training requirements. That means we’re qualified to perform air conditioner repairs, warranty work, and these comprehensive services:

The HVAC industry is a worldwide enterprise, with roles including operation and maintenance, system design and construction, equipment manufacturing and sales, and in education and research. The HVAC industry was historically regulated by the manufacturers of HVAC equipment, but regulating and standards organizations such as HARDI, ASHRAE, SMACNA, ACCA, Uniform Mechanical Code, International Mechanical Code, and AMCA have been established to support the industry and encourage high standards and achievement.
Some systems include an "economizer mode", which is sometimes called a "free-cooling mode". When economizing, the control system will open (fully or partially) the outside air damper and close (fully or partially) the return air damper. This will cause fresh, outside air to be supplied to the system. When the outside air is cooler than the demanded cool air, this will allow the demand to be met without using the mechanical supply of cooling (typically chilled water or a direct expansion "DX" unit), thus saving energy. The control system can compare the temperature of the outside air vs. return air, or it can compare the enthalpy of the air, as is frequently done in climates where humidity is more of an issue. In both cases, the outside air must be less energetic than the return air for the system to enter the economizer mode.
ABM is an EOE (Minority / Female / Veteran / Disability / Gender Identity / Sexual Orientation) and is committed to working with and providing reasonable accommodation to individuals with disabilities. If you have a disability and need assistance in completing the employment application, please call 855-350-0226. We will provide you with assistance and make a determination on your request for reasonable accommodation on a case-by-case basis.

I could not have been more pleased with the responsiveness, considerate employees, workmanship, and follow up. We used three divisions of Bill Howe when we had a flood due to a water heater/T&P gauge, Plumbing, Remediation and Reconstruction. It was timely, reasonably priced and finished with attention to detail. Ashley in the office was always polite and responsive and we could not have been happier under the circumstances.


The summers here in Alexandria can range from almost pleasant to downright brutal. And you know as well as we do that it’s those latter days when your central AC or heat pump will decide to go down! But you needn’t seek solace at the Waterfront or over at Cameron Run Regional Park. The secret to restoring your comfort lies with the certified specialists at HVAC Unlimited!
After one company just took a cursory glance at our A/C and found nothing wrong, I called HVAC. I called them mostly based on Michael W's post on 8/10/14 where he told us the owner, Alberto, took his feedback and took it SERIOUSLY. That speaks VOLUMES to anyone who has been around long enough to know the characteristics of the serious players are and those who are the wannabes.
Air flow meter Aquastat BACnet Blower door Building automation Carbon dioxide sensor Clean Air Delivery Rate (CADR) Gas sensor Home energy monitor Humidistat HVAC control system Intelligent buildings LonWorks Minimum efficiency reporting value (MERV) OpenTherm Programmable communicating thermostat Programmable thermostat Psychrometrics Room temperature Smart thermostat Thermostat Thermostatic radiator valve
Other InformationCost to install a bathroom medicine cabinetCost to install a basement windowCost to install a bifold doorCost to install a door frameCost to install a bay windowCost to hang a prehung doorCost to install a door knobCost to install a door jambCost to install a bathtubCost to install a faucetCost to install a bidetCost to hang wallpaper
A.J. LeBlanc Heating specializes in the installation and service of heating, air conditioning and plumbing systems for residential homes. Whether you are building a new home, converting your existing heating system to a different fuel, upgrading your old unit to a more efficient system, or just adding air conditioning, LeBlanc Heating can service your needs.
You should also have air ducts cleaned after recent water contamination or water damage to prevent mold; after renovations or remodeling to ensure debris and dust didn’t settle in the vents and ducts; if you are having problems with allergies or asthma; or when you are moving into a newly purchased home, especially if the previous owners smoked or had pets. The National Air Duct Cleaners Association (NADCA) recommends getting your air ducts cleaned every three to five years, or every two to three years in regions where homeowners use their air conditioning and heater for many months of the year, while the EPA suggests homeowners have duct cleaning done as needed.
If your air ducts have been damaged, you’ll need to replace them. The national average air duct replacement cost is $150-$280, which may not include materials. Factors such as duct material, labor, location of ducts and linear feet of ductwork will all affect your final costs. Labor costs will vary based on how accessible the ducts are and what material your ducts are made of. The least expensive duct material is a flexible, non-metallic ducting that costs approximately $1-$2 per linear foot. Flexible aluminum is generally more expensive and stronger than non-metallic ducting. Stainless steel ducting is the strongest, the least flexible (meaning installing it typically has higher labor rates), and usually the most expensive. An average price for air duct replacement could range between $35 and $55 per linear foot, including basic materials and labor. A typical single-family home has 6-10 duct runs; replacing or installing one duct run could average $150-$250 for labor.
The Chartered Institution of Building Services Engineers is a body that covers the essential Service (systems architecture) that allow buildings to operate. It includes the electrotechnical, heating, ventilating, air conditioning, refrigeration and plumbing industries. To train as a building services engineer, the academic requirements are GCSEs (A-C) / Standard Grades (1-3) in Maths and Science, which are important in measurements, planning and theory. Employers will often want a degree in a branch of engineering, such as building environment engineering, electrical engineering or mechanical engineering. To become a full member of CIBSE, and so also to be registered by the Engineering Council UK as a chartered engineer, engineers must also attain an Honours Degree and a master's degree in a relevant engineering subject.
Combined, our people can offer decades worth of HVAC service and installation experience in Tucker, which we bring to every single job we do. Our staff believes wholeheartedly that reliability, passion, and expertise are critical to providing our customers with good service, and we can do that for both residential and commercial clients. For commercial buildings, in which safety and maintenance are key values, we are the best provider for your needs. From weekly safety meetings to provided protective equipment and mandatory site risk assessments, our technicians can install, repair, and maintain all commercial HVAC products under the purview of the very highest safety standards. In addition, we can give you a one-year, 100% Satisfaction Guarantee* on commercial service. Most companies only guarantee their work for the first few months, but we believe that we can, and will, do an exemplary job for all our customers in Tucker.
The belt should slip right into place. If it seems to be too tight or difficult to set in place, it may be necessary to adjust the motor mount to provide more slack. Then you can re-tighten the tension once the belt is in place. Check the manufacturer’s specifications for proper tension—in most cases, the belt should deflect about an inch when you press down on it.
New heating and cooling equipment installations present a wide variety of options that can save you money on your power bills and reduce the amount of HVAC maintenance and service that will ultimately be required over the life of your new unit. Energy-efficient options like heat pumps, two-stage furnaces, air-to-heat exchangers (HRVs), and programmable thermostats can all go a long way toward increasing efficiency and extending the life expectancy of your system.
The federal government is phasing out Freon to conserve energy across the nation. Because of this, Freon costs are increasing significantly. If your AC unit uses Freon, eventually you’ll need to replace it to make the switch to the new R410A refrigerant. It’s most likely a good time to consider a replacement if your unit is breaking down or has problems associated with needing more Freon.

Because an air conditioner moves heat between the indoor coil and the outdoor coil, both must be kept clean. This means that, in addition to replacing the air filter at the evaporator coil, it is also necessary to regularly clean the condenser coil. Failure to keep the condenser clean will eventually result in harm to the compressor, because the condenser coil is responsible for discharging both the indoor heat (as picked up by the evaporator) and the heat generated by the electric motor driving the compressor.


Outside of your home is an outdoor unit, which is called a condenser. Inside the condenser is a compressor, a condenser coil, and a large fan. The compressor pumps cool refrigerant to an evaporator coil located either in the air handler or just outside the furnace. The evaporator coil gets really cold so that when the blower or furnace pushes warm air past it, the air is cooled. This cool air is then distributed throughout your home through a series of air ducts. Heat is absorbed by the evaporator coil, which warms the refrigerant moving through the coils. This warm refrigerant is then pumped back outside to the condenser coil, where a giant fan cools it off allowing the warm air to escape. This cycle is repeated until your thermostat detects that your home has reached the temperature you set it to.
The Refrigeration Loop is a closed system and refrigerant should never have to be added to the unit unless there is a leak. Most residential units use R-22/R410A refrigerant. Prices of R-22/R410A are rising every year as we get closer to the date when refrigerant manufacturers will no longer be able to make R-22/R410A. Phase-out of R-22, an HCFC, begins in 2010 and expected to be complete by 2020.). Furthermore, make sure you ask what the service company charges for R-22 when you are calling an HVAC contractor.
Abacus’ HVAC (heating, ventilating, and air conditioning) technicians are experts at inspecting and repairing systems that are not cooling or heating properly. They specialize at everything from condensers, coils, air ducts, air filtration to complete AC installations and AC replacements with the best warranties in Houston. Need an annual tune up? Ask about the Abacus BAM! Plan. Annual checkups can help prevent many issues from happening to your air conditioning system. BAM! gives customers one tune-up for their heating and another for their air conditioning. This makes sure that you have what your home needs when you need it. You also get the benefits of VIP scheduling and up to 15% off of HVAC services.  

Start with your utility company; they can help a great deal. Comparing previous bills isn't always a good measure, as the weather is never exactly the same month to month. Instead, if you take your energy bill and divide it by the square footage of livable space in your home, don't count areas like unfinished garages or basements -- you can calculate how much you are spending to heat or cool each square foot of your home. Your energy provider can tell you what the average cost per square foot is in your region for that same period of time so you can compare apples to apples.

We are a local, family-owned business that has been serving the Lancaster County area since 1945. For many homeowners, we are their trusted partner for home improvements and repairs, providing certified electrical and plumbing services, home remodeling, and major home appliance sales and service. Our large team of experienced installers, plumbers, electricians, and HVAC repair technicians means you can rely on Brubaker, Inc. to respond quickly for all your home repair needs.


Many HVAC maintenance companies offer annual servicing contracts for preventative maintenance. Such contracts cost anywhere from $100-$150 per year, and cover annual visits in which standard maintenance tasks are performed. Some companies will allow you to make monthly payments for your maintenance contract, and will provide you with discounts around 15% if you hire them when you need your unit repaired.
Count on R.S. Andrews for all of your residential and commercial air conditioning repair and installation needs. Our team repairs and maintains all the major brands including Trane, Carrier, Lennox, Bryant, American Standard, Goodman and more. Our fleet a fully stocked trucks will arrive ready to go to work. Most of the parts for maintenance or repair are always on board. Our team is ready to perform at your expectations. The team is licensed and insured by the state of Georgia.
Does your home's temperature need a little adjusting? An HVAC contract is a document that establishes your agreement with the contractor you hire to fix or maintain your heating, ventilation and air conditioning systems. It's best to create a free HVAC contract before the work has even begun. We'll help you take down the details of your project so work can begin and your place will get back to a comfy temperature, fast.
If your compressor doesn’t have an overload button and you hear it humming or buzzing, poke a screwdriver or stick down through the top grille and try to spin the fan blades clockwise. If doing this gives the fan enough of a boost to get it going, the unit has a faulty capacitor that must be replaced. See How to Test and Replace an AC Run Capacitor, above.

Modern air conditioning systems are not designed to draw air into the room from the outside, they only recirculate the increasingly cool air on the inside. Because this inside air always has some amount of moisture suspended in it, the cooling portion of the process always causes ambient warm water vapor to condense on the cooling coils and to drip from them down onto a catch tray at the bottom of the unit from which it must then be routed outside, usually through a drain hole. As this moisture has no dissolved minerals in it, it will not cause mineral buildup on the coils. This will happen even if the ambient humidity level is low. If ice begins to form on the evaporative fins, it will reduce circulation efficiency and cause the development of more ice, etc. A clean and strong circulatory fan can help prevent this, as will raising the target cool temperature of the unit's thermostat to a point that the compressor is allowed to turn off occasionally. A failing thermistor may also cause this problem. Refrigerators without a defrost cycle may have this same issue. Dust can also cause the fins to begin blocking air flow with the same undesirable result: ice.
Ductwork pinging or popping. If you hear a pinging or popping sound coming from metal ductwork, this may be caused by thermal expansion or by air blowing past a loose flap of metal. Track along the duct runs, listening for the sound. If you find it, make a small dent in the sheet metal to provide a more rigid surface that’s less likely to move as it heats and cools.

When central air conditioning service fails during a heat spell, you may have to wait days for an HVAC repair technician or a ac contractor to show up, and you’ll probably pay at least several hundred for the repair. But if you’re comfortable working around electricity and are willing to spend about $50 on parts, you can probably repair your air conditioning service yourself in about two hours and save about $225 on parts markup and labor.
×