In the most general sense, air conditioning can refer to any form of technology that modifies the condition of air (heating, (de-)humidification, cooling, cleaning, ventilation, or air movement). In common usage, though, "air conditioning" refers to systems which cool air. In construction, a complete system of heating, ventilation, and air conditioning is referred to as HVAC.
The most important maintenance task that will ensure the efficiency of your air conditioner is to routinely replace or clean its filters. Clogged, dirty filters block normal airflow and reduce a system's efficiency significantly. With normal airflow obstructed, air that bypasses the filter may carry dirt directly into the evaporator coil and impair the coil's heat-absorbing capacity. Replacing a dirty, clogged filter with a clean one can lower your air conditioner's energy consumption by 5% to 15%.
If the unit isn't turning on, check on it outside to make sure the condenser is still running. It should be fully plugged in and the thermostat should be set. Lower the thermostat by a few more degrees than your typical setting. You should hear it power on after doing so. If that doesn't take care of the problem, check your fuse box. You could have a blown fuse or a tripped circuit that's causing the air conditioner to not turn on.
Your home’s HVAC system is a fine-tuned piece of machinery. Like your car, your system needs regular maintenance and tune-ups to ensure it is running reliably. Manufacturer warranties for most new systems require annual tune-ups, and for good reason: these preventative maintenance measures extend the life of your system by keeping your system running the way it is designed to run.
Air-source heat pumps are more popular in milder winter climates where the temperature is frequently in the range of 4–13 °C (40–55 °F), because heat pumps become inefficient in more extreme cold. This is because ice forms on the outdoor unit's heat exchanger coil, which blocks air flow over the coil. To compensate for this, the heat pump system must temporarily switch back into the regular air conditioning mode to switch the outdoor evaporator coil back to being the condenser coil, so that it can heat up and defrost. A heat pump system will therefore have a form of electric resistance heating in the indoor air path that is activated only in this mode in order to compensate for the temporary indoor air cooling, which would otherwise be uncomfortable in the winter.
Other than mineral deposits, the most common problem is sediment in the water supply. The float inlet valve has a tiny hole that easily clogs. The float is usually made of plastic, and if cracked will fill with water and sink. The valve will be stuck open and the reservoir will overflow. Use caution when scraping deposits off the float. If the deposits cannot be removed, replace the float or it will sink and cause an overflow.
Heat pumps and electric furnaces usually have steam humidifiers to increase output. They are line voltage powered and must be unplugged or disconnected before servicing to avoid injury. With the exception of some mist type humidifiers, all have a reservoir. Stagnant water sitting in the reservoir during the off season can be a breeding ground for bacteria. Turn the water off and clean the humidifier if possible when heating season has ended.
A career in this field may require you to meet certain licensing, training, and other requirements that can vary by vocation and state. You should check with your state, local government, and/or licensing board to find out which requirements may be applicable in your state. Click here for contact information on state licensing/regulatory boards and certain professional licensing information.
Rapid Repair Experts proudly provide plumbing, electrical & HVAC services to Raleigh, Angier, Apex, Benson, Carrboro, Cary, Chapel Hill, Clayton, Dunn, Durham, Fuquay-Varina, Garner, Holly Springs, Knightdale, Morrisville, New Hill, Pittsboro, Rolesville, Sanford, Smithfield, Wake Forest, Wendell, Youngsville, Zebulon. If you don’t see your area, please contact us to see if we can visit you!
Additionally, new technology and government requirements are pushing manufacturers to build more energy efficient HVAC equipment. January 2006 we observed the end of 10 SEER units with 13 SEER air conditioning units mandated by the government. This only makes sense; however, with the higher efficiency, there comes complexity in the technology engineered into the equipment. A problem can be difficult to troubleshoot and diagnose and may require more time than the lower efficiency, less complex units.
We have been using Bill Howe Plumbing's service for more than 25 years and have been pleasantly surprised at how consistently they perform an excellent service call. We use them for our home and our rental properties, and their dispatchers and technicians have always been the best at problem solving; our tenants have told us how great the service is as well. When we needed air conditioning service, naturally we called Bill Howe first. There's no reason to call anyone else. I know the job will be done right the first time, with fair pricing and professional service.
If you live in a warmer climate, your AC is likely one of the most essential pieces of equipment for your home. The best course is to perform regular routine air conditioner maintenance to ensure its smooth operation during the warmest months of the year. Annual tune-ups by a professional HVAC technician will increase the lifespan of your unit. When repairs are needed, be sure to hire a technician trained and certified in HVAC repair for best results. Following these guidelines will ensure that you are comfortable and cool through the summer season.
Your HVAC professional can perform a yearly tune-up of your system for around $80-$100. This yearly maintenance can go far toward heading off major repairs to your system, and provide you with peace of mind and considerable savings in the long term. Additionally, regular servicing of your AC unit can help a home inspector to certify that your unit is working properly in the event you decide to sell your home.
The heat-exchanger cools the air that is being forced through it by the furnace blower. As the warm air comes in contact with this cool surface the water in the air condenses. By pulling the water molecules from the air. According to the psychometric chart as relative humidity decreases in order to feel cool you will have to lower the temperature even more. A common way to counteract this effect is by installing a whole-home humidifier. Similarly, installing a high efficient system this need to turn the temperature down wont have such and influence on your energy costs.
We provide plumbing service to Atlanta and the surrounding communities, including: Acworth, Alpharetta, Austell, Avondale Estates, Brookhaven, Buford, Chamblee, Clarkston, Conyers, Cumming, Dacula, Decatur, Doraville, Douglasville, Duluth, Dunwoody, Fayetteville, Forest Park, Grayson, Holly Springs, Johns Creek, Kennesaw, Lawrenceville, Lilburn, Lithonia, Loganville, Marietta, Milton, Morrow, Norcross, Peach Tree City, Pine Lake, Powder Springs, Roswell, Sandy Springs, Snellville, Stone Mountain, Sugar Hill, Suwanee, and Woodstock, GA.
Looking to cut down your home heating and cooling costs? Trane TruComfort™ Variable speed systems do just that. Trane TruComfort™ runs at the speed necessary to keep your home continuously comfortable – automatically adjusting up and down within one-half degree of your setting and constantly circulating air. The result? Running at up to 21 SEER (Seasonal Energy Efficiency Ratio) – which means affordable residential heating and air for you.
Beyond changing the air filter on a regular basis, one of the best ways to ensure your home's HVAC system is operating at peak efficiency is to have a qualified professional HVAC contractor tune up the system on a biannual basis. Energy Star recommends scheduling your system tune-up around the beginning of daylight savings time in the fall and its end in the spring. It's an easy way to remember to have your system serviced before the peak heating and cooling seasons. A standard tune-up is likely to cost you between $70 and $100, but it's money well spent.
"Friendly, professional, responded quickly to my problem. I have called many air conditioning companies about my problem including the maker of the unit and had come to the conclusion that I would not find someone to repair this unit. D's came in and within a short test found the problem and assured me of a fix. They made the fix within 2 days as they needed to get a part and they also checked to see what the cost would be of the fix by putting in the control boarrd from the maker which was very high to the extreme. I now have a unit working and am very pleased."
Once a diagnosis is made to your air-conditioning and/or heating system, the unit can be repaired, in most situations, with stock HVAC parts off the truck. Sometimes the HVAC part has to be ordered because it is a specialty part that only the HVAC manufacturer of your equipment can provide. If the part can be picked up locally then you can expect to pay for travel time to and from the HVAC parts dealer. It is practically impossible to carry every single HVAC part for every single HVAC breakdown that occurs.
If the condenser coils are clogged, the compressor can overheat and shut down. You’ll experience intermittent periods of minimal cooling, followed by no cooling. Even if you’re “sure” the condenser coils are clean, clean them again. Turn off the power. Flip the air conditioning service and furnace circuit breakers in your main electrical panel to the “Off” position. Next, turn off the power switch right at the furnace or air handler. Then yank the disconnect block (Photo 1) and clean the condenser coils (Photo 2). If the air conditioning service still doesn’t work properly after you’ve cleaned the condenser coils, installed a new filter and opened all the supply vents, proceed with the following repairs.