Denver HVAC Repair

After discussing faulty AC system symptoms with you, Jiffy Lube® technicians begin the service by visually inspecting the air conditioning compressor drive belt, serpentine belt and all accessible components for cracks, leaks or damage. Then they check the operation of the air conditioning compressor. If no leaks or damage are found, they evacuate the refrigerant from the system, vacuum test it, and recharge the air conditioning system using the appropriate refrigerant according to your vehicle manufacturer's recommendations.
Dehumidification (air drying) in an air conditioning system is provided by the evaporator. Since the evaporator operates at a temperature below the dew point, moisture in the air condenses on the evaporator coil tubes. This moisture is collected at the bottom of the evaporator in a pan and removed by piping to a central drain or onto the ground outside.
Turning to a source you know and trust is a solution many can rely on. Online review sites can be full of negative or glowing experiences – you don’t know who’s telling the truth on Yelp, you don’t know who they are! Your neighbor, coworker, or family member is someone you’ve built a relationship with. You trust their opinions on many subjects – local air conditioner repair is no different.”
We’ve found that many homes and businesses in Atlanta face significant indoor air quality issues as a result of the seasonal high humidity in our area, which creates conditions ripe for mold and mildew growth in both old and new HVAC systems. Our HVAC technicians can help you determine which strategies will work best for neutralizing airborne particulates in your home, which often involves a combination of filtration methods and ultraviolet light technology that together can help keep your system perpetually free of contaminants. We can also install whole-house dehumidifiers and humidifiers, which can make a huge difference in the amount of work your HVAC unit will have to do to be effective.
The condensed, pressurized, and still usually somewhat hot liquid refrigerant is next routed through an expansion valve (often nothing more than a pinhole in the system's copper tubing) where it undergoes an abrupt reduction in pressure. That pressure reduction results in flash evaporation of a part of the liquid refrigerant, greatly lowering its temperature. The cold refrigerant is then routed through the evaporator. A fan blows the interior warm air (which is to be cooled) across the evaporator, causing the liquid part of the cold refrigerant mixture to evaporate as well, further lowering the temperature. The warm air is therefore cooled and is pumped by an exhaust fan/ blower into the room. To complete the refrigeration cycle, the refrigerant vapor is routed back into the compressor. In order for the process to have any efficiency, the cooling/evaporative portion of the system must be separated by some kind of physical barrier from the heating/condensing portion, and each portion must have its own fan to circulate its own "kind" of air (either the hot air or the cool air).
Air conditioning and refrigeration are provided through the removal of heat. Heat can be removed through radiation, convection, or conduction. Refrigeration conduction media such as water, air, ice, and chemicals are referred to as refrigerants. A refrigerant is employed either in a heat pump system in which a compressor is used to drive thermodynamic refrigeration cycle, or in a free cooling system which uses pumps to circulate a cool refrigerant (typically water or a glycol mix).
When you schedule air conditioning and heating maintenance with The Home Depot, one of our local, licensed, and insured service providers will come to your house and perform a 28-point inspection on your units. Scheduling two seasonal heating and cooling services per year with The Home Depot is a worthwhile investment that can help identify and fix small issues before they lead to bigger, more expensive repairs.
Additionally, new technology and government requirements are pushing manufacturers to build more energy efficient HVAC equipment. January 2006 we observed the end of 10 SEER units with 13 SEER air conditioning units mandated by the government. This only makes sense; however, with the higher efficiency, there comes complexity in the technology engineered into the equipment. A problem can be difficult to troubleshoot and diagnose and may require more time than the lower efficiency, less complex units.
We service and install forced air systems from all manufacturers, including Trane, Burnham, Heil, Rheem, and many more. If your home needs a new system, we will recommend the best system for your needs and budget. If you have a brand preference, we can recommend and provide qualified installation of a system from that company that fits your home’s needs.
Our team’s knowledge covers a variety of manufacturers, types of systems, local building codes, and best practices. Each technician goes through 200-plus hours of continuing education and training every year, including weekly training sessions. Whether your HVAC system is complex or small, old or brand new, or located in your basement or garage, our repair technicians can handle it.

I awoke to a smoky smell from my heater and called HVAC service Heating & Air . I called HVAC and I was given an appointment that afternoon. Their technician arrived promptly and was totally knowledgeable and courteous. He had the new motor and starter on his truck and after a total replacement I now have my morning heat back!! I would use them over n over and they were very competitive in their pricing.

We’re located in Pella and service the surrounding area, so feel free to swing by if you’re looking for a new furnace or want to set up an appointment to have one of our techs do a consultation at your home and help you learn which system is ideal for your home. Schedule furnace repair or a furnace service appointment with Van Haaften Plumbing & Heating using our online scheduler, or if you want help more urgently, give us a call at 641-628-3621. 


Shortly thereafter, the first private home to have air conditioning was built in Minneapolis in 1914, owned by Charles Gates.[11] Realizing that air conditioning would one day be a standard feature of private homes, particularly in regions with warmer climate, David St. Pierre DuBose (1898-1994) designed a network of ductwork and vents for his home Meadowmont, all disguised behind intricate and attractive Georgian-style open moldings.[when?] This building is believed to be one of the first private homes in the United States equipped for central air conditioning.[12]

An air conditioner’s cooling process produces condensation, which normally flows away from the equipment, causing no problem. If there is a clog in the condensate drain lines or drip pan, or if outdoor humidity levels are high, moisture may back up into your air conditioner. Excess condensation will increase indoor humidity levels and hinder the air conditioner’s performance. It could also cause damage to your air conditioner’s components.
So, whether you need a furnace repair or you’re searching for a new heating and cooling system—or you need a plumbing repair as soon as possible–you can count on our specialists in Longmont. We’re experts in heating system and plumbing repair and providing top-notch heating and plumbing service is what we do best. Call Service Experts 24/7/365 at 303-647-5749 or request an appointment online today, and don’t forget to look at our coupons page for savings on your heating system or plumbing repair service.
The performance of vapor compression refrigeration cycles[23] is limited by thermodynamics. These air conditioning and heat pump devices move heat rather than convert it from one form to another, so thermal efficiencies do not appropriately describe the performance of these devices. The Coefficient-of-Performance (COP) measures performance, but this dimensionless measure has not been adopted. Instead, the Energy Efficiency Ratio (EER) has traditionally been used to characterize the performance of many HVAC systems. EER is the Energy Efficiency Ratio based on a 35 °C (95 °F) outdoor temperature. To more accurately describe the performance of air conditioning equipment over a typical cooling season a modified version of the EER, the Seasonal Energy Efficiency Ratio (SEER), or in Europe the ESEER, is used. SEER ratings are based on seasonal temperature averages instead of a constant 35 °C (95 °F) outdoor temperature. The current industry minimum SEER rating is 14 SEER.[24]

The use of furnaces, space heaters, and boilers as a method of indoor heating could result in incomplete combustion and the emission of carbon monoxide, nitrogen oxides, formaldehyde, volatile organic compounds, and other combustion byproducts. Incomplete combustion occurs when there is insufficient oxygen; the inputs are fuels containing various contaminants and the outputs are harmful byproducts, most dangerously carbon monoxide, which is a tasteless and odorless gas with serious adverse health effects.[14]

Modern air conditioning systems are not designed to draw air into the room from the outside, they only recirculate the increasingly cool air on the inside. Because this inside air always has some amount of moisture suspended in it, the cooling portion of the process always causes ambient warm water vapor to condense on the cooling coils and to drip from them down onto a catch tray at the bottom of the unit from which it must then be routed outside, usually through a drain hole. As this moisture has no dissolved minerals in it, it will not cause mineral buildup on the coils. This will happen even if the ambient humidity level is low. If ice begins to form on the evaporative fins, it will reduce circulation efficiency and cause the development of more ice, etc. A clean and strong circulatory fan can help prevent this, as will raising the target cool temperature of the unit's thermostat to a point that the compressor is allowed to turn off occasionally. A failing thermistor may also cause this problem. Refrigerators without a defrost cycle may have this same issue. Dust can also cause the fins to begin blocking air flow with the same undesirable result: ice.


The employees were on time, professional, and extremely thorough while addressing a particularly difficult situation. The entire time Saul, the supervisor of the team, kept me informed, and educated me about any process that I may have not completely understood. The team was courteous to the residents they encountered, and made sure not to leave evidence that they had even been there. Great job!
Window unit air conditioners are installed in an open window. The interior air is cooled as a fan blows it over the evaporator. On the exterior the heat drawn from the interior is dissipated into the environment as a second fan blows outside air over the condenser. A large house or building may have several such units, allowing each room to be cooled separately.
Your heating, cooling, and air quality systems are a significant investment, and are expected to answer high demand, day after day, year after year.  To enjoy the greatest benefit from your equipment, let the professionals from Edwards Heating & Air handle the essential upkeep.  Through conscientious, seasonal maintenance, we effectively restore operational sound and efficiency levels, improve air quality, eliminate the majority of repairs, and extend service life.  The key to safe and uninterrupted performance, lower overall costs, and superior temperature control is through proactive measures.  The NATE-certified technicians from Edwards Heating & Air complete a lengthy task list that is specifically targeted at the optimization of your system.  Not only will your HVAC system be ready and able to handle volatile weather conditions, but it will operate safely.  Comprehensive service from Edwards Heating & Air is your best protection against health concerns, property damage, system failure, and elevated cost of ownership.  Contact Edwards Heating & Air, and we'll set up a maintenance plan that is affordable, convenient, rewarding, and works perfectly for you.
HVAC is an important part of residential structures such as single family homes, apartment buildings, hotels and senior living facilities, medium to large industrial and office buildings such as skyscrapers and hospitals, on ships and submarines, and in marine environments, where safe and healthy building conditions are regulated with respect to temperature and humidity, using fresh air from outdoors.

If you believe that the ac not working or you’re getting little or no cold air, check these three things first. Make sure all the registers in the house are wide open. Then be sure the furnace filter is clean. Then go outside and clean off the condenser coils (Photo 2). If several registers were closed or the filter was clogged, the reduced airflow could have caused the evaporator coil to ice up and stop cooling your home. If you’ve changed the filter and opened all the registers and you’re still not getting airflow at the registers, deice the A-coil. Move the thermostat mode switch from “Cooling” to “Off” and move the fan switch from “Auto” to “On.” Let the blower run for at least 30 minutes or until there’s good airflow at the registers. Then turn the AC back on to test it. If it works for the next 12 hours, you’ve solved the problem.
×