Denver HVAC Repair

In order to get the most out of your equipment, we highly recommend proper preventative HVAC maintenance. You’ll want to make sure from the outset that you have access to skilled and knowledgeable technicians who have been factory-trained to service your particular model, since different systems require different highly specific modifications. It’s advisable to find a reputable HVAC dealer in the Atlanta area that guarantees their work and offers annual service contracts to their customers to ensure necessary seasonal maintenance is always being performed regularly. Many times, timely adjustments and filter changes that are done on a regular basis can wind up saving you from breakdowns that always seem to occur right when you need your system the most.

Check your filter every month, especially during heavy use months (winter and summer). If the filter looks dirty after a month, change it. At a minimum, change the filter every 3 months. A dirty filter will slow down air flow and make the system work harder to keep you warm or cool — wasting energy. A clean filter will also prevent dust and dirt from building up in the system — leading to expensive maintenance and/or early system failure.


Your home’s HVAC system is a fine-tuned piece of machinery. Like your car, your system needs regular maintenance and tune-ups to ensure it is running reliably. Manufacturer warranties for most new systems require annual tune-ups, and for good reason: these preventative maintenance measures extend the life of your system by keeping your system running the way it is designed to run.
Dehumidification (air drying) in an air conditioning system is provided by the evaporator. Since the evaporator operates at a temperature below the dew point, moisture in the air condenses on the evaporator coil tubes. This moisture is collected at the bottom of the evaporator in a pan and removed by piping to a central drain or onto the ground outside.
If you have a good HVAC contractor they should offer an annual preventive maintenance agreement where they will perform semi-annual maintenance, once in the Spring and once in the Fall, to service your heating and cooling system. The typical maintenance agreement usually guarantees the HVAC contractor will provide service and parts at a discount rate if the listed equipment fails. Some contractors will even give you after hours service with no extra overtime charge as is the case with most other customers.
When you run into issues with the HVAC system at your home or office, you need a team of professionals by your side right away. That's exactly what A & K Service Heating & Cooling Inc. is here for. We'll take on any job in the Alpharetta and Woodstock, Georgia areas, from filter changeouts in single-family homes to complete HVAC overhauls in large commercial properties.
1/27/2015 Jim, we are committed to 100% satisfaction so every customer is very important to us.… Jim, we are committed to 100% satisfaction so every customer is very important to us.  Unfortunately, with all companies, there will be times when a customer may feel they have been let down.  If that happens with us, we certainly want to hear from you.  To better address your concerns, please contact Steve, our Customer Relations Specialist, directly by email at [email protected] or give him a call at 925-318-4795. Hopefully we will hear from you soon so that we can promptly understand your issue and address the issue! Thanks Jim Read more
“Today Tom Mendoza visited a rental house I own. Again another great visit, he represented himself & Robinson Air in an outstanding manner. Tom was very knowledgeable, professional and courteous. In all the techs I have interacted with from Robinson Air, they continue to show great pride and candor when laying out options. There is no doubt, this is a first class business who work for the customer. Call them first!!! Kudos to Tom and all the Robinson Air team. Thank you.”
Count on R.S. Andrews for all of your residential and commercial air conditioning repair and installation needs. Our team repairs and maintains all the major brands including Trane, Carrier, Lennox, Bryant, American Standard, Goodman and more. Our fleet a fully stocked trucks will arrive ready to go to work. Most of the parts for maintenance or repair are always on board. Our team is ready to perform at your expectations. The team is licensed and insured by the state of Georgia.
Air conditioning makes deep plan buildings feasible, for otherwise they would have to be built narrower or with light wells so that inner spaces received sufficient outdoor air via natural ventilation. Air conditioning also allows buildings to be taller, since wind speed increases significantly with altitude making natural ventilation impractical for very tall buildings.[citation needed] Comfort applications are quite different for various building types and may be categorized as:

I have a recurring problem of having to have freon added to my A/C system. I have even replaced both units inside and outside but seem to have the same problem. I believe that it must be in the lines between the outside and inside. Is there anything that can be put into the lines to seal any leaks if this is the problem? If not is it advised that the lines be replaced?


Turning to a source you know and trust is a solution many can rely on. Online review sites can be full of negative or glowing experiences – you don’t know who’s telling the truth on Yelp, you don’t know who they are! Your neighbor, coworker, or family member is someone you’ve built a relationship with. You trust their opinions on many subjects – local air conditioner repair is no different.”
If your AC doesn’t turn off when room temperature reaches the temperature set on the thermostat, the problem is generally occurring either at the thermostat or in the electrical system that runs the outside condensing unit. You can use the AC’s circuit breaker to shut off the unit, but that should not be a permanent solution—circuit breakers are not designed to be used like light switches.
Poor dehumidification can also be caused by excessive humidity in the home. This may be caused by water leaks or open windows during humid periods or by a lack of proper condensate drainage from your evaporator coil in the furnace's plenum. A properly functioning cooling unit produces condensate and drains it away. If your unit is not producing condensate its cooling and dehumidification functions are not working properly.

Attic Fan Installation Bathroom Fan Repair Ceiling Fan Installation Ceiling Fan Repair Electric Wall Heater Installation Electrical Panel Installation Electrical Panel Repair Electrical Panel Upgrade Electrical Wiring Installation Electrical Wiring Upgrade Exhaust Fan Installation Holiday Lighting Installation LED Interior Light Conversion Light Fixture Installation Light Fixture Repair Light Fixture Replacement Light Switch Installation Outlet Installation Outlet Repair Spa Wiring Installation

An air conditioner’s cooling process produces condensation, which normally flows away from the equipment, causing no problem. If there is a clog in the condensate drain lines or drip pan, or if outdoor humidity levels are high, moisture may back up into your air conditioner. Excess condensation will increase indoor humidity levels and hinder the air conditioner’s performance. It could also cause damage to your air conditioner’s components.


If your HVAC equipment is more than 10 years old or not keeping your house comfortable, have it evaluated by a professional HVAC contractor. If it is not performing efficiently or needs upgrading, consider replacing it with a unit that has earned the ENERGY STAR. Depending on where you live, replacing your old heating and cooling equipment with ENERGY STAR qualified equipment can cut your annual energy bill by more than $115. But before you invest in a new HVAC system, make sure that you have addressed the big air leaks in your house and the duct system. Sometimes, these are the real sources of problems rather than your HVAC equipment.

AC units and thermostats have built-in delay features when they’re shut down and then repowered. The delay can be as long as 10 minutes. And, if you’ve subscribed to an energy-saving device from your local power utility, the unit can take even longer to reset. If you’ve installed the parts shown and reinstalled the disconnect block, repowered the circuit breaker, turned on the switch at the furnace, moved the thermostat to AC mode and lowered the temperature below the indoor temperature, and the unit doesn’t fire up after 30 minutes, it’s time to call a pro.

×