Denver HVAC Repair

Heating, ventilation, and air conditioning (HVAC) are one of the most important ways to make certain that your Tucker home is a comfortable place to spend time. If you’re sitting in a hot room during summer, or shivering in your house during the winter, the experience can be strenuous, to say the least. Our job is to make sure that neither of those scenarios happen, which is why we are here for you all day and night.
Check your filter every month, especially during heavy use months (winter and summer). If the filter looks dirty after a month, change it. At a minimum, change the filter every 3 months. A dirty filter will slow down air flow and make the system work harder to keep you warm or cool — wasting energy. A clean filter will also prevent dust and dirt from building up in the system — leading to expensive maintenance and/or early system failure.
Most of the time, diagnosing problems is simple and other times it can be a complicated process where the HVAC technician calls in another HVAC technician. The technician may call in an HVAC manufacturer representative. Residential and commercial heating and cooling is important and you want the best possible HVAC air conditioning and heating service. It does not matter whether you have a Carrier Air Conditioner, Trane Air Conditioners, or need a replacement, whatever, it is best to get a qualified technician to look at your system before a decision is made to repair or replace the air conditioner or heat pump systems.

Abacus’ residential and commercial plumbers are proficient at repairing all kinds of plumbing issues, including gas and electric water heaters, slab leaks, leaky pipes to hydro jetting clogged drains. Many plumbing problems are not DIY types of jobs, call Abacus so one of our licensed plumbers can fix your problem. Our plumbers are not only knowledgeable but their customer service skills will meet or exceed your expectations.
Ductwork pinging or popping. If you hear a pinging or popping sound coming from metal ductwork, this may be caused by thermal expansion or by air blowing past a loose flap of metal. Track along the duct runs, listening for the sound. If you find it, make a small dent in the sheet metal to provide a more rigid surface that’s less likely to move as it heats and cools.
An air conditioning system, or a standalone air conditioner, provides cooling and humidity control for all or part of a building. Air conditioned buildings often have sealed windows, because open windows would work against the system intended to maintain constant indoor air conditions. Outside, fresh air is generally drawn into the system by a vent into the indoor heat exchanger section, creating positive air pressure. The percentage of return air made up of fresh air can usually be manipulated by adjusting the opening of this vent. Typical fresh air intake is about 10%.
Waited a week for technician who showed up for less than 15 minutes and told me that my air filters were dirty and I needed to experiment with thermostats to be comfortable. Thermostat shows temp at 75 when set on 71. Did what he instructed and still had problems when I realized unit was short cycling. When I called technician he told me I would have to place a new request for service. He gave me the office number and hung up on me. By the time I called office he had called in and said he refused to come back out. The operator would not give me business owners name and could not tell me why technician refused to return although they did say they would refund the fee for service call. Telephone rep yelled at me.
SEER is related to the coefficient of performance (COP) commonly used in thermodynamics and also to the Energy Efficiency Ratio (EER). The EER is the efficiency rating for the equipment at a particular pair of external and internal temperatures, while SEER is calculated over a whole range of external temperatures (i.e., the temperature distribution for the geographical location of the SEER test). SEER is unusual in that it is composed of an Imperial unit divided by an SI unit. The COP is a ratio with the same metric units of energy (joules) in both the numerator and denominator. They cancel out, leaving a dimensionless quantity. Formulas for the approximate conversion between SEER and EER or COP are available.[34]

The employees were on time, professional, and extremely thorough while addressing a particularly difficult situation. The entire time Saul, the supervisor of the team, kept me informed, and educated me about any process that I may have not completely understood. The team was courteous to the residents they encountered, and made sure not to leave evidence that they had even been there. Great job!

We offer 24-hour emergency service, with no overtime charges. Our fully stocked trucks with thousands of specialty parts and materials on board are ready to serve you and fix your heating or air conditioner problem on the first call. And when your family's health, safety, and comfort are involved, that means peace of mind. Quality service is important to our clients, and our goal is to ensure that your needs are met when heating or air conditioning issues that arise.

Next, consider the age of your unit. Remember, as we mentioned earlier, that the average life of a furnace is around 15 to 20 years. In some cases, during the installation process, your licensed and trained technician will write down the installation date right on the unit. If not, you can check inside the chamber door for a metal identification plate containing the serial and model numbers. You can then call the customer service line of the manufacturer and ask for the manufacture date of the unit.
Geothermal Heating and Cooling systems are unmatched in every way. This green alternative to temperature control is three times more efficient than conventional systems. Recognized by the US Environmental Protection Agency as the most environmentally-friendly option available today, installation of a geothermal HVAC system translates into a 50% reduction in heating costs, 30% reduction in cooling costs, and a 65% potential savings on hot water costs.  Sky Heating & Air Conditioning is now the largest WaterFurnace geothermal contractor west of Iowa. Our team of experienced professionals offer conscientious and skilled start-to-finish installation and service.  We specialize in outstanding geothermal HVAC systems, adding value and enjoyment to your home through sustainable solutions to year round temperature control. Contact Sky Heating & Air Conditioning for geothermal heat pump installation in Portland.

This information is not intended as an offer to sell, or the solicitation of an offer to buy, a franchise. It is for information purposes only. Read More Currently, the following states regulate the offer and sale of franchises: California, Hawaii, Illinois, Indiana, Maryland, Michigan, Minnesota, New York, North Dakota, Oregon, Rhode Island, South Dakota, Virginia, Washington, and Wisconsin. If you are a resident of or want to locate a franchise in one of these states, we will not offer you a franchise unless and until we have complied with applicable pre-sale registration and disclosure requirements in your state. Read Less Aire Serv is a registered trademark of Aire Serv LLC © Aire Serv | All rights reserved | All Aire Serv franchise locations are independently owned and operated.


Does your home's temperature need a little adjusting? An HVAC contract is a document that establishes your agreement with the contractor you hire to fix or maintain your heating, ventilation and air conditioning systems. It's best to create a free HVAC contract before the work has even begun. We'll help you take down the details of your project so work can begin and your place will get back to a comfy temperature, fast.
Before opening the electrical cover on the A/C unit, be sure to shut off all power to the compressor unit and the indoor furnace or air handler, and verify that it is off. Note that this may mean shutting off a circuit breaker that serves the furnace and air handler, and then, near the compressor, pulling out the disconnect block (or shutting off the 220-volt power) to the outdoor compressor.
The compressor-based refrigerant systems are air-cooled, meaning they use air to exchange heat, in the same way as a car radiator or typical household air conditioner does. Such a system dehumidifies the air as it cools it. It collects water condensed from the cooled air and produces hot air which must be vented outside the cooled area; doing so transfers heat from the air in the cooled area to the outside air.
Air conditioning and refrigeration are provided through the removal of heat. Heat can be removed through radiation, convection, or conduction. Refrigeration conduction media such as water, air, ice, and chemicals are referred to as refrigerants. A refrigerant is employed either in a heat pump system in which a compressor is used to drive thermodynamic refrigeration cycle, or in a free cooling system which uses pumps to circulate a cool refrigerant (typically water or a glycol mix).
Turning to a source you know and trust is a solution many can rely on. Online review sites can be full of negative or glowing experiences – you don’t know who’s telling the truth on Yelp, you don’t know who they are! Your neighbor, coworker, or family member is someone you’ve built a relationship with. You trust their opinions on many subjects – local air conditioner repair is no different.”
Once a diagnosis is made to your air-conditioning and/or heating system, the unit can be repaired, in most situations, with stock HVAC parts off the truck. Sometimes the HVAC part has to be ordered because it is a specialty part that only the HVAC manufacturer of your equipment can provide. If the part can be picked up locally then you can expect to pay for travel time to and from the HVAC parts dealer. It is practically impossible to carry every single HVAC part for every single HVAC breakdown that occurs.
The icing problem becomes much more severe with lower outdoor temperatures, so heat pumps are commonly installed in tandem with a more conventional form of heating, such as a natural gas or oil furnace, which is used instead of the heat pump during harsher winter temperatures. In this case, the heat pump is used efficiently during the milder temperatures, and the system is switched to the conventional heat source when the outdoor temperature is lower.

If your AC doesn’t turn off when room temperature reaches the temperature set on the thermostat, the problem is generally occurring either at the thermostat or in the electrical system that runs the outside condensing unit. You can use the AC’s circuit breaker to shut off the unit, but that should not be a permanent solution—circuit breakers are not designed to be used like light switches.
Be cautious with companies that offer “whole house air duct cleaning,” urges the NADCA. The company may be using unscrupulous tactics to upsell you once they get started. Before any work begins, always clarify in writing what the job entails and what the cost will be. To protect yourself against fraud, read customer reviews and verify that your HVAC cleaning service has applicable licenses and certifications.

Air conditioning can also be provided by a process called free cooling which uses pumps to circulate a coolant (typically water or a glycol mix) from a cold source, which in turn acts as a heat sink for the energy that is removed from the cooled space. Common storage media are deep aquifers or a natural underground rock mass accessed via a cluster of small-diameter boreholes, equipped with heat exchanger. Some systems with small storage capacity are hybrid systems, using free cooling early in the cooling season, and later employing a heat pump to chill the circulation coming from the storage. The heat pump is added because the temperature of the storage gradually increases during the cooling season, thereby declining its effectiveness.

The heat-exchanger cools the air that is being forced through it by the furnace blower. As the warm air comes in contact with this cool surface the water in the air condenses. By pulling the water molecules from the air. According to the psychometric chart[42] as relative humidity decreases in order to feel cool you will have to lower the temperature even more. A common way to counteract this effect is by installing a whole-home humidifier.[43] Similarly, installing a high efficient system this need to turn the temperature down wont have such and influence on your energy costs.
With the right equipment and regular maintenance, your heating and cooling systems can pay you back. Our NATE-certified technicians are trained to maintain and repair central air conditioners and heat pumps from Carrier and all other brands. If you are experiencing problems with your furnace or AC system, we’ll make sure that your system is working properly, and we won’t leave until the job is complete and your home is comfortable. In this busy world, we understand the importance of prompt appointment scheduling and reliable service. We even offer 24-hour emergency service and after-hours air conditioner repairs that fit your busy schedule.
I have a recurring problem of having to have freon added to my A/C system. I have even replaced both units inside and outside but seem to have the same problem. I believe that it must be in the lines between the outside and inside. Is there anything that can be put into the lines to seal any leaks if this is the problem? If not is it advised that the lines be replaced?
"Highly recommend! From the time I contacted them to make an appointment, to them showing up, troubleshooting the issue with my a/c unit, them verifying my warranty and driving to Grapevine to get the part, then back to Fort Worth to install it was LESS than 24 hours. Outstanding service, price and knowledge. I will only use this company from now on. Would give ten stars if possible."
×