Denver HVAC Repair

I have a recurring problem of having to have freon added to my A/C system. I have even replaced both units inside and outside but seem to have the same problem. I believe that it must be in the lines between the outside and inside. Is there anything that can be put into the lines to seal any leaks if this is the problem? If not is it advised that the lines be replaced?
The heat pump gained popularity in the 1950s in Japan and the United States.[13] Heat pumps can extract heat from various sources, such as environmental air, exhaust air from a building, or from the ground. Initially, heat pump HVAC systems were only used in moderate climates, but with improvements in low temperature operation and reduced loads due to more efficient homes, they are increasing in popularity in cooler climates.

If the air conditioner on your thermostat set low, and you aren't feeling cool air, it could be that debris is blocking the condenser. Check on your system outside and remove any tree branches or leaves from around it. Debris can easily obstruct air flow, so make sure the area around your air conditioning unit is clean and trimmed back. Make sure your filter is clean. A buildup of dirt and dust can cause poor air circulation.


Our licensed HVAC Dallas Air Conditioning technicians are experts in air conditioning, heating & cooling technology and the latest innovations in green technology, including the installation of Energy Star certified products and the use of Ozone friendly refrigerants. Residential customers depend on Berkeys for timely, quality, and affordable air conditioning repair, maintenance, and installation solutions in Dallas. Read our Air Conditioning Reviews.
All modern air conditioning systems, even small window package units, are equipped with internal air filters. These are generally of a lightweight gauzy material, and must be replaced or washed as conditions warrant. For example, a building in a high dust environment, or a home with furry pets, will need to have the filters changed more often than buildings without these dirt loads. Failure to replace these filters as needed will contribute to a lower heat exchange rate, resulting in wasted energy, shortened equipment life, and higher energy bills; low air flow can result in iced-over evaporator coils, which can completely stop air flow. Additionally, very dirty or plugged filters can cause overheating during a heating cycle, and can result in damage to the system or even fire.

Your heating and cooling equipment is vital to your comfort and breakdowns can be stressful, inconvenient and even dangerous. You can rely on the professionals at One Hour Heating and Air Conditioning* for expert service when you need it most. Our highly-trained technicians are available around the clock to meet your heating and cooling needs. We'll install, repair and maintain your HVAC system, keeping it in peak condition. Give us a call when you need to:
So, whether you need a furnace repair or you’re searching for a new heating and cooling system—or you need a plumbing repair now–you can count on our team in North America. We’re specialists in heating system and plumbing repair and offering exceptional heating and plumbing service is what we do best. Call Service Experts 24/7/365 at 866-397-3787 or request an appointment online today, and don’t forget to visit our coupons page for savings on your heating system or plumbing repair service.

First, it is wise to stick with a company that specializes in HVAC services. While many general handyman companies may do some things with AC units, a company that specializes in air conditioning and heating is always a better option. Because air conditioning repairs can be quite costly, depending on the particular problem, it is best to work with highly trained HVAC professionals to ensure quality work.


Regardless of how far along you are in your air conditioning project, you should start looking for a contractor now. The demand for Portland air conditioning has begun to outstrip the supply of contractors, and homeowners are telling us they've had to fight/wait to schedule an installation date. This may also determine the availability of your preferred contractor, as the best contractors' schedules tend to fill more quickly than the rest. Once you've submitted your online request, you can trust that our contractors are the most reliable professionals in the business. Each and every one our contractors has been put through a rigorous ten-step screening process. Our online customer ratings and reviews section will allow you to see what other homeowners have said, not just about individual contractors, but Portland air conditioning installation in general.
Your home’s HVAC system is a fine-tuned piece of machinery. Like your car, your system needs regular maintenance and tune-ups to ensure it is running reliably. Manufacturer warranties for most new systems require annual tune-ups, and for good reason: these preventative maintenance measures extend the life of your system by keeping your system running the way it is designed to run.
Replacing a capacitor is easy. Just take a photo of the wires before disconnecting anything (you may need a reference later on). Then discharge the stored energy in the old capacitor (Photo 4). Use needle-nose pliers to pluck one wire at a time from the old capacitor and snap it onto the corresponding tab of the new capacitor. The female crimp connectors should snap tightly onto the capacitor tabs. Wiggle each connector to see if it’s tight. If it’s not, remove the connector and bend the rounded edges of it so it makes a tighter fit on the tab. When you’ve swapped all the wires, secure the new capacitor (Photo 5).
If you need a furnace repaired or an air conditioner serviced, we'll send a local technician out to diagnose the specific problem and recommend solutions for you and your family. There will be a diagnostic fee for the visit, and any specific repairs will be an additional charge. If replacing your system is the best solution, the fee for the diagnosis will be credited toward the purchase and install of a new system.
7) Schedule an annual tune-up with an HVAC professional. A trained HVAC technician can detect most problems before they become major ones. With a cost of around $100 for a routine maintenance call, the benefits will likely outweigh the costs by a considerable margin. A typical tune-up will include various tests to ensure your unit’s internal parts are functioning correctly, as well as a filter check, and a refrigerant charge if needed. Your technician will likely also clear the drain, and clean your unit thoroughly inside and out.
The most recognized standards for HVAC design are based on ASHRAE data. The most general of four volumes of the ASHRAE Handbook is Fundamentals; it includes heating and cooling calculations. Each volume of the ASHRAE Handbook is updated every four years. The design professional must consult ASHRAE data for the standards of design and care as the typical building codes provide little to no information on HVAC design practices; codes such as the UMC and IMC do include much detail on installation requirements, however. Other useful reference materials include items from SMACNA, ACGIH, and technical trade journals.
If the AC doesn’t turn off, it may be time to clean the condensing unit. Dirty condenser coils won’t give off heat efficiently and will keep the unit running.  Another possibility: The contacts on the outdoor run relay may have welded together—something that can happen over time because of frequent electrical arcing at the relay. Before checking the run relay, turn off the power to the furnace and the condensing unit. Next, disassemble the relay and pry apart the contacts. This should do the trick until you buy a replacement—which you should do soon.
We live in a recently completed townhouse that was built with double-wall construction. That construction method was touted by the builder as what would keep sound from penetrating between the units. But we can hear the next door neighbors' TV and stereo, and sometimes voices and even snoring, through the wall. While sometimes it's the volume, mostly it's the bass sounds coming through the wall. They say they don't hear us, but we keep our bass turned down. They crank up the bass, and they are not going to change that. They also are not going to do anything construction-wise to help from their side. What is the best way for us to try to block the low frequency/bass sounds from penetrating the existing wall into our side?
In 1995, Germany made CFC refrigerators illegal.[22] DuPont and other companies blocked the refrigerant in the U.S. with the U.S. EPA, disparaging the approach as "that German technology".[21][23] Nevertheless, in 2004, Greenpeace worked with multinational corporations like Coca-Cola and Unilever, and later Pepsico and others, to create a corporate coalition called Refrigerants Naturally!.[22][24] Then, four years later, Ben & Jerry's of Unilever and General Electric began to take steps to support production and use in the U.S.[25] In 2011 the EPA decided in favor of the ozone- and climate-safe refrigerant for U.S. manufacture.[17][26][27]
Circulating refrigerant vapor enters the compressor, where its pressure and temperature are increased. The hot, compressed refrigerant vapor is now at a temperature and pressure at which it can be condensed and is routed through a condenser. Here it is cooled by air flowing across the condenser coils and condensed into a liquid. Thus, the circulating refrigerant removes heat from the system and the heat is carried away by the air. The removal of this heat can be greatly augmented by pouring water over the condenser coils, making it much cooler when it hits the expansion valve.
If your air conditioner’s condenser coils, which are located in the outdoor unit, freeze up, your system will not run properly. Poor airflow through your cooling system can cause ice to form on the coils. Obstructions are typically the cause – such as dirty air filters or blocked return air ducts. Low refrigerant could also be the cause, requiring a refrigerant charge. A home AC repair technician can diagnose the issue behind your frozen coils, resolve it, and safely thaw your coils to restore cooling in your home.”

Brennan’s Heating & Air Conditioning is a Carrier Factory Authorized Dealer (FAD), and we got that way by demonstrating our knowledge and expertise in performing heating repairs and AC installation. We maintain this designation by offering superior service and by meeting stringent training requirements. That means we’re qualified to perform air conditioner repairs, warranty work, and these comprehensive services:


We do our best to screen all of our hvac contractors. However, there are still some hvac contractor professionals in Portland that have not been pre-screened. This means that their licenses may not be up to date to operate in Portland or OR. Always be sure to pre-screen them yourself before hiring. Here are some unscreened professionals offering hvac:
I needed a replacement for my heater. I called Bill Howe and they promptly fitted me into their schedule. The person who arrived, Laurence C. thoroughly tested my furnace and pointed out the problem. I decided to replace it. They arrived on the day to install it. The two men, Jose Gomez and Javier Diaz promptly went to work. They were clean, efficient and respectful of my home. I would gladly recommend Bill Howe for your heating and plumbing needs. They were great!!​
AC units and thermostats have built-in delay features when they’re shut down and then repowered. The delay can be as long as 10 minutes. And, if you’ve subscribed to an energy-saving device from your local power utility, the unit can take even longer to reset. If you’ve installed the parts shown and reinstalled the disconnect block, repowered the circuit breaker, turned on the switch at the furnace, moved the thermostat to AC mode and lowered the temperature below the indoor temperature, and the unit doesn’t fire up after 30 minutes, it’s time to call a pro.
×