Denver HVAC Repair

The Environmental Protection Agency (EPA) requires that all technicians who open a system containing a controlled refrigerant be certified to do so. There are four levels of certification, one of which is a “universal” certification to allow the HVAC technician to work on any type of equipment containing refrigerant. Your HVAC technician should be certified as “Level II Certified” at a minimum or, preferably, “Universal Certification” to work on your central air conditioner. Obtaining this certification information from your professional HVAC technician may be required in the event you are working with a realtor to sell your home. Costs for certification average $40-$240.

Replacing a capacitor is easy. Just take a photo of the wires before disconnecting anything (you may need a reference later on). Then discharge the stored energy in the old capacitor (Photo 4). Use needle-nose pliers to pluck one wire at a time from the old capacitor and snap it onto the corresponding tab of the new capacitor. The female crimp connectors should snap tightly onto the capacitor tabs. Wiggle each connector to see if it’s tight. If it’s not, remove the connector and bend the rounded edges of it so it makes a tighter fit on the tab. When you’ve swapped all the wires, secure the new capacitor (Photo 5).


Compare replacement and repair costs: A new boiler or furnace is a substantial investment, but repair costs can also become costly as well. Not to mention, there’s always the possibility of the same issue occurring again or the need for more work in the future. You may want to replace your heating system if the repairs exceed half of the replacement costs.
Packaged terminal air conditioner (PTAC) systems are also known as wall-split air conditioning systems.[36] They are ductless systems. PTACs, which are frequently used in hotels, have two separate units (terminal packages), the evaporative unit on the interior and the condensing unit on the exterior, with an opening passing through the wall and connecting them. This minimizes the interior system footprint and allows each room to be adjusted independently. PTAC systems may be adapted to provide heating in cold weather, either directly by using an electric strip, gas, or other heater, or by reversing the refrigerant flow to heat the interior and draw heat from the exterior air, converting the air conditioner into a heat pump. While room air conditioning provides maximum flexibility, when used to cool many rooms at a time it is generally more expensive than central air conditioning.
When you trust your winter comfort to Edwards Heating & Air, we answer with state-of-the-art technology, NATE-certified technicians, and prompt action.  As a Carrier Factory Authorized Dealer, we specialize in the most proven and sophisticated solutions to home and commercial temperature control.  Through ongoing factory training and strict installation and service procedures, the team from Edwards Heating & Air delivers superior workmanship and superior results.  We ensure your demands for efficiency, reliability, and consistent heating are met, and your expectations for courteous and skilled service are exceeded.  Whether you are in the process of building your dream home, in need of effective heating for your existing home or business, or upgrading your furnace or heat pump, our installation specialists provide informed recommendations, attention to detail, and quick turnaround on your project.  Serving Acworth and the surrounding areas of Acworth, Alpharetta, Cummings, Cartersville, Kennesaw & Woodstock, GA since 2001, you can count on Edwards Heating & Air for everything from installation and maintenance to emergency repairs.
Check your filter every month, especially during heavy use months (winter and summer). If the filter looks dirty after a month, change it. At a minimum, change the filter every 3 months. A dirty filter will slow down air flow and make the system work harder to keep you warm or cool — wasting energy. A clean filter will also prevent dust and dirt from building up in the system — leading to expensive maintenance and/or early system failure.

If your heating system is not running efficiently, it will not heat your home effectively. A good sign you have an inefficient heater is if you notice some rooms in your house aren’t heating to the temperature you set. Older systems could have difficulty heating your entire household, and you’ll know this if you notice some rooms are warmer than others.
Since 1971, One Hour Heating & Air Conditioning has been the leading Charlotte AC repair company. Our technicians are not only professional experts, but they work 24/7, 365 days a year to make sure you’re comfortable. Plus, they’re “Always on time… or you don’t pay a dime.” ®. If you are looking for heating and air in Charlotte NC, you are in the right place!
From Day 1, Alberto walked us through the process, and present us with a variety of options based our budget for the project. His customer service is the best as he did not oversell any services and did not nudge us towards buying a unit that would stretch our budget. On installation day, HVAC Services sent out a crew of 6-7 guys, all of whom were very polite and kept their work areas clean, and installed the whole system the same day.
The contactor (relay) and start/run capacitor(s) (see illustration below) fail most often and are inexpensive. So it’s a safe bet to buy and install those parts right away, especially if your air conditioning service unit is older than five years. The condenser fan motor can also fail, but it runs about $150 — hold off buying that unless you’re sure that’s the culprit.
×