Denver HVAC Repair

Our A/C was blowing hot air intermittently...it was cold one minute and warm the next. By 8pm I'd have a 90 degree interior temp. After one company just took a cursory glance at our A/C and found nothing wrong, I called HVAC. I called them mostly based on Michael W's post on 8/10/14 where he told us the owner, Alberto, took his feedback and took it SERIOUSLY. That speaks VOLUMES to anyone who has been around long enough to know the characteristics of the serious players are and those who are the wannabes. So HVAC sent Tony Diaz to my house. I was at work so he was subjected to the most excruciatingly exacting woman on the planet (my wife). Tony impressed her with his friendliness, professionalism and the obvious jouneyman-level knowledge of his craft. He found literally --burnt-out-- parts in our system and replaced them. It cost us a bit but I know enough about the parts to see there was no gouging on the parts and a fair rate for the labor. It wasn't cheap but it was fair and worth every dime. And now i have A/C in my house again and a repairman came to my house, actually FIXED something AND managed to do so in a friendly & professional manner. That used to be commonplace...nowadays it deserves a "Wow".. Thank you, Tony!

Although HVAC is executed in individual buildings or other enclosed spaces (like NORAD's underground headquarters), the equipment involved is in some cases an extension of a larger district heating (DH) or district cooling (DC) network, or a combined DHC network. In such cases, the operating and maintenance aspects are simplified and metering becomes necessary to bill for the energy that is consumed, and in some cases energy that is returned to the larger system. For example, at a given time one building may be utilizing chilled water for air conditioning and the warm water it returns may be used in another building for heating, or for the overall heating-portion of the DHC network (likely with energy added to boost the temperature).[4][5][6]
AC units and thermostats have built-in delay features when they’re shut down and then repowered. The delay can be as long as 10 minutes. And, if you’ve subscribed to an energy-saving device from your local power utility, the unit can take even longer to reset. If you’ve installed the parts shown and reinstalled the disconnect block, repowered the circuit breaker, turned on the switch at the furnace, moved the thermostat to AC mode and lowered the temperature below the indoor temperature, and the unit doesn’t fire up after 30 minutes, it’s time to call a pro.

Refrigeration air conditioning equipment usually reduces the absolute humidity of the air processed by the system. The relatively cold (below the dewpoint) evaporator coil condenses water vapor from the processed air, much like an ice-cold drink will condense water on the outside of a glass. Therefore, water vapor is removed from the cooled air and the relative humidity in the room is lowered. The water is usually sent to a drain or may simply drip onto the ground outdoors. The heat is rejected by the condenser which is located outside of room to be cooled.


A specialized air conditioner that is used only for dehumidifying is called a dehumidifier. It also uses a refrigeration cycle, but differs from a standard air conditioner in that both the evaporator and the condenser are placed in the same air path. A standard air conditioner transfers heat energy out of the room because its condenser coil releases heat outside. However, since all components of the dehumidifier are in the same room, no heat energy is removed. Instead, the electric power consumed by the dehumidifier remains in the room as heat, so the room is actually heated, just as by an electric heater that draws the same amount of power.
No matter where you bought your air conditioning system, we can repair it. We have years of experience working with all the best central air conditioner brands such as Kenmore, Carrier. Trane, Goodman, and Rheem. As a result, you can rest assured we’re familiar with your air conditioning system and we have the parts you need to complete a successful air conditioner repair.
We have been using Bill Howe Plumbing's service for more than 25 years and have been pleasantly surprised at how consistently they perform an excellent service call. We use them for our home and our rental properties, and their dispatchers and technicians have always been the best at problem solving; our tenants have told us how great the service is as well. When we needed air conditioning service, naturally we called Bill Howe first. There's no reason to call anyone else. I know the job will be done right the first time, with fair pricing and professional service.
When you need prompt, dependable heating or air conditioning repair in Cumming, you can count on Coolray. We have served the Atlanta metro area for more than 50 years and we are staffed with HVAC professionals that are ready to tackle any heating or air conditioning issue you have, 24 hours a day, 7 days a week. Our technicians are licensed, trained, and have the tools and experience to correctly diagnose and repair your air conditioner, furnace, heat pump or HVAC equipment. 

1) Change your filter. The simplest and most effective way to keep your AC running smoothly is changing your filter once a month. By regularly changing your filter, you reduce a lot of the burden on your system. A dirty or clogged filter makes your air conditioner work much harder than does a clean filter. Changing your filters regularly is easy on your budget and easy on your system as well. It will lower your utility bill and extend the life of your AC.
Special chemicals can be used to clean mineral deposits, but one of the safest is vinegar. A 50% mixture of vinegar and water will usually dissolve or help clean away deposits. If the humidifier has a drum with a belt, replacement of the belt at the beginning of the heating season can be the easiest fix if the water has a high mineral content. If the humidifier has screens or is the wick type, some corrosion can occur as well as build up

All modern air conditioning systems, even small window package units, are equipped with internal air filters. These are generally of a lightweight gauzy material, and must be replaced or washed as conditions warrant. For example, a building in a high dust environment, or a home with furry pets, will need to have the filters changed more often than buildings without these dirt loads. Failure to replace these filters as needed will contribute to a lower heat exchange rate, resulting in wasted energy, shortened equipment life, and higher energy bills; low air flow can result in iced-over evaporator coils, which can completely stop air flow. Additionally, very dirty or plugged filters can cause overheating during a heating cycle, and can result in damage to the system or even fire.
Does your home's temperature need a little adjusting? An HVAC contract is a document that establishes your agreement with the contractor you hire to fix or maintain your heating, ventilation and air conditioning systems. It's best to create a free HVAC contract before the work has even begun. We'll help you take down the details of your project so work can begin and your place will get back to a comfy temperature, fast.
As an Atlanta resident, you’re well aware that the weather in our area can go through extremes of both hot and cold throughout the year, taxing your heating and cooling system to its limits. You’ll likely encounter the need for repair or replacement at some point. If you need HVAC installation, HVAC maintenance, or HVAC service and repair, R.S. Andrews is the most trusted name in Atlanta.
Modern air conditioning systems are not designed to draw air into the room from the outside, they only recirculate the increasingly cool air on the inside. Because this inside air always has some amount of moisture suspended in it, the cooling portion of the process always causes ambient warm water vapor to condense on the cooling coils and to drip from them down onto a catch tray at the bottom of the unit from which it must then be routed outside, usually through a drain hole. As this moisture has no dissolved minerals in it, it will not cause mineral buildup on the coils. This will happen even if the ambient humidity level is low. If ice begins to form on the evaporative fins, it will reduce circulation efficiency and cause the development of more ice, etc. A clean and strong circulatory fan can help prevent this, as will raising the target cool temperature of the unit's thermostat to a point that the compressor is allowed to turn off occasionally. A failing thermistor may also cause this problem. Refrigerators without a defrost cycle may have this same issue. Dust can also cause the fins to begin blocking air flow with the same undesirable result: ice.
They were quick to come out and diagnose the problem with my furnace, but I thought the estimate of $549 a bit high to replace the circuit board.  So called around and found Leo's Appliance in Concord that sells appliance parts and the circuit board was only $90.49 - that is the retail cost to me, so I imagine the wholesale cost is a lot less.  So BEWARE of this company since they wanted $500!!! to replace the circuit board which is located right in the front of the furnace - extremely easy to access.  I hate it that you cannot trust repair companies.

An air conditioner’s cooling process produces condensation, which normally flows away from the equipment, causing no problem. If there is a clog in the condensate drain lines or drip pan, or if outdoor humidity levels are high, moisture may back up into your air conditioner. Excess condensation will increase indoor humidity levels and hinder the air conditioner’s performance. It could also cause damage to your air conditioner’s components.

For details about apprenticeships or other work opportunities, contact the offices of the state employment service, the state apprenticeship agency, local contractors, or local union–management HVACR apprenticeship committees. Apprenticeship information is available from the U.S. Department of Labor’s Apprenticeship program online or by phone at 877-872-5627.


Berkeys is a licensed HVAC contractor and air conditioning company offering AC repair, Air Conditioning tune-up, and air conditioning replacement services in Southlake, TX, Keller, TX, Coppell, TX, Colleyville, TX, Grapevine, TX, Plano, TX, Fort Worth, TX, Arlington, TX, Frisco, TX, Dallas, TX, Addison, TX, Flower Mound, TX, Irving, TX, McKinney, TX, Arlington, TX, Euless, TX, Denton, TX, Highland Village, TX, Grand Prairie, TX, Westlake, TX, Farmers Branch, TX, Lewisville, TX and more. Call to confirm service for your home.
Just like running a marathon, we perform better at full strength. If we’re not feeling great, it’s that much harder to finish the race. Similarly, when you set your thermostat to a certain temperature, the system is tasked with maintaining that temperature throughout the room. Working at full strength, the system can easily maintain that temperature (as long as it’s not below 60 degrees or above 80 degrees). However, when injured, the system may struggle to keep the room at your desired temperature. As such, it’s working harder, which means higher utility bills.
Next, consider the age of your unit. Remember, as we mentioned earlier, that the average life of a furnace is around 15 to 20 years. In some cases, during the installation process, your licensed and trained technician will write down the installation date right on the unit. If not, you can check inside the chamber door for a metal identification plate containing the serial and model numbers. You can then call the customer service line of the manufacturer and ask for the manufacture date of the unit.
Although your AC may continue to work for a time, if you ignore warning signs of air conditioner repair troubles, it can be much more costly to repair in the long term. Diminished cooling capacity not only makes your home uncomfortably warm, but it also raises your utility bills significantly as your unit struggles to maintain the desired temperature ineffectively. A system put under strain is likely to overheat, resulting in major damage. Therefore, it is best to have your air conditioner repaired promptly when you discover signs of trouble. 

BGE HOME HVAC repair technicians are thoroughly trained and certified to work on all major brands of heating and air conditioning equipment. When your system breaks down and needs a heating and air conditioning repair, you want to call someone you can trust. Need air conditioning service in the middle of the night? Emergency heating and cooling HVAC service is available 24 hours a day by calling 888-243-4663.
×