Denver HVAC Repair

When you run into issues with the HVAC system at your home or office, you need a team of professionals by your side right away. That's exactly what A & K Service Heating & Cooling Inc. is here for. We'll take on any job in the Alpharetta and Woodstock, Georgia areas, from filter changeouts in single-family homes to complete HVAC overhauls in large commercial properties.
No one wants to be stuck in the dead of summer with a broken air conditioner, or in the cold of winter with a broken furnace or boiler. That’s why we’re available any time of day to make your emergency heating and air conditioning repair and get your system up and running as quickly as possible. We’ll show up on time, in uniform and ready to make your HVAC repair right the first time.
In very dry climates, evaporative coolers, sometimes referred to as swamp coolers or desert coolers, are popular for improving coolness during hot weather. An evaporative cooler is a device that draws outside air through a wet pad, such as a large sponge soaked with water. The sensible heat of the incoming air, as measured by a dry bulb thermometer, is reduced. The temperature of the incoming air is reduced, but it is also more humid, so the total heat (sensible heat plus latent heat) is unchanged. Some of the sensible heat of the entering air is converted to latent heat by the evaporation of water in the wet cooler pads. If the entering air is dry enough, the results can be quite substantial.
With the split system, the evaporator coil is connected to a remote condenser unit using refrigerant piping between an indoor and outdoor unit instead of ducting air directly from the outdoor unit. Indoor units with directional vents mount onto walls, suspended from ceilings, or fit into the ceiling. Other indoor units mount inside the ceiling cavity, so that short lengths of duct handle air from the indoor unit to vents or diffusers around the rooms.

Other than mineral deposits, the most common problem is sediment in the water supply. The float inlet valve has a tiny hole that easily clogs. The float is usually made of plastic, and if cracked will fill with water and sink. The valve will be stuck open and the reservoir will overflow. Use caution when scraping deposits off the float. If the deposits cannot be removed, replace the float or it will sink and cause an overflow.


Brennan’s Heating & Air Conditioning is a Carrier Factory Authorized Dealer (FAD), and we got that way by demonstrating our knowledge and expertise in performing heating repairs and AC installation. We maintain this designation by offering superior service and by meeting stringent training requirements. That means we’re qualified to perform air conditioner repairs, warranty work, and these comprehensive services:
When you need prompt, dependable heating or air conditioning repair in Cumming, you can count on Coolray. We have served the Atlanta metro area for more than 50 years and we are staffed with HVAC professionals that are ready to tackle any heating or air conditioning issue you have, 24 hours a day, 7 days a week. Our technicians are licensed, trained, and have the tools and experience to correctly diagnose and repair your air conditioner, furnace, heat pump or HVAC equipment. 
Advantages of the ductless system include smaller size and flexibility for zoning or heating and cooling individual rooms. The inside wall space required is significantly reduced. Also, the compressor and heat exchanger can be located farther away from the inside space, rather than merely on the other side of the same unit as in a PTAC or window air conditioner. Flexible exterior hoses lead from the outside unit to the interior one(s); these are often enclosed with metal to look like common drainpipes from the roof. In addition, ductless systems offer higher efficiency, reaching above 30 SEER.[39]
The quality of the air you breathe affects your comfort, health, and productivity.  Whether at home or in the workplace, an ample supply of fresh, clean air is essential to everyday life.  Whatever concerns you may face, Edwards Heating & Air provides proven, cost-effective products to significantly improve Indoor Air Quality.  Our NATE-certified specialists are qualified to analyze your residential or commercial space, make informed recommendations, and implement a strategy specifically targeted at your unique circumstances.  As a Carrier Factory Authorized Dealer, we are extensively trained in leading-edge products that silently and effectively eliminate harmful bacteria, fumes, chemicals, viruses, smoke, and much more.  The installation of a humidifier, ventilator, air filter, or UV lamp will protect the health of your indoor breathing air, maintain a cleaner, more comfortable home, and even reduce energy costs.  Contact the specialists from Edwards Heating & Air for trusted solutions and complete peace of mind.  
"Customer service was great, and the price was in-line with other places, and fast service. We had a whole replacement of the outside and inside. I would have liked to see a better install for the furnace and new thermostat - the new thermostat should have gone where the old one was, and even tho the new furnace was a tight fit, they didn't offer to come back and repair the case molding, or give me a discount on the damage done, and I believe they should have put a disconnect box on the outside of the home, to make it easier for any future repairs needed. Other than that, am very happy with the cooling and heating!"
Some types of filters are reusable; others must be replaced. They are available in a variety of types and efficiencies. Clean or replace your air conditioning system's filter or filters every month or two during the cooling season. Filters may need more frequent attention if the air conditioner is in constant use, is subjected to dusty conditions, or you have fur-bearing pets in the house.
Eventually, every homeowner experiences a malfunction in their heating unit. It’s a cold morning and you hike the thermostat up like you usually do to take the chill off, but you get no response. You don’t hear the system firing up or feel the radiators or air vents producing any heat. You hope it’s just a quick fix, like a clogged filter or a tripped circuit breaker. On the other hand, you might be wondering if it’s more cost-effective to just have the unit replaced.
Heaters are appliances whose purpose is to generate heat (i.e. warmth) for the building. This can be done via central heating. Such a system contains a boiler, furnace, or heat pump to heat water, steam, or air in a central location such as a furnace room in a home, or a mechanical room in a large building. The heat can be transferred by convection, conduction, or radiation.
Start with your utility company; they can help a great deal. Comparing previous bills isn't always a good measure, as the weather is never exactly the same month to month. Instead, if you take your energy bill and divide it by the square footage of livable space in your home, don't count areas like unfinished garages or basements -- you can calculate how much you are spending to heat or cool each square foot of your home. Your energy provider can tell you what the average cost per square foot is in your region for that same period of time so you can compare apples to apples.

The most recognized standards for HVAC design are based on ASHRAE data. The most general of four volumes of the ASHRAE Handbook is Fundamentals; it includes heating and cooling calculations. Each volume of the ASHRAE Handbook is updated every four years. The design professional must consult ASHRAE data for the standards of design and care as the typical building codes provide little to no information on HVAC design practices; codes such as the UMC and IMC do include much detail on installation requirements, however. Other useful reference materials include items from SMACNA, ACGIH, and technical trade journals.

Should I repair or replace my HVAC? It’s a common question — and you need to weigh several factors to make the decision. One of the most significant factors is the lifespan of your unit. According to EnergyStar — a U.S. Environmental Protection Agency voluntary program — an A.C. unit lasts about 15 to 20 years. On average, a heat pump perseveres for 16 years and a furnace functions for between 15 to 20 years, reports This Old House.
Allow our experts to help with any of your heating and cooling needs or questions. Our wide array of expertise and background will benefit you and your home, whether you are considering a replacement system or evaluating your whole system to check for areas of improvement. We can help you reach your optimum indoor comfort. Give us a ring at 866-397-3787 or request an appointment online.
×