Denver HVAC Repair

If the AC doesn’t turn off, it may be time to clean the condensing unit. Dirty condenser coils won’t give off heat efficiently and will keep the unit running.  Another possibility: The contacts on the outdoor run relay may have welded together—something that can happen over time because of frequent electrical arcing at the relay. Before checking the run relay, turn off the power to the furnace and the condensing unit. Next, disassemble the relay and pry apart the contacts. This should do the trick until you buy a replacement—which you should do soon.
Routine maintenance involves replacing or cleaning the filters if so equipped, and keeping the outside air intake free of debris. After years of service the air exchanger will become crusted with grease and dirt that collects during condensation. Removing this accumulation will probably take solvents or degreasers and require opening up the cabinet and compartments.

In variable climates, the system may include a reversing valve that switches from heating in winter to cooling in summer. By reversing the flow of refrigerant, the heat pump refrigeration cycle is changed from cooling to heating or vice versa. This allows a facility to be heated and cooled by a single piece of equipment by the same means, and with the same hardware.
   As for parts prices, we are a business and factor in profit and overhead into our pricing structure, and frequently research other companies to be sure we are competitive, which we are. Jody, you did not pay $400 for labor, you paid $489 for a flat rate repair which included, travel, labor, diagnostics, parts, tax, shipping, truck charge, fuel charge, overtime rate, profit and overhead. As for the time of the actual repair, if it had taken 2 or 3 hours the cost would have still been the same $489.        

Abacus’ plumbers are also experts at sewer & pipe repairs, shower & tub repairs/installations, kitchen & bath faucet repair/installations, sink repairs/installation, plumbing inspections, water filtration, water softening, garbage disposal repair/installation, toilet repair/replacement, drain cleaning with drain camera inspections, leak detection/repair, plumbing repair/installation and back flow prevention for all Houston Texas homes & commercial business properties. Need an annual Plumbing Inspection on all your home’s plumbing systems? Ask about the Abacus CLUB. The CLUB membership will give you the peace of mind that your plumbing system is working at top efficiency. Our licensed plumbers will conduct an inspection of your home to look for and fix any potential plumbing problems. 


Central, "all-air" air-conditioning systems (or package systems) with a combined outdoor condenser/evaporator unit are often installed in North American residences, offices, and public buildings, but are difficult to retrofit (install in a building that was not designed to receive it) because of the bulky air ducts required. (Minisplit ductless systems are used in these situations.) Outside of North America, packaged systems are only used in limited applications involving large indoor space such as stadiums, theatres or exhibition halls.
As an Atlanta resident, you’re well aware that the weather in our area can go through extremes of both hot and cold throughout the year, taxing your heating and cooling system to its limits. You’ll likely encounter the need for repair or replacement at some point. If you need HVAC installation, HVAC maintenance, or HVAC service and repair, R.S. Andrews is the most trusted name in Atlanta.

Here’s a simple test to try on your own: When it’s hotter than 80 degrees outside, turn on your AC unit, and set it to well below room temperature. Let it run for 15 minutes, then use a thermometer to check just outside the return duct (the area where air flows in to be cooled). Now take a temperature reading just outside the strongest, most easily accessible vent (where cool air should be flowing out). Subtract the second reading from the first. If the difference between these two is fewer than 14 degrees, your HVAC unit might need work. 


Central home air conditioner service systems consist of two major components: a condensing unit that sits outside your house, and the evaporator coil (often referred to as an A-coil) that sits in the plenum of your furnace or air handler. The refrigerant in the A-coil picks up the heat from your home and moves it to the outdoor condensing unit. The condensing unit fan blows outside air through the condensing coil to remove the heat. The condensing unit houses the three parts replaceable by a DIYer: the contactor, the start/run capacitor(s) and the condenser fan motor. The condensing unit also houses the compressor, but only a pro can replace that. The A-coil has no parts that can be serviced by a DIYer.
×