Denver HVAC Repair

Your system is 10 - 15 years old: Follow this simple rule of thumb from Energy Star—if your current system is over 10 years old, it's time to start looking into an HVAC replacement. Most HVAC systems last for about 15 years, so there’s no immediate need to replace yours if it’s still functioning properly. But by doing your research now, you’ll know just what you want to do should your HVAC system suddenly stop working properly.
Ventilation, air conditioning and heating systems require regular maintenance for them to work efficiently. You’ll likely need tune-ups and repairs for them at some point during their lifespan. However, no matter how much preventative maintenance you put into your HVAC system, there comes a time when repairs aren’t enough anymore and it’s time for a replacement.
Got to say that I am very pleased with their work. The knowledge of the technician was on the spot. She was very professional at all times sharing her expertise and advice with me. Going further, I have hired some other pro's from this website to fix my AC and none them identified a faulty connection on the AC blower control board as my technician from Superior AC did. The price for the repair was fair, no overpricing at all. I am pretty sure that I will call them again and definitively recommend them. Thanks!! Aurelio
This information is not intended as an offer to sell, or the solicitation of an offer to buy, a franchise. It is for information purposes only. Read More Currently, the following states regulate the offer and sale of franchises: California, Hawaii, Illinois, Indiana, Maryland, Michigan, Minnesota, New York, North Dakota, Oregon, Rhode Island, South Dakota, Virginia, Washington, and Wisconsin. If you are a resident of or want to locate a franchise in one of these states, we will not offer you a franchise unless and until we have complied with applicable pre-sale registration and disclosure requirements in your state. Read Less Aire Serv is a registered trademark of Aire Serv LLC © Aire Serv | All rights reserved | All Aire Serv franchise locations are independently owned and operated.
Its difficult to describe how good of an experience I had with Cobb heat and AC. Ill put it like this, I have gone two 3 other AC repair companies, they send out their most novice field engineer, they give me a 6000 dollar quote to replace my AC for a property I just purchased, and then they leave. Mr Cobb came out himself, figured out the issue cleaned the condenser coils and told me my unit was only a YEAR OLD!!! He did not try to up-sale me or BS me with a quote to replace the boiler which I have had happen as well as the ac unit. Other AC companies suck, I'm sticking with Cobb. hope that helps

The use of furnaces, space heaters, and boilers as a method of indoor heating could result in incomplete combustion and the emission of carbon monoxide, nitrogen oxides, formaldehyde, volatile organic compounds, and other combustion byproducts. Incomplete combustion occurs when there is insufficient oxygen; the inputs are fuels containing various contaminants and the outputs are harmful byproducts, most dangerously carbon monoxide, which is a tasteless and odorless gas with serious adverse health effects.[14]


AC air handler buzzing sounds. Do you hear a buzzing sound when you turn on the thermostat? The only thing that comes on in the house when you turn on the thermostat is the fan relay and fan in the air handler or furnace. Try switching the thermostat HEAT/COOL switch to OFF. Then switch the fan switch from AUTO to ON. The fan (only) should come on. If the air handler makes a buzzing sound, it probably has a bad fan relay or, more likely, blower fan.
Beyond changing the air filter on a regular basis, one of the best ways to ensure your home's HVAC system is operating at peak efficiency is to have a qualified professional HVAC contractor tune up the system on a biannual basis. Energy Star recommends scheduling your system tune-up around the beginning of daylight savings time in the fall and its end in the spring. It's an easy way to remember to have your system serviced before the peak heating and cooling seasons. A standard tune-up is likely to cost you between $70 and $100, but it's money well spent. 
Clean air delivery rate is the amount of clean air an air cleaner provides to a room or space. When determining CADR, the amount of airflow in a space is taken into account. For example, an air cleaner with a flow rate of 100 cfm (cubic feet per minute) and an efficiency of 50% has a CADR of 50 cfm. Along with CADR, filtration performance is very important when it comes to the air in our indoor environment. Filter performance depends on the size of the particle or fiber, the filter packing density and depth and also the air flow rate.[26]
James Harrison's first mechanical ice-making machine began operation in 1851 on the banks of the Barwon River at Rocky Point in Geelong, Australia. His first commercial ice-making machine followed in 1853, and his patent for an ether vapor compression refrigeration system was granted in 1855. This novel system used a compressor to force the refrigeration gas to pass through a condenser, where it cooled down and liquefied. The liquefied gas then circulated through the refrigeration coils and vaporized again, cooling down the surrounding system. The machine produced 3,000 kilograms (6,600 lb) of ice per day.[citation needed]

We believe in building trust and bringing you value for every dollar you spend. Our proven Enhanced Services Program does just that, providing all of the benefits of a full service maintenance program with none of the draw backs. Our transparent process has no pre-existing issue limitations, no equipment or component exclusions, and ensures you receive value for every dollar of your budget.

Service Experts Heating and Air Conditioning was founded with the understanding of delivering customers with the top of the line heating and cooling practices in the industry. Since its inception, TML Service Experts in Boise has been faithful to our area, providing the first class HVAC (Heating, Ventilation, Air Conditioning) products and services in the area. If you would like to more details about your local HVAC leaders, you can reach us at 208-488-4892 or schedule an appointment with us through our website.


Air changes per hour Bake-out Building envelope Convection Dilution Domestic energy consumption Enthalpy Fluid dynamics Gas compressor Heat pump and refrigeration cycle Heat transfer Humidity Infiltration Latent heat Noise control Outgassing Particulates Psychrometrics Sensible heat Stack effect Thermal comfort Thermal destratification Thermal mass Thermodynamics Vapour pressure of water
For residential homes, some countries set minimum requirements for energy efficiency. In the United States, the efficiency of air conditioners is often (but not always) rated by the seasonal energy efficiency ratio (SEER). The higher the SEER rating, the more energy efficient is the air conditioner. The SEER rating is the BTU of cooling output during its normal annual usage divided by the total electric energy input in watt hours (W·h) during the same period.[33]
Not obvious is the fact that they need maintenance routinely, just like any other machine. The filter, usually located behind the front grill, needs to be washed. The condenser coil at the back of the unit can accumulate a lot of debris, and might require a special chemical bath. All air conditioning systems, large or small, need good air flow across the evaporator coil and the condenser coil. Efficiency and performance drop rapidly as air flow decreases. Lose enough air flow and the unit will burn out. Rodents can nest inside when not in use, and can foul up the unit in many ways. Wasps and hornets, as well as the honey bee find finned coils to be comfortable nesting places. Nests and dead insects can ruin the air conditioner.
Air Conditioning Service Repair - No matter what name brand (York, Trane, Carrier, Goodman, Lennox, Rheem) of air conditioning and/or heating unit you purchase some time or the other you will need to have that air conditioning and heating equipment checked for a problem and repaired. Even if you have regular air conditioning maintenance done. While there are air
Finally, after the air conditioning unit has been properly charged, the unit should definitely cool better. There should be a temperature difference between the return and supply of 12° to 20° Fahrenheit (delta T). That range is generally acceptable for a proper delta T temperature. This dat is used to determine if your air conditioning system is operating efficiently. If you do not have this range of temperature differential with your air conditioning system then there are problems. These problems need to be addressed whether it is bad duct or a mechanical or electrical issue causing the problem. Lastly, the unit is simply not providing the cooling it needs to provide to make you comfortable.
Our Technicians are NATE Certified, licensed TACLA00078831E,  and will arrive in vehicles fully stocked so that the repair can be done the same day. When it comes to system performance, we are the pros. We have had extensive training in residential and commercial air balancing which means we can dial in your system to perform at maximum levels. We specialize in home or business air conditioning service and repair.
First, it is wise to stick with a company that specializes in HVAC services. While many general handyman companies may do some things with AC units, a company that specializes in air conditioning and heating is always a better option. Because air conditioning repairs can be quite costly, depending on the particular problem, it is best to work with highly trained HVAC professionals to ensure quality work.
In the refrigeration cycle, heat is transported from a colder location to a hotter area. As heat would naturally flow in the opposite direction, work is required to achieve this. A refrigerator is an example of such a system, as it transports the heat out of the interior and into its environment. The refrigerant is used as the medium which absorbs and removes heat from the space to be cooled and subsequently ejects that heat elsewhere.
    Second, there are the diagnostics involved as well as the return trip to effect the actual repair. What about the hidden costs such as having the part picked up at the supplier, was this considered? As for the parts manager at our shop having wasted time tracking the part down, it often happens that we have to contact several suppliers to find parts especially during the recent cold spell when so many suppliers were out of stock of even the most common service items due to demand being so high.
What type of insurance do you have? Heating, ventilation and air conditioning (HVAC) professionals work on a variety of mechanical areas of the home. You'll want to ask specific questions regarding professional training and licensing, as well as what types of insurance they have (for example, mold, air pollution or worker's compensation). It's fair to ask for the dollar amounts they are covered and a quality professional will show you verification of coverage.
In modern buildings, the design, installation, and control systems of these functions are integrated into one or more HVAC systems. For very small buildings, contractors normally estimate the capacity and type of system needed and then design the system, selecting the appropriate refrigerant and various components needed. For larger buildings, building service designers, mechanical engineers, or building services engineers analyze, design, and specify the HVAC systems. Specialty mechanical contractors then fabricate and commission the systems. Building permits and code-compliance inspections of the installations are normally required for all sizes of building.

SEER is related to the coefficient of performance (COP) commonly used in thermodynamics and also to the Energy Efficiency Ratio (EER). The EER is the efficiency rating for the equipment at a particular pair of external and internal temperatures, while SEER is calculated over a whole range of external temperatures (i.e., the temperature distribution for the geographical location of the SEER test). SEER is unusual in that it is composed of an Imperial unit divided by an SI unit. The COP is a ratio with the same metric units of energy (joules) in both the numerator and denominator. They cancel out, leaving a dimensionless quantity. Formulas for the approximate conversion between SEER and EER or COP are available.[34]
Sometimes a heating and air conditioning system just needs to be repaired rather than completely replaced. You may need air conditioning repair services if there is leaking around the outside unit, the air coming into the house isn't hot or cool enough, the unit is short-cycling or constantly turning on and off, using the system is consistently resulting in higher-than-normal energy bills, or if there is excessive noise during startup and operation.
BGE HOME HVAC repair technicians are thoroughly trained and certified to work on all major brands of heating and air conditioning equipment. When your system breaks down and needs a heating and air conditioning repair, you want to call someone you can trust. Need air conditioning service in the middle of the night? Emergency heating and cooling HVAC service is available 24 hours a day by calling 888-243-4663.
×