Denver HVAC Repair

When you need prompt, dependable heating or air conditioning repair in Cumming, you can count on Coolray. We have served the Atlanta metro area for more than 50 years and we are staffed with HVAC professionals that are ready to tackle any heating or air conditioning issue you have, 24 hours a day, 7 days a week. Our technicians are licensed, trained, and have the tools and experience to correctly diagnose and repair your air conditioner, furnace, heat pump or HVAC equipment. 
We service, repair and install most every type of hvac system whether it’s gas, electric or oil, on hvac systems (furnaces, heatpumps air conditioning untis and boilers) by Trane, Bryant, York, Goodman, Lennox, Rheem, Panasonic, Fujitsu and many more.  Our service area is mainly around the I-97 to Rout 32 corridor specifically Annapolis, Crownsville, Severna Park, Millersville, Gambrills, Crofton, Odenton, Severn, Fort Meade, Jessup, Elkridge through Columbia, MD.
Strongsville Heating & Air Conditioning simplifies the challenges of keeping a perfectly comfortable home. We provide convenience, cost-savings, and reliability using top of the line products, premium materials, highly skilled technicians and exceptional customer service. Whether you need a new heating/cooling installation, replacement, retrofit, routine maintenance, trustworthy repair or air quality options, count on our team of NATE-certified technicians to eliminate stress and maximize comfort. We protect your busy schedule with flexible appointments, prompt arrival and mess free completion. Strongsville Heating & Air Conditioning is always available to you for Emergency Service, 24 hours a day, 365 days a year across Strongsville & Surrounding Areas.
If the unit isn't turning on, check on it outside to make sure the condenser is still running. It should be fully plugged in and the thermostat should be set. Lower the thermostat by a few more degrees than your typical setting. You should hear it power on after doing so. If that doesn't take care of the problem, check your fuse box. You could have a blown fuse or a tripped circuit that's causing the air conditioner to not turn on.

Edwards Heating & Air continues to look for new ways to improve service.  We hire only NATE-certified, extensively experienced, and dedicated professionals.  We offer a wide range of products, from ductless options to heat pumps, furnaces, air conditioners, and air quality systems, guaranteed to answer the most challenging comfort demands.  To maintain your equipment in peak condition, promoting year after year of uninterrupted performance, we offer preventative service plans that are affordable, convenient, and effective.  If you are ever confronted with a malfunction, the team from Edwards Heating & Air is always available, 24 hours a day, 7 days a week, to provide the skilled assistance you need. Through our relationship with Wells Fargo Financial National Bank, we offer flexible financing options with approved credit to facilitate your investment into superior quality heating and cooling.  Our ongoing dedication to your complete satisfaction is evidenced by our complaint-free, A+ rating by the Better Business Bureau.  At Edwards Heating & Air, we do things right, every time.
What type of insurance do you have? Heating, ventilation and air conditioning (HVAC) professionals work on a variety of mechanical areas of the home. You'll want to ask specific questions regarding professional training and licensing, as well as what types of insurance they have (for example, mold, air pollution or worker's compensation). It's fair to ask for the dollar amounts they are covered and a quality professional will show you verification of coverage.
The most recognized standards for HVAC design are based on ASHRAE data. The most general of four volumes of the ASHRAE Handbook is Fundamentals; it includes heating and cooling calculations. Each volume of the ASHRAE Handbook is updated every four years. The design professional must consult ASHRAE data for the standards of design and care as the typical building codes provide little to no information on HVAC design practices; codes such as the UMC and IMC do include much detail on installation requirements, however. Other useful reference materials include items from SMACNA, ACGIH, and technical trade journals.
The coil is usually made of copper tubing with aluminum fins, but some manufacturers use aluminum tubing. Its purpose is to transfer heat as rapidly as possible. Pressure inside the coil can exceed 400 psi. during extremely warm weather conditions. The cleaner it is kept, the better it transfers heat. Rinsing with a garden hose occasionally when the unit is not running will help keep it operating efficiently. After many years of use it may be necessary to put special chemicals on to clean it.

ISO 16813:2006 is one of the ISO building environment standards.[27] It establishes the general principles of building environment design. It takes into account the need to provide a healthy indoor environment for the occupants as well as the need to protect the environment for future generations and promote collaboration among the various parties involved in building environmental design for sustainability. ISO16813 is applicable to new construction and the retrofit of existing buildings.[28]


In the fall you should prepare your HVAC unit for winter. Turn off your air conditioner’s circuit, then hose it off to remove debris. It must dry completely. Do this when it’s warm enough that there’s no risk of the water freezing. Cover the exposed pipes with foam pipe insulation ($1-$3), and protect your entire unit with a weatherproof cover ($20-$50).
Alberto said they were busy but could either install on the upcoming Saturday.  We were going to be out of town and said unfortunately that day did not work.  He then proposed the upcoming Tuesday as a possible solution, but just had to confirm with another appointment.  I said great.  I will review the estimate and call your office to confirm I want to move forward with the install.

YP - The Real Yellow PagesSM - helps you find the right local businesses to meet your specific needs. Search results are sorted by a combination of factors to give you a set of choices in response to your search criteria. These factors are similar to those you might use to determine which business to select from a local Yellow Pages directory, including proximity to where you are searching, expertise in the specific services or products you need, and comprehensive business information to help evaluate a business's suitability for you. “Preferred” listings, or those with featured website buttons, indicate YP advertisers who directly provide information about their businesses to help consumers make more informed buying decisions. YP advertisers receive higher placement in the default ordering of search results and may appear in sponsored listings on the top, side, or bottom of the search results page.


Inside the unit, the air passes over the evaporator coil first, and is cooled and dehumidified. The now dehumidified, cold air then passes over the condenser coil where it is warmed up again. Then the air is released back into the room. The unit produces warm, dehumidified air and can usually be placed freely in the environment (room) that is to be conditioned.
Our company has been serving Woodbridge and the Northern Virginia region since 1979. We don’t compromise on quality — our team members pride themselves on providing the top-quality service each and every time. We attribute our success to the fact that we’re responsive to our customers’ needs, no matter if they’re residential or commercial, large or small. Whether you need routine maintenance or a complete system installation, our team of trained technicians is at your beck and call, and we’re prepared to deliver quality services and products at an affordable price. We live by the time-tested motto, “Do the job right the first time.”
Also, have an energy-efficiency professional come to your home and perform an energy assessment. This assessment could be either conducting a walk-through of your home with a clipboard or performing a thorough audit, pressurizing your home with a blower-door test to detect energy leaks. You may qualify for state discounts or rebates to have insulation installed in your home. Some utility companies also subsidize the cost of these energy efficiency assessments.
R22 (also known as HCFC-22) has a global warming potential about 1,800 times higher than CO2.[61] It was phased out for use in new equipment by 2010, and is to be completely discontinued by 2020. Although these gasses can be recycled when air conditioning units are disposed of, uncontrolled dumping and leaking can release gas directly into the atmosphere.
AC units and thermostats have built-in delay features when they’re shut down and then repowered. The delay can be as long as 10 minutes. And, if you’ve subscribed to an energy-saving device from your local power utility, the unit can take even longer to reset. If you’ve installed the parts shown and reinstalled the disconnect block, repowered the circuit breaker, turned on the switch at the furnace, moved the thermostat to AC mode and lowered the temperature below the indoor temperature, and the unit doesn’t fire up after 30 minutes, it’s time to call a pro.
×