Denver HVAC Repair

So HVAC sent Tony Diaz to my house. I was at work so he was subjected to the most excruciatingly exacting woman on the planet (my wife). Tony impressed her with his friendliness, professionalism and the obvious jouneyman-level knowledge of his craft. He found literally --burnt-out-- parts in our system and replaced them. It cost us a bit but I know enough about the parts to see there was no gouging on the parts and a fair rate for the labor. It wasn't cheap but it was fair and worth every dime.
HVAC professionals in the US can receive training through formal training institutions, where most earn associate degrees. Training for HVAC technicians includes classroom lectures and hands-on tasks, and can be followed by an apprenticeship wherein the recent graduate works alongside a professional HVAC technician for a temporary period.[29] HVAC techs who have been trained can also be certified in areas such as air conditioning, heat pumps, gas heating, and commercial refrigeration.[30]
Ventilation, air conditioning and heating systems require regular maintenance for them to work efficiently. You’ll likely need tune-ups and repairs for them at some point during their lifespan. However, no matter how much preventative maintenance you put into your HVAC system, there comes a time when repairs aren’t enough anymore and it’s time for a replacement.
“Robinson Air = top notch professionals. Mike was personable, knowledgeable, timely, thorough, and left me with a hard copy of prioritized recommendations and his explanations of HVAC needs I may have in the future. I was very impressed with being shown a tablet picture of a possible problem. It was so refreshing to have the service and all phone interactions handled so well and smoothly…thank you for taking the “angst” out of this kind of service call. My hat is off to you and I will happily recommend you to family and friends. Thank you!!!”

1/18/2014 Hi Jody M-  First, as you pointed out, we were the "Only" company to answer your phone call on the… Hi Jody M-  First, as you pointed out, we were the "Only" company to answer your phone call on the weekend & provide service for you on the same day. There is a premium for most any service company to come out afterhours or weekends, and being we are one of the very few companies to offer this service, a higher labor rate is understandable, after all, we have to pay our service persons an overtime rate for such calls.          


This company deserves more than five stars. They didn't just replace my heater and air conditioner, they built me a new system for my house. Going above and beyond is a understatement. Steve's staff were 2 of the nicest workers I've come across in a long time. Friendly, knowledgeable, and very clean. Truly a top rated company. Thanks Steve. Great job.
Focus first on sealing ducts that run through the attic, crawlspace, unheated basement, or garage. Use duct sealant (mastic) or metal-backed (foil) tape to seal the seams and connections of ducts. After sealing the ducts in those spaces, wrap them in insulation to keep them from getting hot in the summer or cold in the winter. Next, look to seal any other ducts that you can access in the heated or cooled part of the house. See our Duct Sealing Fact Sheet (787KB) for more information.
Modern air conditioning emerged from advances in chemistry during the 19th century, and the first large-scale electrical air conditioning was invented and used in 1902 by England inventor Willis Carrier. The introduction of residential air conditioning in the 1920s helped enable the great migration to the Sun Belt in the United States.[citation needed]
Some systems include an "economizer mode", which is sometimes called a "free-cooling mode". When economizing, the control system will open (fully or partially) the outside air damper and close (fully or partially) the return air damper. This will cause fresh, outside air to be supplied to the system. When the outside air is cooler than the demanded cool air, this will allow the demand to be met without using the mechanical supply of cooling (typically chilled water or a direct expansion "DX" unit), thus saving energy. The control system can compare the temperature of the outside air vs. return air, or it can compare the enthalpy of the air, as is frequently done in climates where humidity is more of an issue. In both cases, the outside air must be less energetic than the return air for the system to enter the economizer mode.
Allow our experts to help with any of your heating and cooling needs or questions. Our wide array of expertise and background will benefit you and your home, whether you are considering a replacement system or evaluating your whole system to check for areas of improvement. We can help you reach your optimum indoor comfort. Give us a ring at 866-397-3787 or request an appointment online.
×