Natural ventilation is the ventilation of a building with outside air without using fans or other mechanical systems. It can be via operable windows, louvers, or trickle vents when spaces are small and the architecture permits. In more complex schemes, warm air is allowed to rise and flow out high building openings to the outside (stack effect), causing cool outside air to be drawn into low building openings. Natural ventilation schemes can use very little energy, but care must be taken to ensure comfort. In warm or humid climates, maintaining thermal comfort solely via natural ventilation might not be possible. Air conditioning systems are used, either as backups or supplements. Air-side economizers also use outside air to condition spaces, but do so using fans, ducts, dampers, and control systems to introduce and distribute cool outdoor air when appropriate.
The customer service person on the phone was very pleasant. About an hour later a technician arrived even though it was 9pm at night. The technician seemed very experienced and thorough. He found the problem right away, but spent additional time looking over the entire system to make sure nothing else was causing other problems. He then explained the repair and gave me the price to make the repair, and asked for approval before moving ahead with the repair. The price was very reasonable, and it was repaired within an hour. I highly recommend AND Services!
Modern air conditioning systems are not designed to draw air into the room from the outside, they only recirculate the increasingly cool air on the inside. Because this inside air always has some amount of moisture suspended in it, the cooling portion of the process always causes ambient warm water vapor to condense on the cooling coils and to drip from them down onto a catch tray at the bottom of the unit from which it must then be routed outside, usually through a drain hole. As this moisture has no dissolved minerals in it, it will not cause mineral buildup on the coils. This will happen even if the ambient humidity level is low. If ice begins to form on the evaporative fins, it will reduce circulation efficiency and cause the development of more ice, etc. A clean and strong circulatory fan can help prevent this, as will raising the target cool temperature of the unit's thermostat to a point that the compressor is allowed to turn off occasionally. A failing thermistor may also cause this problem. Refrigerators without a defrost cycle may have this same issue. Dust can also cause the fins to begin blocking air flow with the same undesirable result: ice.
AC air handler squealing or grinding noises. Though most air handlers have direct-drive motors, some older units may be belt-driven. Squealing sounds from a belt-drive air handler generally occur when the belt that connects the motor to the blower slips. In most cases, the belt is improperly aligned or worn and needs replacement. Follow the instructions above under Air Conditioner Not Blowing Air and refer to your owner’s manual.
When it comes to your indoor winter comfort, you should never settle. A perfectly warm home is important to your daily life, and the performance of your heating system impacts the safety, air quality, and cost of keeping an enjoyable home. Sky Heating & Air Conditioning protects your ongoing satisfaction with a diverse range of quality heating products and services, including new system installation, replacement, seasonal maintenance, and repair. We work to improve efficiency, reliability, and safety, and deliver corner to corner temperature control throughout the rooms of your home. With 24/7 Emergency Services, you’re never left out in the cold. Contact Sky Heating & Air Conditioning for heating service in The Dalles and Portland, OR, and we’ll provide the exemplary customer service that sets us apart.
If your AC doesn’t turn off when room temperature reaches the temperature set on the thermostat, the problem is generally occurring either at the thermostat or in the electrical system that runs the outside condensing unit. You can use the AC’s circuit breaker to shut off the unit, but that should not be a permanent solution—circuit breakers are not designed to be used like light switches.
When we’re in a customer’s home, we’re always on the lookout for things we can do to help them out and put a smile on their face. It could be as simple as changing a lightbulb or as involved as cleaning gutters, listing a car for sale online, or repairing a broken gate. There’s no limit to what we might do, and of course, there’s never any charge to help out. It’s good deeds for FREE!
An HVAC service contract can be a very cost-effective way to make sure your system is properly maintained and to have someone on call when things go wrong. Depending on the amount of services offered, they cost between $150 and $500 per year, but they often include yearly inspections of both your furnace and A/C, discounts on major repairs, and preferred scheduling status when you have problems during the busy season.
If your air ducts have been damaged, you’ll need to replace them. The national average air duct replacement cost is $150-$280, which may not include materials. Factors such as duct material, labor, location of ducts and linear feet of ductwork will all affect your final costs. Labor costs will vary based on how accessible the ducts are and what material your ducts are made of. The least expensive duct material is a flexible, non-metallic ducting that costs approximately $1-$2 per linear foot. Flexible aluminum is generally more expensive and stronger than non-metallic ducting. Stainless steel ducting is the strongest, the least flexible (meaning installing it typically has higher labor rates), and usually the most expensive. An average price for air duct replacement could range between $35 and $55 per linear foot, including basic materials and labor. A typical single-family home has 6-10 duct runs; replacing or installing one duct run could average $150-$250 for labor.
Advantages of the ductless system include smaller size and flexibility for zoning or heating and cooling individual rooms. The inside wall space required is significantly reduced. Also, the compressor and heat exchanger can be located farther away from the inside space, rather than merely on the other side of the same unit as in a PTAC or window air conditioner. Flexible exterior hoses lead from the outside unit to the interior one(s); these are often enclosed with metal to look like common drainpipes from the roof. In addition, ductless systems offer higher efficiency, reaching above 30 SEER.
Inside the unit, the air passes over the evaporator coil first, and is cooled and dehumidified. The now dehumidified, cold air then passes over the condenser coil where it is warmed up again. Then the air is released back into the room. The unit produces warm, dehumidified air and can usually be placed freely in the environment (room) that is to be conditioned.
You can keep your air conditioner running efficiently with some preventative care measures. Shut off the power to your AC before cleaning it or performing any of these tasks: clean your filter at least twice a year; remove leaves and twigs from cages; clean the fins with a garden hose or special spray, then use a butter knife to straighten any that are crooked; keep your yard clean so the fins won't get blocked; cover the unit up for winter; and make sure it's level or you run the risk of damaging the inner workings of the unit.
Good Evening HVAC Team, I deeply appreciate your team for getting back to me quickly yesterday evening so I could schedule an appointment for my gf's place(definitely something has been wrong for a while)-- The technician Alberto showed up within the 2 hour window that was appointed to us (WITHIN the 1st half hour!!!). BIG THANK YOU for being honest, and advising us that for some reason the fuse/switch was in the reverse position so the AC unit would not properly turn on. The unit turned back on immediately, and began cooling the house. And then providing advice that the AC/Heating system needed some TLC, and giving us options to save money by purchasing a maintenance plan that included the filters plus cleaning services since we were already being charged for the service today. My personal thanks for being extremely professional, and personable as you entered our home. Solving the technical issue is only part of the job, but providing great Customer Service, and Cost Effective solutions are reasons to recommend you to the people who are looking for the same type of service. Also, it was very convenient that you were able to take my payment over the Phone(FaceTime) since I was not present at the time. Your company website is well organized, and I had no problem reviewing your capabilities as well as how to contact your team. Most important, Tina spoke very highly of you, and made her feel comfortable through the process. SO BOTTOM LINE to other customers looking for HVAC service: LOOK NO FURTHER!!! If you have a AC/Heater Issue, give this the HVAC company a call, or email-- You won't be disappointed. Kind Regards, Michael
Are you considering whether you need to replace your home’s central heating, ventilation, and air conditioning unit—commonly known as your HVAC system? As a general rule, if your existing HVAC system is more than 15 years old, it’s only a matter of time before it starts to cost more to maintain than it would to replace it with a new system. In addition to higher energy bills brought on by a system that can no longer function at peak efficiency, repair costs will also start to add up as parts are replaced and the ventilation system undergoes major overhauls.
The time it takes to install an AC unit and the associated cost depends on the square footage of your home. Many homeowners spend between $3,677 to $7,151 for a contractor to put in a new central air system.A family with a 2,000-square-foot house that already has a forced-air heating unit can expect to pay $3,500 to $4,000 for a cooling system. If technicians don't need to make any changes to the duct-work, then the project should take them an average of two to three days.
Our technicians have experience repairing furnaces and will make sure your home is back to keeping your family cozy in no time. From training and certifications to our reputation for doing the job right time and time again, you can trust that James Heating & A/C, Inc’s furnace repair technicians will have your troubles taken care of and your furnace operating smoothly. Whether it’s emergency furnace repair or service you can schedule a little in advance, our team can give you peace of mind, knowing that your furnace is in good hands. Are you in need of a furnace repair? When performing a repair, it's important to hire professional HVAC contractors.
No one wants to be stuck in the dead of summer with a broken air conditioner, or in the cold of winter with a broken furnace or boiler. That’s why we’re available any time of day to make your emergency heating and air conditioning repair and get your system up and running as quickly as possible. We’ll show up on time, in uniform and ready to make your HVAC repair right the first time.