Denver HVAC Repair

The cost of service varies widely from one region to the next so it is next to impossible to give you prices for air conditioning service. The best way to check prices is to shop around. Be aware though that sometimes the cheapest price for HVAC air conditioning and heating service and repair is not always the best way to go. Your main concern should be getting knowledgeable HVAC service technicians, reliability, punctuality, honesty, integrity, and guaranteed work.
The first air conditioners and refrigerators employed toxic or flammable gases, such as ammonia, methyl chloride, or propane, that could result in fatal accidents when they leaked. Thomas Midgley, Jr. created the first non-flammable, non-toxic chlorofluorocarbon gas, Freon, in 1928. The name is a trademark name owned by DuPont for any chlorofluorocarbon (CFC), hydrochlorofluorocarbon (HCFC), or hydrofluorocarbon (HFC) refrigerant. The refrigerant names include a number indicating the molecular composition (e.g., R-11, R-12, R-22, R-134A). The blend most used in direct-expansion home and building comfort cooling is an HCFC known as chlorodifluoromethane (R-22).
It can be hard to make the decision to replace or repair your AC unit. However, in many cases, homeowners call in HVAC professionals to check their units and provide a second opinion. A technician can tell you if there’s plenty of life left in your old air conditioning unit or that it’s time to let it go and get a new one. Your HVAC technician may check out your home’s insulation quality, too. You could increase your system’s effectiveness by improving the insulation.
Most modern air-conditioning systems feature a dehumidification cycle during which the compressor runs while the fan is slowed as much as possible[citation needed] to reduce the evaporator temperature and therefore condense more water. When the temperature falls below a threshold, both the fan and compressor are shut off to mitigate further temperature drops;[clarification needed] this prevents moisture on the evaporator from being blown back into the room.[citation needed] When the temperature rises again,[clarification needed] the compressor restarts and the fan returns to low speed.

Hospital operating theatres, in which air is filtered to high levels to reduce infection risk and the humidity controlled to limit patient dehydration. Although temperatures are often in the comfort range, some specialist procedures, such as open heart surgery, require low temperatures (about 18 °C, 64 °F) and others, such as neonatal, relatively high temperatures (about 28 °C, 82 °F).


ISO 16813:2006 is one of the ISO building environment standards.[27] It establishes the general principles of building environment design. It takes into account the need to provide a healthy indoor environment for the occupants as well as the need to protect the environment for future generations and promote collaboration among the various parties involved in building environmental design for sustainability. ISO16813 is applicable to new construction and the retrofit of existing buildings.[28]
Check that the 240-volt circuit breaker (double-pole breaker) controlling the air-conditioning compressor/condensing unit and the 120-volt circuit breaker controlling the furnace blower or separate air handler, is in the "On" positions. If a circuit breaker has tripped or a fuse is blown, then reset the circuit breaker or replace the fuse. If you reset the breaker or replace the fuse and they trip or blow again, stop and call an air-conditioning service technician, as you may have a more serious problem.
SEER is related to the coefficient of performance (COP) commonly used in thermodynamics and also to the Energy Efficiency Ratio (EER). The EER is the efficiency rating for the equipment at a particular pair of external and internal temperatures, while SEER is calculated over a whole range of external temperatures (i.e., the temperature distribution for the geographical location of the SEER test). SEER is unusual in that it is composed of an Imperial unit divided by an SI unit. The COP is a ratio with the same metric units of energy (joules) in both the numerator and denominator. They cancel out, leaving a dimensionless quantity. Formulas for the approximate conversion between SEER and EER or COP are available.[34]
Per hour service charges are not the only way companies charge their customers. There are also service companies that flat rate their services. Either way, you pay, you want the service and troubleshooting done in a quick and efficient manner with a guarantee. Do your research before selecting a company to provide reliable, honest service to your home. If you know what the problem is then the company can likely give you an estimate over the phone. Some will while some do not. Why? Because they likely want to verify the problem to make sure it is a correct assessment. It can be a complex issue and what you think it is it may not be the problem. So you can expect to pay for a service call and troubleshooting charge. Most HVAC service companies do not give free estimates on repairs.

In 1906, Stuart W. Cramer of Charlotte was exploring ways to add moisture to the air in his textile mill. Cramer coined the term "air conditioning", using it in a patent claim he filed that year as an analogue to "water conditioning", then a well-known process for making textiles easier to process. He combined moisture with ventilation to "condition" and change the air in the factories, controlling the humidity so necessary in textile plants. Willis Carrier adopted the term and incorporated it into the name of his company.[10]
I'm very glad that I found another guy to come replace the circuit board and put it away from the water, fix the water leak, and also find and fix another impending failure.  All of that was for much less than HVAC Service wanted to charge for repair or replacement. The other guy did a great repair, so I'm confident it will not break down again, but if it does, I will not call HVAC Service. Don't get suckered by their Yelp Deal.

An air conditioner’s cooling process produces condensation, which normally flows away from the equipment, causing no problem. If there is a clog in the condensate drain lines or drip pan, or if outdoor humidity levels are high, moisture may back up into your air conditioner. Excess condensation will increase indoor humidity levels and hinder the air conditioner’s performance. It could also cause damage to your air conditioner’s components.
Modern air conditioning systems are not designed to draw air into the room from the outside, they only recirculate the increasingly cool air on the inside. Because this inside air always has some amount of moisture suspended in it, the cooling portion of the process always causes ambient warm water vapor to condense on the cooling coils and to drip from them down onto a catch tray at the bottom of the unit from which it must then be routed outside, usually through a drain hole. As this moisture has no dissolved minerals in it, it will not cause mineral buildup on the coils. This will happen even if the ambient humidity level is low. If ice begins to form on the evaporative fins, it will reduce circulation efficiency and cause the development of more ice, etc. A clean and strong circulatory fan can help prevent this, as will raising the target cool temperature of the unit's thermostat to a point that the compressor is allowed to turn off occasionally. A failing thermistor may also cause this problem. Refrigerators without a defrost cycle may have this same issue. Dust can also cause the fins to begin blocking air flow with the same undesirable result: ice.

From Day 1, Alberto walked us through the process, and present us with a variety of options based our budget for the project. His customer service is the best as he did not oversell any services and did not nudge us towards buying a unit that would stretch our budget. On installation day, HVAC Services sent out a crew of 6-7 guys, all of whom were very polite and kept their work areas clean, and installed the whole system the same day.

Restoring or replacing an aging unit can get expensive. Invest in a new model if your utility bills are rising and you notice uneven air flow and temperatures throughout your property. If one room is cooler than another, consider a total replacement. If the air conditioner is relatively new and still within its age range, it's more cost-effective to get a contractor to repair it.
A heating, ventilation and air conditioning (HVAC) service technician starts an appointment with a customer by asking about any problems with the heating, ventilation, and/or air conditioning systems in the client's home or business. From there, the technician will carefully examine the equipment in question to diagnose and troubleshoot the problem. Once the issue is determined, the technician provides the customer with a repair quote and, if authorized, begins to repair or replace defective equipment, mechanical components, or wiring in HVAC systems. An HVAC service technician might also be called upon by a customer to carry out preventative maintenance tasks or inspections to ensure that heating, ventilation, and air conditioning systems continue to run smoothly. A technician should have certification or an associate's degree from a technical or trade school that is accredited by HVAC Excellence, the National Center for Construction Education and Research, or the Partnership for Air Conditioning, Heating, and Refrigeration Accreditation. Formal training programs can last anywhere from six months up to two years. The job involves working with electrical equipment, so it is very important that a technician know exactly what he or she is doing or the job can get very dangerous very quickly. If an education is not in the picture, it is sometimes possible to go through a formal apprenticeship program which can take three to five years and mixes on-the-job experience and training with classroom instruction. Exams for certifications are offered by a number of associations. A license to work as an HVAC technician is required in several states and can be obtained by passing a written test. (Copyright 2018 PayScale.com)
If your air conditioner isn’t cooling, or is experiencing another performance issue, shut it off. Don’t continue to operate a malfunctioning air conditioner, as that may worsen the problem at hand. This is one reason we do preventative maintenance checks pre-season – a technician identifies and corrects problems, so you don’t run your system with faulty components, causing more damage.
Good Evening HVAC Team, I deeply appreciate your team for getting back to me quickly yesterday evening so I could schedule an appointment for my gf's place(definitely something has been wrong for a while)-- The technician Alberto showed up within the 2 hour window that was appointed to us (WITHIN the 1st half hour!!!). BIG THANK YOU for being honest, and advising us that for some reason the fuse/switch was in the reverse position so the AC unit would not properly turn on. The unit turned back on immediately, and began cooling the house. And then providing advice that the AC/Heating system needed some TLC, and giving us options to save money by purchasing a maintenance plan that included the filters plus cleaning services since we were already being charged for the service today. My personal thanks for being extremely professional, and personable as you entered our home. Solving the technical issue is only part of the job, but providing great Customer Service, and Cost Effective solutions are reasons to recommend you to the people who are looking for the same type of service. Also, it was very convenient that you were able to take my payment over the Phone(FaceTime) since I was not present at the time. Your company website is well organized, and I had no problem reviewing your capabilities as well as how to contact your team. Most important, Tina spoke very highly of you, and made her feel comfortable through the process. SO BOTTOM LINE to other customers looking for HVAC service: LOOK NO FURTHER!!! If you have a AC/Heater Issue, give this the HVAC company a call, or email-- You won't be disappointed. Kind Regards, Michael
I have no idea what a barrel is??? In chilled water systems the evaporator and condensers sometimes use what is called a chiller barrel for the evaporator and/or the condenser but for most residential system it is a rarity to find a chilled water system installed. Are you talking about a commercial system chiller. 7.1 KW is not a very big system but they do exist in light commercial and as mentioned in residential.
Excalibur Water Systems helps solve the water challenges around the globe with water solutions for any possible water concerns in: water hardness, filtration of any contaminant, bacteria removal and high purity water needs and also comes with a warranty of up to 20 years at no extra cost. The best warranty for the water treatment equipment industry.
Are you considering whether you need to replace your home’s central heating, ventilation, and air conditioning unit—commonly known as your HVAC system? As a general rule, if your existing HVAC system is more than 15 years old, it’s only a matter of time before it starts to cost more to maintain than it would to replace it with a new system. In addition to higher energy bills brought on by a system that can no longer function at peak efficiency, repair costs will also start to add up as parts are replaced and the ventilation system undergoes major overhauls.
If the condenser coils are clogged, the compressor can overheat and shut down. You’ll experience intermittent periods of minimal cooling, followed by no cooling. Even if you’re “sure” the condenser coils are clean, clean them again. Turn off the power. Flip the air conditioning service and furnace circuit breakers in your main electrical panel to the “Off” position. Next, turn off the power switch right at the furnace or air handler. Then yank the disconnect block (Photo 1) and clean the condenser coils (Photo 2). If the air conditioning service still doesn’t work properly after you’ve cleaned the condenser coils, installed a new filter and opened all the supply vents, proceed with the following repairs.
×