Denver HVAC Repair

I have a recurring problem of having to have freon added to my A/C system. I have even replaced both units inside and outside but seem to have the same problem. I believe that it must be in the lines between the outside and inside. Is there anything that can be put into the lines to seal any leaks if this is the problem? If not is it advised that the lines be replaced?
1/27/2015 Melissa, we are committed to providing the highest level of service and would like to hear more… Melissa, we are committed to providing the highest level of service and would like to hear more about your personal situation. Please email steve, our Customer Relations Specialist at [email protected] or give him a call at 925-318-4795.  Hopefully, you will give us the opportunity to make this right. Read more
Excalibur Water Systems helps solve the water challenges around the globe with water solutions for any possible water concerns in: water hardness, filtration of any contaminant, bacteria removal and high purity water needs and also comes with a warranty of up to 20 years at no extra cost. The best warranty for the water treatment equipment industry.
Modern air conditioning systems are not designed to draw air into the room from the outside, they only recirculate the increasingly cool air on the inside. Because this inside air always has some amount of moisture suspended in it, the cooling portion of the process always causes ambient warm water vapor to condense on the cooling coils and to drip from them down onto a catch tray at the bottom of the unit from which it must then be routed outside, usually through a drain hole. As this moisture has no dissolved minerals in it, it will not cause mineral buildup on the coils. This will happen even if the ambient humidity level is low. If ice begins to form on the evaporative fins, it will reduce circulation efficiency and cause the development of more ice, etc. A clean and strong circulatory fan can help prevent this, as will raising the target cool temperature of the unit's thermostat to a point that the compressor is allowed to turn off occasionally. A failing thermistor may also cause this problem. Refrigerators without a defrost cycle may have this same issue. Dust can also cause the fins to begin blocking air flow with the same undesirable result: ice.
We’re here to make your life a lot less hectic, and a lot more productive. As a local HVAC and Mechanical Contractor, MacDonald-Miller is committed to delivering true peace of mind. We perform regular inspections and maintenance of your building systems to ensure a greater level of operational excellence. We test, align, calibrate, and record performance to ensure your building’s equipment quality and reduce downtime or emergencies. When it comes to dedicated HVAC service & maintenance, MacDonald-Miller is unmatched.
At BGE HOME, our customers trust our courteous and knowledgeable technicians to repair the most sophisticated heating and air conditioning system breakdowns. Every BGE HOME technician is licensed in their trade and adheres to a stringent in-house certification program that guarantees their knowledge, affirms their commitment to the customer, and ensures excellence in completing every heating and air conditioning repair with the highest level of quality.
The content of this blog is intended for informational purposes only. Renovate America provides no endorsement and makes no representations as to accuracy, reliability, completeness, suitability or validity of any information or content on, distributed through or linked, downloaded or accessed from this site. This blog is subject to the additional terms found at https://www.renovateamerica.com/blog-disclaimer.
The basic concept behind air conditioning is said to have been applied in ancient Egypt, where reeds were hung in windows and were moistened with trickling water. The evaporation of water cooled the air blowing through the window. This process also made the air more humid, which can be beneficial in a dry desert climate. In ancient Rome, water from aqueducts was circulated through the walls of certain houses to cool them. Other techniques in medieval Persia involved the use of cisterns and wind towers to cool buildings during the hot season.[5]

So HVAC sent Tony Diaz to my house. I was at work so he was subjected to the most excruciatingly exacting woman on the planet (my wife). Tony impressed her with his friendliness, professionalism and the obvious jouneyman-level knowledge of his craft. He found literally --burnt-out-- parts in our system and replaced them. It cost us a bit but I know enough about the parts to see there was no gouging on the parts and a fair rate for the labor. It wasn't cheap but it was fair and worth every dime.
At Reliable Comfort Heating & Air Conditioning, we combine skilled workmanship with dedicated customer service to earn your complete satisfaction.  Whether you are in need of new HVAC installation, replacement, maintenance, repair, air quality solutions, or duct sealing, we draw from extensive hands-on experience, quality products, and advanced training to maximize value and rewards.
ABM (NYSE: ABM) is a leading provider of facility solutions with revenues of approximately $5.5 billion and more than 130,000 employees in 350+ offices throughout the United States and various international locations. ABM's comprehensive capabilities include janitorial, electrical & lighting, energy solutions, facilities engineering, HVAC & mechanical, landscape & turf, mission critical solutions and parking, provided through stand-alone or integrated solutions. ABM provides custom facility solutions in urban, suburban and rural areas to properties of all sizes - from schools and commercial buildings to hospitals, data centers, manufacturing plants and airports. ABM Industries Incorporated, which operates through its subsidiaries, was founded in 1909. For more information, visit www.abm.com.

It doesn’t matter the time, our experts will have your home back to complete comfort swiftly. We back our workmanship so much so that we guarantee it in writing for one full year. Our 100% Satisfaction Guarantee* firmly demonstrates our dedication to providing the best heating system service in the industry. Repairing, selling and installing heating systems is something we do every day. More people count on us for their home comfort, so you can be certain your home will be back to being warm and cozy in no time.
When you schedule air conditioning and heating maintenance with The Home Depot, one of our local, licensed, and insured service providers will come to your house and perform a 28-point inspection on your units. Scheduling two seasonal heating and cooling services per year with The Home Depot is a worthwhile investment that can help identify and fix small issues before they lead to bigger, more expensive repairs.

An air conditioner's filters, coils, and fins require regular maintenance for the unit to function effectively and efficiently throughout its years of service. Neglecting necessary maintenance ensures a steady decline in air conditioning performance while energy use steadily increases. Check out our Energy Saver 101 Infographic: Home Cooling for more ways to help improve your comfort and the efficiency of your air conditioner.
Replacing a capacitor is easy. Just take a photo of the wires before disconnecting anything (you may need a reference later on). Then discharge the stored energy in the old capacitor (Photo 4). Use needle-nose pliers to pluck one wire at a time from the old capacitor and snap it onto the corresponding tab of the new capacitor. The female crimp connectors should snap tightly onto the capacitor tabs. Wiggle each connector to see if it’s tight. If it’s not, remove the connector and bend the rounded edges of it so it makes a tighter fit on the tab. When you’ve swapped all the wires, secure the new capacitor (Photo 5).
×