Denver HVAC Repair

No matter where you bought your air conditioning system, we can repair it. We have years of experience working with all the best central air conditioner brands such as Kenmore, Carrier. Trane, Goodman, and Rheem. As a result, you can rest assured we’re familiar with your air conditioning system and we have the parts you need to complete a successful air conditioner repair.
Your heating and cooling equipment is vital to your comfort and breakdowns can be stressful, inconvenient and even dangerous. You can rely on the professionals at One Hour Heating and Air Conditioning* for expert service when you need it most. Our highly-trained technicians are available around the clock to meet your heating and cooling needs. We'll install, repair and maintain your HVAC system, keeping it in peak condition. Give us a call when you need to:
Air changes per hour Bake-out Building envelope Convection Dilution Domestic energy consumption Enthalpy Fluid dynamics Gas compressor Heat pump and refrigeration cycle Heat transfer Humidity Infiltration Latent heat Noise control Outgassing Particulates Psychrometrics Sensible heat Stack effect Thermal comfort Thermal destratification Thermal mass Thermodynamics Vapour pressure of water

Inside the unit, the air passes over the evaporator coil first, and is cooled and dehumidified. The now dehumidified, cold air then passes over the condenser coil where it is warmed up again. Then the air is released back into the room. The unit produces warm, dehumidified air and can usually be placed freely in the environment (room) that is to be conditioned.

In variable climates, the system may include a reversing valve that switches from heating in winter to cooling in summer. By reversing the flow of refrigerant, the heat pump refrigeration cycle is changed from cooling to heating or vice versa. This allows a facility to be heated and cooled by a single piece of equipment by the same means, and with the same hardware.
If your AC doesn’t turn off when room temperature reaches the temperature set on the thermostat, the problem is generally occurring either at the thermostat or in the electrical system that runs the outside condensing unit. You can use the AC’s circuit breaker to shut off the unit, but that should not be a permanent solution—circuit breakers are not designed to be used like light switches.
You can count on our analysis of your home’s plumbing, air conditioning & electrical problems as well as our recommendations for installation, and maintenance. We provide state-of-the-art equipment, so all jobs are performed professionally and efficiently. To schedule an appointment with some of the best Houston area plumbers, electricians or air conditioning repair and installation experts, call 713-766-3605713-766-3605.
With our wide range of expert services, affordable pricing, and customer dedication, we are certain to satisfy. This is all to ensure you only need to keep one number in mind for all your heating and cooling solutions. That number is 630-723-7716! Contact us today for new design/installation, replacement, seasonal maintenance, and/or prompt repair of furnaces, boilers, central air conditioners, ductless systems and so much more. After more than thirty years in business, Apex Energy, Inc. knows how to treat you right.
There is nothing worse than having your air conditioner break in the middle of a long, hot summer. You can ensure your air conditioning unit stays in working order all year long with regular service. Sometimes, however, repairs are necessary whether it’s fixing the evaporator, capacitor, or condenser or recharging the refrigerant. Most air conditioner repairs cost between $163 and $528 with most homeowners reporting that they spend about $344. If you do need a repair, here is some information to help you get it done quickly, professionally, and economically.
Refrigeration air conditioning equipment usually reduces the absolute humidity of the air processed by the system. The relatively cold (below the dewpoint) evaporator coil condenses water vapor from the processed air, much like an ice-cold drink will condense water on the outside of a glass. Therefore, water vapor is removed from the cooled air and the relative humidity in the room is lowered. The water is usually sent to a drain or may simply drip onto the ground outdoors. The heat is rejected by the condenser which is located outside of room to be cooled.
If you hear clicking that is followed by a hum or buzz, you’re probably hearing the fan motor attempting to start without the boost it needs from the capacitor. You can almost always conclude that the capacitor has failed. Sometimes you can get the compressor fan spinning (clockwise) by pushing it with a thin stick or long screwdriver poked through the grille. But the chances are good that this might work for one cycle, but the capacitor will fail next time the AC goes on. It’s best to replace the capacitor.

In 1992, a non-governmental organization, Greenpeace, was spurred by corporate executive policies and requested that a European lab find substitute refrigerants. This led to two alternatives, one a blend of propane (R290) and isobutane (R600a), and one of pure isobutane.[18][22] Industry resisted change in Europe until 1993, and in the U.S. until 2011, despite some supportive steps in 2004 and 2008 (see Refrigerant Development above).[27][67]
In the fall you should prepare your HVAC unit for winter. Turn off your air conditioner’s circuit, then hose it off to remove debris. It must dry completely. Do this when it’s warm enough that there’s no risk of the water freezing. Cover the exposed pipes with foam pipe insulation ($1-$3), and protect your entire unit with a weatherproof cover ($20-$50).
Our company has been serving Woodbridge and the Northern Virginia region since 1979. We don’t compromise on quality — our team members pride themselves on providing the top-quality service each and every time. We attribute our success to the fact that we’re responsive to our customers’ needs, no matter if they’re residential or commercial, large or small. Whether you need routine maintenance or a complete system installation, our team of trained technicians is at your beck and call, and we’re prepared to deliver quality services and products at an affordable price. We live by the time-tested motto, “Do the job right the first time.”
The content of this blog is intended for informational purposes only. Renovate America provides no endorsement and makes no representations as to accuracy, reliability, completeness, suitability or validity of any information or content on, distributed through or linked, downloaded or accessed from this site. This blog is subject to the additional terms found at https://www.renovateamerica.com/blog-disclaimer.
The air conditioner's evaporator coil and condenser coil collect dirt over their months and years of service. A clean filter prevents the evaporator coil from soiling quickly. In time, however, the evaporator coil will still collect dirt. This dirt reduces airflow and insulates the coil, reducing its ability to absorb heat. To avoid this problem, check your evaporator coil every year and clean it as necessary.
Other InformationCost to install a bathroom medicine cabinetCost to install a basement windowCost to install a bifold doorCost to install a door frameCost to install a bay windowCost to hang a prehung doorCost to install a door knobCost to install a door jambCost to install a bathtubCost to install a faucetCost to install a bidetCost to hang wallpaper

If you believe that the ac not working or you’re getting little or no cold air, check these three things first. Make sure all the registers in the house are wide open. Then be sure the furnace filter is clean. Then go outside and clean off the condenser coils (Photo 2). If several registers were closed or the filter was clogged, the reduced airflow could have caused the evaporator coil to ice up and stop cooling your home. If you’ve changed the filter and opened all the registers and you’re still not getting airflow at the registers, deice the A-coil. Move the thermostat mode switch from “Cooling” to “Off” and move the fan switch from “Auto” to “On.” Let the blower run for at least 30 minutes or until there’s good airflow at the registers. Then turn the AC back on to test it. If it works for the next 12 hours, you’ve solved the problem.
×