Denver HVAC Repair

SEER is related to the coefficient of performance (COP) commonly used in thermodynamics and also to the Energy Efficiency Ratio (EER). The EER is the efficiency rating for the equipment at a particular pair of external and internal temperatures, while SEER is calculated over a whole range of external temperatures (i.e., the temperature distribution for the geographical location of the SEER test). SEER is unusual in that it is composed of an Imperial unit divided by an SI unit. The COP is a ratio with the same metric units of energy (joules) in both the numerator and denominator. They cancel out, leaving a dimensionless quantity. Formulas for the approximate conversion between SEER and EER or COP are available.[34]

Our goal is to make you more comfortable in your home. When your furnace, central air conditioner, heat pump or boiler stops working and you need service, call the professionals at BGE HOME. Heating and cooling system breakdowns occur at the most inconvenient times, so rely on our certified, skilled technicians to make the repair quickly and correctly the first time.


Eventually, every homeowner experiences a malfunction in their heating unit. It’s a cold morning and you hike the thermostat up like you usually do to take the chill off, but you get no response. You don’t hear the system firing up or feel the radiators or air vents producing any heat. You hope it’s just a quick fix, like a clogged filter or a tripped circuit breaker. On the other hand, you might be wondering if it’s more cost-effective to just have the unit replaced.
If your air conditioner isn’t cooling, or is experiencing another performance issue, shut it off. Don’t continue to operate a malfunctioning air conditioner, as that may worsen the problem at hand. This is one reason we do preventative maintenance checks pre-season – a technician identifies and corrects problems, so you don’t run your system with faulty components, causing more damage.
They were quick to come out and diagnose the problem with my furnace, but I thought the estimate of $549 a bit high to replace the circuit board.  So called around and found Leo's Appliance in Concord that sells appliance parts and the circuit board was only $90.49 - that is the retail cost to me, so I imagine the wholesale cost is a lot less.  So BEWARE of this company since they wanted $500!!! to replace the circuit board which is located right in the front of the furnace - extremely easy to access.  I hate it that you cannot trust repair companies.
Are you considering whether you need to replace your home’s central heating, ventilation, and air conditioning unit—commonly known as your HVAC system? As a general rule, if your existing HVAC system is more than 15 years old, it’s only a matter of time before it starts to cost more to maintain than it would to replace it with a new system. In addition to higher energy bills brought on by a system that can no longer function at peak efficiency, repair costs will also start to add up as parts are replaced and the ventilation system undergoes major overhauls.

Replacing your old heating and cooling equipment with new, energy-efficient models is a great start. But to make sure that you get the best performance, the new equipment must be properly installed. In fact, improper installation can reduce system efficiency by up to 30 percent - costing you more on your utility bills and possibly shortening the equipment's life. Learn more.
In addition to the information below, see these two articles for the general care and maintenance of your air conditioner: Preparing Your Air Conditioner for Summer and How to Replace Furnace & AC Filters. Most noteworthy, you should replace the filters at least twice a year, before the heating and cooling seasons. For information on furnace problems, please see Furnace Not Working.
Consequently, this water must exit the air handler—typically through plastic pipe or a drain tube. That drain tube goes directly outside, often terminating near the compressor, or to a floor drain or to a small electric “condensate pump” located by the air handler. Where a condensate pump is used, it connects to a 1/2-inch vinyl or rubber tube that exits outdoors or to a drain.
We are service professionals! As licensed contractors and specialists in the field of heating and air conditioning, we have the tools, the equipment, and the experience to keep your equipment running smoothly all year long. If it is emergency service that you need, we are available to assist you! To help reduce service emergencies, we offer service agreements to keep your comfort system running at peak performance.
All modern air conditioning systems, even small window package units, are equipped with internal air filters. These are generally of a lightweight gauzy material, and must be replaced or washed as conditions warrant. For example, a building in a high dust environment, or a home with furry pets, will need to have the filters changed more often than buildings without these dirt loads. Failure to replace these filters as needed will contribute to a lower heat exchange rate, resulting in wasted energy, shortened equipment life, and higher energy bills; low air flow can result in iced-over evaporator coils, which can completely stop air flow. Additionally, very dirty or plugged filters can cause overheating during a heating cycle, and can result in damage to the system or even fire.
The federal government is phasing out Freon to conserve energy across the nation. Because of this, Freon costs are increasing significantly. If your AC unit uses Freon, eventually you’ll need to replace it to make the switch to the new R410A refrigerant. It’s most likely a good time to consider a replacement if your unit is breaking down or has problems associated with needing more Freon.
You’re constantly repairing your HVAC: If your heating and cooling system has needed repairs more than once or twice in the past few years, it may be time to take the leap with a replacement system. The money you spend repairing older equipment can often be better used towards the purchase of newer, energy-efficient HVAC systems. Here’s a simple guide: If your labor and parts cost upwards of $1,000, look toward replacement. 
Air flow meter Aquastat BACnet Blower door Building automation Carbon dioxide sensor Clean Air Delivery Rate (CADR) Gas sensor Home energy monitor Humidistat HVAC control system Intelligent buildings LonWorks Minimum efficiency reporting value (MERV) OpenTherm Programmable communicating thermostat Programmable thermostat Psychrometrics Room temperature Smart thermostat Thermostat Thermostatic radiator valve
If the AC doesn’t turn off, it may be time to clean the condensing unit. Dirty condenser coils won’t give off heat efficiently and will keep the unit running.  Another possibility: The contacts on the outdoor run relay may have welded together—something that can happen over time because of frequent electrical arcing at the relay. Before checking the run relay, turn off the power to the furnace and the condensing unit. Next, disassemble the relay and pry apart the contacts. This should do the trick until you buy a replacement—which you should do soon.
As you would expect, air conditioning in Portland isn't as expensive as in most areas of the country, owing simply to the fact that most homes don't require particularly large or state-of-the-art units. While our data suggests the national average for air conditioning installation is about $6,000, in Portland we see numbers between $3,000-$4,000, although we've also seen projects as low as $1,500 and as high as $6,000. Heat pump installation is likely to be closer to the national average, but as mentioned, these devices work to be cool your home in the summer and heat in the winter.
I'll give props to HVAC Service for being available quickly and having Saturday and Sunday appointments. Tony fixed our air conditioner and was professional. So why only 2 stars? Because we sent the receipt into our homeowner association to see if we could get reimbursed for some costs, and the property manager said that we paid THREE times more than we should have. We got conned. I advise you to call HVAC Service, but also shop around and get other estimates. Learn from our mistake!
Regardless of how far along you are in your air conditioning project, you should start looking for a contractor now. The demand for Portland air conditioning has begun to outstrip the supply of contractors, and homeowners are telling us they've had to fight/wait to schedule an installation date. This may also determine the availability of your preferred contractor, as the best contractors' schedules tend to fill more quickly than the rest. Once you've submitted your online request, you can trust that our contractors are the most reliable professionals in the business. Each and every one our contractors has been put through a rigorous ten-step screening process. Our online customer ratings and reviews section will allow you to see what other homeowners have said, not just about individual contractors, but Portland air conditioning installation in general.
Absorption heat pumps are a kind of air-source heat pump, but they do not depend on electricity to power them. Instead, gas, solar power, or heated water is used as a main power source. An absorption pump dissolves ammonia gas in water, which gives off heat. Next, the water and ammonia mixture is depressurized to induce boiling, and the ammonia is boiled off, which absorbs heat from the outdoor air.[citation needed]
“Robinson Air = top notch professionals. Mike was personable, knowledgeable, timely, thorough, and left me with a hard copy of prioritized recommendations and his explanations of HVAC needs I may have in the future. I was very impressed with being shown a tablet picture of a possible problem. It was so refreshing to have the service and all phone interactions handled so well and smoothly…thank you for taking the “angst” out of this kind of service call. My hat is off to you and I will happily recommend you to family and friends. Thank you!!!”
I have a tankless water heater that began to leak. I called around and settled on Bill Howe. Jason came out on Monday and immediately pinpointed the issue. He called the manufacturer, explained what he saw, took a couple of pictures and said he will be back in a couple of days with replacement parts. A few days later Jason called to say he was on his way. He showed up and completed the work in about an hour.
A contactor is a $25 mechanical relay that uses low-voltage power from the thermostat to switch 220-volt high-amperage current to the compressor and condenser fan. AC contactors can wear out and are at the top of the list of common air conditioning service failures. Even if your contactor is working, it pays to replace it every five years or so. Unscrew the old contactor before removing the wires. Then move the wires to the new unit (photo 6).
×