Denver HVAC Repair

Heaters exist for various types of fuel, including solid fuels, liquids, and gases. Another type of heat source is electricity, normally heating ribbons composed of high resistance wire (see Nichrome). This principle is also used for baseboard heaters and portable heaters. Electrical heaters are often used as backup or supplemental heat for heat pump systems.
Many disconnect blocks contain two cartridge fuses. Check them before you proceed with repairs (Photo 3). A blown fuse is a sign of a failing part inside the condensing unit. So don’t just replace it and think you’ve solved the problem. Instead, replace the parts we show here. Then install new fuses and fire up the unit. If it blows again, call a pro—you’ve got more serious issues.
In very dry climates, evaporative coolers, sometimes referred to as swamp coolers or desert coolers, are popular for improving coolness during hot weather. An evaporative cooler is a device that draws outside air through a wet pad, such as a large sponge soaked with water. The sensible heat of the incoming air, as measured by a dry bulb thermometer, is reduced. The temperature of the incoming air is reduced, but it is also more humid, so the total heat (sensible heat plus latent heat) is unchanged. Some of the sensible heat of the entering air is converted to latent heat by the evaporation of water in the wet cooler pads. If the entering air is dry enough, the results can be quite substantial.
Modern air conditioning emerged from advances in chemistry during the 19th century, and the first large-scale electrical air conditioning was invented and used in 1902 by England inventor Willis Carrier. The introduction of residential air conditioning in the 1920s helped enable the great migration to the Sun Belt in the United States.[citation needed]
Berkeys knows how unbearable the Dallas, Plano, Fort Worth and Arlington Texas summers can be. Assuring your home’s air conditioning system is functioning properly is our job! We’ll always have the solution to your air conditioning problem, and we’ll rescue you when your system stops working. Call us or schedule your service online today and we think you will see why we are considered to be one of the Best A/C Companies in the Dallas & Fort Worth area!
At Peachtree Service Experts Heating & Air Conditioning, we understand heating and air conditioning, which is why we back up our work with our 100% Satisfaction Guarantee*. Not only does it demonstrate our confidence that you’ll be happy with the furnace repair we have completed, it holds us to a higher standard, making sure that we continue to provide you with amazing service without fail. When it’s time to handle any heating and cooling question or problem you have, know that you can trust the team at Peachtree Service Experts regardless of what the Atlanta weather brings.

Because an air conditioner moves heat between the indoor coil and the outdoor coil, both must be kept clean. This means that, in addition to replacing the air filter at the evaporator coil, it is also necessary to regularly clean the condenser coil. Failure to keep the condenser clean will eventually result in harm to the compressor, because the condenser coil is responsible for discharging both the indoor heat (as picked up by the evaporator) and the heat generated by the electric motor driving the compressor.
Need 24-hour emergency furnace repair? We can take care of that too. With our same-day service and live phone and online chat service available 24/7, we make your comfort our highest priority. Heating and air conditioning should help you live a comfortable life, so let us help you make your home the most comfortable it has ever been. It’s easy, just grab your furnace repair coupon, then simply give us a call at 678-235-9699, chat or schedule an appointment with us online.
Evaporative coolers tend to feel as if they are not working during times of high humidity, when there is not much dry air with which the coolers can work to make the air as cool as possible for dwelling occupants. Unlike other types of air conditioners, evaporative coolers rely on the outside air to be channeled through cooler pads that cool the air before it reaches the inside of a house through its air duct system; this cooled outside air must be allowed to push the warmer air within the house out through an exhaust opening such as an open door or window.[28] These coolers cost less and are mechanically simple to understand and maintain.
I was able to get a next day appointment with them last week after multiple other providers did not have availability. The tech was on time and did a good job to diagnose and eventually replace the circuit board and get it up running again. The service itself would be 5 stars, although it did take a week to complete the job due to ordering the part.
In modern buildings, the design, installation, and control systems of these functions are integrated into one or more HVAC systems. For very small buildings, contractors normally estimate the capacity and type of system needed and then design the system, selecting the appropriate refrigerant and various components needed. For larger buildings, building service designers, mechanical engineers, or building services engineers analyze, design, and specify the HVAC systems. Specialty mechanical contractors then fabricate and commission the systems. Building permits and code-compliance inspections of the installations are normally required for all sizes of building.
In the fall you should prepare your HVAC unit for winter. Turn off your air conditioner’s circuit, then hose it off to remove debris. It must dry completely. Do this when it’s warm enough that there’s no risk of the water freezing. Cover the exposed pipes with foam pipe insulation ($1-$3), and protect your entire unit with a weatherproof cover ($20-$50).
You can keep your air conditioner running efficiently with some preventative care measures. Shut off the power to your AC before cleaning it or performing any of these tasks:  clean your filter at least twice a year; remove leaves and twigs from cages; clean the fins with a garden hose or special spray, then use a butter knife to straighten any that are crooked; keep your yard clean so the fins won't get blocked; cover the unit up for winter; and make sure it's level or you run the risk of damaging the inner workings of the unit.
Technician Laurence arrived on time. I was running 20 minutes late and he waited patiently for my arrival. I described the problem with my air conditioner. He examined the A/C system and quickly diagnosed the problem. He had identified that the capacitor was not functioning and replaced it. Her then started the A/C system and confirmed that it was working well. He also checked refrigerant level. I am very happy with the service provided and the professionalism of Bill Howe Technician Laurence. I would highly recommend Bill Howe Heating & Air.

Should I repair or replace my HVAC? It’s a common question — and you need to weigh several factors to make the decision. One of the most significant factors is the lifespan of your unit. According to EnergyStar — a U.S. Environmental Protection Agency voluntary program — an A.C. unit lasts about 15 to 20 years. On average, a heat pump perseveres for 16 years and a furnace functions for between 15 to 20 years, reports This Old House.
Before opening the electrical cover on the A/C unit, be sure to shut off all power to the compressor unit and the indoor furnace or air handler, and verify that it is off. Note that this may mean shutting off a circuit breaker that serves the furnace and air handler, and then, near the compressor, pulling out the disconnect block (or shutting off the 220-volt power) to the outdoor compressor.
As a local HVAC provider, established in 2001, Reliable Comfort Heating & Air Conditioning targets the challenges faced by homeowners in Columbus, Seymour & surrounding areas.  No matter what the weather brings, we answer with products and services that deliver unprecedented energy efficiency, safe operation, ideal comfort, reliability, and sustainability.  We love nothing better than enhancing your home enjoyment while trimming your monthly costs.  Replace outdated equipment with a state-of-the-art furnace, air conditioner, or heat pump, and we’ll make sure your system pays for itself.  Take advantage of a Home Performance Evaluation, Aeroseal Duct Sealing, or enrollment in Comfort Care, and we’ll optimize and protect your indoor environment.  If you’re in need of expert repair, our NATE-certified technicians are always on call, 24 hours a day, 365 days a year.  There’s simply no challenge we can’t turn into a rewarding result.

I have a tankless water heater that began to leak. I called around and settled on Bill Howe. Jason came out on Monday and immediately pinpointed the issue. He called the manufacturer, explained what he saw, took a couple of pictures and said he will be back in a couple of days with replacement parts. A few days later Jason called to say he was on his way. He showed up and completed the work in about an hour.
Regardless of the scope of your project, find out what you need to do to prepare your home for their visit. For example, the HVAC professional will need access to the areas in question and may need access to other mechanical or ventilation points. Make sure pets and children are kept out of the way. Ask if your project will involve removing dry wall or making any other structural changes – you may need to hire a professional drywall contractor to patch up HVAC work. If you are adding a unit that may contribute to carbon monoxide within the home, find out if you need to purchase a carbon monoxide detector.
Air conditioner equipment power in the U.S. is often described in terms of "tons of refrigeration", with each approximately equal to the cooling power of one short ton (2000 pounds or 907 kilograms) of ice melting in a 24-hour period. The value is defined as 12,000 BTU per hour, or 3517 watts.[32] Residential central air systems are usually from 1 to 5 tons (3.5 to 18 kW) in capacity.
Air conditioner equipment power in the U.S. is often described in terms of "tons of refrigeration", with each approximately equal to the cooling power of one short ton (2000 pounds or 907 kilograms) of ice melting in a 24-hour period. The value is defined as 12,000 BTU per hour, or 3517 watts.[32] Residential central air systems are usually from 1 to 5 tons (3.5 to 18 kW) in capacity.
With the split system, the evaporator coil is connected to a remote condenser unit using refrigerant piping between an indoor and outdoor unit instead of ducting air directly from the outdoor unit. Indoor units with directional vents mount onto walls, suspended from ceilings, or fit into the ceiling. Other indoor units mount inside the ceiling cavity, so that short lengths of duct handle air from the indoor unit to vents or diffusers around the rooms.

Explore HVAC.com for all your heating and air conditioning questions to find reliable answers and resources. We provide informational resources for improving your indoor air quality, finding the best HVAC provider for your home, understanding common heating and cooling terms, and more. Our expert tips help you save energy with your heating and cooling system so you can reduce your energy bills year-round.

"Customer service was great, and the price was in-line with other places, and fast service. We had a whole replacement of the outside and inside. I would have liked to see a better install for the furnace and new thermostat - the new thermostat should have gone where the old one was, and even tho the new furnace was a tight fit, they didn't offer to come back and repair the case molding, or give me a discount on the damage done, and I believe they should have put a disconnect box on the outside of the home, to make it easier for any future repairs needed. Other than that, am very happy with the cooling and heating!"
×