If the air conditioner on your thermostat set low, and you aren't feeling cool air, it could be that debris is blocking the condenser. Check on your system outside and remove any tree branches or leaves from around it. Debris can easily obstruct air flow, so make sure the area around your air conditioning unit is clean and trimmed back. Make sure your filter is clean. A buildup of dirt and dust can cause poor air circulation.
Whether you have concerns about your indoor air quality or want to upgrade your air conditioning unit, Aire Serv of Omaha knows how to get the job done. Our Omaha heater repair and AC maintenance experts can tackle problems big and small throughout Bellevue, Carter Lake (IA), St. Columbans, Waterloo, La Vista, and surrounding communities. Trust our team to take care of your heating and air conditioning service needs today.
The selection of the working fluids (refrigerants) has a significant impact not only on the performance of the air conditioners but on the environment as well. Most refrigerants used for air conditioning contribute to global warming, and many also deplete the ozone layer. CFCs, HCFCs, and HFCs are potent greenhouse gases when leaked to the atmosphere.
As one of the most trusted commercial HVAC service companies in the Midwest, not only will you receive prompt service, you won’t have to worry about our teams’ knowledge and corrective service capabilities. In the last 18 months, we’ve performed more than 3,790 mechanical preventive maintenance inspections. Whether you're in need of basic air conditioner maintenance or full commercial heating and air conditioning repair, we have yet to find a deficiency we can't fix.
The myth that most people believe is that if you add more refrigerant to the unit it will cool better. This is only true if the evaporator coil is operating below freezing. The unit must have a balanced charge at the correct refrigerant pressure for the temperature and usually, only an HVAC professional can charge your unit properly. Another misconception about refrigerant is that the unit burns it up and it must be replaced from time to time. This is not true. Furthermore, the refrigerant loop is a closed system and barring any leaks the air conditioning system should never need any refrigerant.
A dehumidifier is an air-conditioner-like device that controls the humidity of a room or building. It is often employed in basements which have a higher relative humidity because of their lower temperature (and propensity for damp floors and walls). In food retailing establishments, large open chiller cabinets are highly effective at dehumidifying the internal air. Conversely, a humidifier increases the humidity of a building.
Occupational employment projections are developed for all states by Labor Market Information (LMI) or individual state Employment Projections offices. All state projections data are available at www.projectionscentral.com. Information on this site allows projected employment growth for an occupation to be compared among states or to be compared within one state. In addition, states may produce projections for areas; there are links to each state’s websites where these data may be retrieved.
This is a very common air conditioning problem. The unit will cool for a few hours and then it stops cooling all together. The next day or several hours later the air conditioning is cooling again but for only a few hours and then the air conditioning stops again. The reason this is happening is because the air conditioning unit is low on refrigerant because you have a refrigerant leak (the unit could freeze because of a few other air conditioning problems but this is the most common reason).
As you would expect, air conditioning in Portland isn't as expensive as in most areas of the country, owing simply to the fact that most homes don't require particularly large or state-of-the-art units. While our data suggests the national average for air conditioning installation is about $6,000, in Portland we see numbers between $3,000-$4,000, although we've also seen projects as low as $1,500 and as high as $6,000. Heat pump installation is likely to be closer to the national average, but as mentioned, these devices work to be cool your home in the summer and heat in the winter.
I have a recurring problem of having to have freon added to my A/C system. I have even replaced both units inside and outside but seem to have the same problem. I believe that it must be in the lines between the outside and inside. Is there anything that can be put into the lines to seal any leaks if this is the problem? If not is it advised that the lines be replaced?
An improperly maintained heating and air conditioning is an inefficient heating and air conditioning system. That’s why we provide appointments for annual inspections with our licensed technicians. It’s our goal to make sure that your home is as comfortable and energy-efficient as possible. For inspections, repairs, and service, contact BGE HOME for quality service.
Our skilled technicians arrive prepared to handle the scope of even complex malfunctions, with all makes and models of heating and cooling equipment, most often resolving the problem on the spot. For all your HVAC service, repairs, and installations in Livermore, CA, Pleasanton, CA & Dublin, CA, call the team from Miller’s Air Conditioning & Heating!
The basic concept behind air conditioning is said to have been applied in ancient Egypt, where reeds were hung in windows and were moistened with trickling water. The evaporation of water cooled the air blowing through the window. This process also made the air more humid, which can be beneficial in a dry desert climate. In ancient Rome, water from aqueducts was circulated through the walls of certain houses to cool them. Other techniques in medieval Persia involved the use of cisterns and wind towers to cool buildings during the hot season.
Air duct cleaning is done by heating, ventilation and air conditioning (HVAC) professionals. The pros use industrial-strength, truck-mounted vacuums and powerful brushes and hoses to clean inside the metal ducts that make up your forced air heating and cooling system. The Environmental Protection Agency recommends duct cleaning if there is “substantial visible mold growth inside hard surface ducts, ducts that are infested with vermin such as rodents or insects, or ducts that are clogged with excessive amounts of dust and debris and/or particles are actually released into the home from your supply registers.”
The condensed, pressurized, and still usually somewhat hot liquid refrigerant is next routed through an expansion valve (often nothing more than a pinhole in the system's copper tubing) where it undergoes an abrupt reduction in pressure. That pressure reduction results in flash evaporation of a part of the liquid refrigerant, greatly lowering its temperature. The cold refrigerant is then routed through the evaporator. A fan blows the interior warm air (which is to be cooled) across the evaporator, causing the liquid part of the cold refrigerant mixture to evaporate as well, further lowering the temperature. The warm air is therefore cooled and is pumped by an exhaust fan/ blower into the room. To complete the refrigeration cycle, the refrigerant vapor is routed back into the compressor. In order for the process to have any efficiency, the cooling/evaporative portion of the system must be separated by some kind of physical barrier from the heating/condensing portion, and each portion must have its own fan to circulate its own "kind" of air (either the hot air or the cool air).
Ventilation is the process of changing or replacing air in any space to control temperature or remove any combination of moisture, odors, smoke, heat, dust, airborne bacteria, or carbon dioxide, and to replenish oxygen. Ventilation includes both the exchange of air with the outside as well as circulation of air within the building. It is one of the most important factors for maintaining acceptable indoor air quality in buildings. Methods for ventilating a building may be divided into mechanical/forced and natural types.
HVAC.com is the top heating and air conditioning resource site in the world! As you search for a contractor, check out our Resource Center and the HVAC.com Blog to find answers to any heating, air conditioning, or indoor air quality question. Learn about the types of systems used in homes and businesses, how to vet contractors, and more which will best prepare you for working with the pros you’ll find through our directory.
Central home air conditioner service systems consist of two major components: a condensing unit that sits outside your house, and the evaporator coil (often referred to as an A-coil) that sits in the plenum of your furnace or air handler. The refrigerant in the A-coil picks up the heat from your home and moves it to the outdoor condensing unit. The condensing unit fan blows outside air through the condensing coil to remove the heat. The condensing unit houses the three parts replaceable by a DIYer: the contactor, the start/run capacitor(s) and the condenser fan motor. The condensing unit also houses the compressor, but only a pro can replace that. The A-coil has no parts that can be serviced by a DIYer.