I could not have been more pleased with the responsiveness, considerate employees, workmanship, and follow up. We used three divisions of Bill Howe when we had a flood due to a water heater/T&P gauge, Plumbing, Remediation and Reconstruction. It was timely, reasonably priced and finished with attention to detail. Ashley in the office was always polite and responsive and we could not have been happier under the circumstances.
Our skilled technicians arrive prepared to handle the scope of even complex malfunctions, with all makes and models of heating and cooling equipment, most often resolving the problem on the spot. For all your HVAC service, repairs, and installations in Livermore, CA, Pleasanton, CA & Dublin, CA, call the team from Miller’s Air Conditioning & Heating!
"Customer service was great, and the price was in-line with other places, and fast service. We had a whole replacement of the outside and inside. I would have liked to see a better install for the furnace and new thermostat - the new thermostat should have gone where the old one was, and even tho the new furnace was a tight fit, they didn't offer to come back and repair the case molding, or give me a discount on the damage done, and I believe they should have put a disconnect box on the outside of the home, to make it easier for any future repairs needed. Other than that, am very happy with the cooling and heating!"
If you have a good HVAC contractor they should offer an annual preventive maintenance agreement where they will perform semi-annual maintenance, once in the Spring and once in the Fall, to service your heating and cooling system. The typical maintenance agreement usually guarantees the HVAC contractor will provide service and parts at a discount rate if the listed equipment fails. Some contractors will even give you after hours service with no extra overtime charge as is the case with most other customers.
If your air conditioner isn’t cooling, or is experiencing another performance issue, shut it off. Don’t continue to operate a malfunctioning air conditioner, as that may worsen the problem at hand. This is one reason we do preventative maintenance checks pre-season – a technician identifies and corrects problems, so you don’t run your system with faulty components, causing more damage.
After discussing faulty AC system symptoms with you, Jiffy Lube® technicians begin the service by visually inspecting the air conditioning compressor drive belt, serpentine belt and all accessible components for cracks, leaks or damage. Then they check the operation of the air conditioning compressor. If no leaks or damage are found, they evacuate the refrigerant from the system, vacuum test it, and recharge the air conditioning system using the appropriate refrigerant according to your vehicle manufacturer's recommendations.
Check that the 240-volt circuit breaker (double-pole breaker) controlling the air-conditioning compressor/condensing unit and the 120-volt circuit breaker controlling the furnace blower or separate air handler, is in the "On" positions. If a circuit breaker has tripped or a fuse is blown, then reset the circuit breaker or replace the fuse. If you reset the breaker or replace the fuse and they trip or blow again, stop and call an air-conditioning service technician, as you may have a more serious problem.
An example of a geothermal heat pump that uses a body of water as the heat sink, is the system used by the Trump International Hotel and Tower in Chicago, Illinois. This building is situated on the Chicago River, and uses cold river water by pumping it into a recirculating cooling system, where heat exchangers transfer heat from the building into the water, and then the now-warmed water is pumped back into the Chicago River.
Central home air conditioner service systems consist of two major components: a condensing unit that sits outside your house, and the evaporator coil (often referred to as an A-coil) that sits in the plenum of your furnace or air handler. The refrigerant in the A-coil picks up the heat from your home and moves it to the outdoor condensing unit. The condensing unit fan blows outside air through the condensing coil to remove the heat. The condensing unit houses the three parts replaceable by a DIYer: the contactor, the start/run capacitor(s) and the condenser fan motor. The condensing unit also houses the compressor, but only a pro can replace that. The A-coil has no parts that can be serviced by a DIYer.