Denver HVAC Repair

If you’re concerned about dust, allergens or mold, it may be time to have your air ducts cleaned. The national average cost for air duct cleaning ranges from $190 to $250. Air duct cleaning costs will vary based on a number of factors such as your location in the country, the age and condition of your air ducts, the number of linear feet to be cleaned, and any repairs your ducts may need. HVAC cleaning companies should clearly outline what is included in their services and at what rate, so always make sure you understand and have a written agreement before work begins. Here are some examples of average air duct cleaning costs:
With our wide range of expert services, affordable pricing, and customer dedication, we are certain to satisfy. This is all to ensure you only need to keep one number in mind for all your heating and cooling solutions. That number is 630-723-7716! Contact us today for new design/installation, replacement, seasonal maintenance, and/or prompt repair of furnaces, boilers, central air conditioners, ductless systems and so much more. After more than thirty years in business, Apex Energy, Inc. knows how to treat you right.
The compressor-based refrigerant systems are air-cooled, meaning they use air to exchange heat, in the same way as a car radiator or typical household air conditioner does. Such a system dehumidifies the air as it cools it. It collects water condensed from the cooled air and produces hot air which must be vented outside the cooled area; doing so transfers heat from the air in the cooled area to the outside air.

It can be hard to make the decision to replace or repair your AC unit. However, in many cases, homeowners call in HVAC professionals to check their units and provide a second opinion. A technician can tell you if there’s plenty of life left in your old air conditioning unit or that it’s time to let it go and get a new one. Your HVAC technician may check out your home’s insulation quality, too. You could increase your system’s effectiveness by improving the insulation.
Packaged terminal air conditioner (PTAC) systems are also known as wall-split air conditioning systems.[36] They are ductless systems. PTACs, which are frequently used in hotels, have two separate units (terminal packages), the evaporative unit on the interior and the condensing unit on the exterior, with an opening passing through the wall and connecting them. This minimizes the interior system footprint and allows each room to be adjusted independently. PTAC systems may be adapted to provide heating in cold weather, either directly by using an electric strip, gas, or other heater, or by reversing the refrigerant flow to heat the interior and draw heat from the exterior air, converting the air conditioner into a heat pump. While room air conditioning provides maximum flexibility, when used to cool many rooms at a time it is generally more expensive than central air conditioning.
This company deserves more than five stars. They didn't just replace my heater and air conditioner, they built me a new system for my house. Going above and beyond is a understatement. Steve's staff were 2 of the nicest workers I've come across in a long time. Friendly, knowledgeable, and very clean. Truly a top rated company. Thanks Steve. Great job.
a/c compressor needed replacing. the A Team Mechanical found a way to return the next day to complete the repairs and made sure the system was running effectively. Even put down another concrete base pad to level the a/c unit. They were professionals and straight forward with the services needed. All the other HVAC companies wanted to charge me three time the amount for the services.

1/27/2015 Melissa, we are committed to providing the highest level of service and would like to hear more… Melissa, we are committed to providing the highest level of service and would like to hear more about your personal situation. Please email steve, our Customer Relations Specialist at [email protected] or give him a call at 925-318-4795.  Hopefully, you will give us the opportunity to make this right. Read more

The condenser fan is another important HVAC element that must be maintained. Condenser fans that contain oil ports should be lubricated at least annually. The outside condenser should also be shielded from direct sunlight if possible. Keeping vegetation at least two feet away from outdoor HVAC units will also promote higher performance and potentially lower energy bills due to higher efficiency. The further away vegetation is, the better an HVAC unit will operate. 


I have a recurring problem of having to have freon added to my A/C system. I have even replaced both units inside and outside but seem to have the same problem. I believe that it must be in the lines between the outside and inside. Is there anything that can be put into the lines to seal any leaks if this is the problem? If not is it advised that the lines be replaced?
The condensed, pressurized, and still usually somewhat hot liquid refrigerant is next routed through an expansion valve (often nothing more than a pinhole in the system's copper tubing) where it undergoes an abrupt reduction in pressure. That pressure reduction results in flash evaporation of a part of the liquid refrigerant, greatly lowering its temperature. The cold refrigerant is then routed through the evaporator. A fan blows the interior warm air (which is to be cooled) across the evaporator, causing the liquid part of the cold refrigerant mixture to evaporate as well, further lowering the temperature. The warm air is therefore cooled and is pumped by an exhaust fan/ blower into the room. To complete the refrigeration cycle, the refrigerant vapor is routed back into the compressor. In order for the process to have any efficiency, the cooling/evaporative portion of the system must be separated by some kind of physical barrier from the heating/condensing portion, and each portion must have its own fan to circulate its own "kind" of air (either the hot air or the cool air).

The myth that most people believe is that if you add more refrigerant to the unit it will cool better. This is only true if the evaporator coil is operating below freezing. The unit must have a balanced charge at the correct refrigerant pressure for the temperature and usually, only an HVAC professional can charge your unit properly. Another misconception about refrigerant is that the unit burns it up and it must be replaced from time to time. This is not true. Furthermore, the refrigerant loop is a closed system and barring any leaks the air conditioning system should never need any refrigerant.
A.J. LeBlanc Heating specializes in the installation and service of heating, air conditioning and plumbing systems for residential homes. Whether you are building a new home, converting your existing heating system to a different fuel, upgrading your old unit to a more efficient system, or just adding air conditioning, LeBlanc Heating can service your needs.
The HVAC industry has grown a lot since Brennan’s Heating & Air Conditioning opened. Today, high-tech comfort systems require highly-trained technicians who are NATE-certified and experienced in all areas of air conditioning repair, heating, and indoor air quality. After 35+ years, we’ve changed a lot too. At Brennan’s Heating & Air Conditioning, we still provide good, old-fashioned service, but we also offer the full line of cutting-edge products from the heating and cooling experts at Carrier.
Energy efficiency can be improved even more in central heating systems by introducing zoned heating. This allows a more granular application of heat, similar to non-central heating systems. Zones are controlled by multiple thermostats. In water heating systems the thermostats control zone valves, and in forced air systems they control zone dampers inside the vents which selectively block the flow of air. In this case, the control system is very critical to maintaining a proper temperature.
Reinstall the access panel and disconnect block. Turn on the circuit breaker and furnace switch. Then set the thermostat to a lower temperature and wait for the AC to start (see “Be Patient at Startup,” below). The compressor should run and the condenser fan should spin. If the compressor starts but the fan doesn’t, the fan motor is most likely shot. Shut off the power and remove the screws around the condenser cover. Lift the cover and remove the fan blade and motor (photo 7). Reinstall the blade and secure the cover. Then repower the unit and see if the fan starts. If it doesn’t, you’ve given it your best shot—it’s time to call a pro.
×