Denver HVAC Repair

Technician Laurence arrived on time. I was running 20 minutes late and he waited patiently for my arrival. I described the problem with my air conditioner. He examined the A/C system and quickly diagnosed the problem. He had identified that the capacitor was not functioning and replaced it. Her then started the A/C system and confirmed that it was working well. He also checked refrigerant level. I am very happy with the service provided and the professionalism of Bill Howe Technician Laurence. I would highly recommend Bill Howe Heating & Air.
Next, consider the age of your unit. Remember, as we mentioned earlier, that the average life of a furnace is around 15 to 20 years. In some cases, during the installation process, your licensed and trained technician will write down the installation date right on the unit. If not, you can check inside the chamber door for a metal identification plate containing the serial and model numbers. You can then call the customer service line of the manufacturer and ask for the manufacture date of the unit.
When you call our HVAC company to repair, maintain or replace your system, you can expect professionals who use the best parts and equipment. After scheduling an initial consultation with the contractor at Robinson Air, you’ll know immediately you’re working with a contractor who is focused on using the highest quality components for your repair, replacement or maintenance needs.

A specialized air conditioner that is used only for dehumidifying is called a dehumidifier. It also uses a refrigeration cycle, but differs from a standard air conditioner in that both the evaporator and the condenser are placed in the same air path. A standard air conditioner transfers heat energy out of the room because its condenser coil releases heat outside. However, since all components of the dehumidifier are in the same room, no heat energy is removed. Instead, the electric power consumed by the dehumidifier remains in the room as heat, so the room is actually heated, just as by an electric heater that draws the same amount of power.
If so, you may want to consider replacing your entire AC system. After your AC system reaches a certain age, it makes more sense to invest in a new AC system altogether rather than repairing it one piece at a time. To learn more about John Moore’s AC replacement program, our warranty, and the cost-advantages of replacing your AC system, visit our AC Replacement page.
A contactor is a $25 mechanical relay that uses low-voltage power from the thermostat to switch 220-volt high-amperage current to the compressor and condenser fan. AC contactors can wear out and are at the top of the list of common air conditioning service failures. Even if your contactor is working, it pays to replace it every five years or so. Unscrew the old contactor before removing the wires. Then move the wires to the new unit (photo 6).
When you schedule air conditioning and heating maintenance with The Home Depot, one of our local, licensed, and insured service providers will come to your house and perform a 28-point inspection on your units. Scheduling two seasonal heating and cooling services per year with The Home Depot is a worthwhile investment that can help identify and fix small issues before they lead to bigger, more expensive repairs.
First, it is wise to stick with a company that specializes in HVAC services. While many general handyman companies may do some things with AC units, a company that specializes in air conditioning and heating is always a better option. Because air conditioning repairs can be quite costly, depending on the particular problem, it is best to work with highly trained HVAC professionals to ensure quality work.
If you believe that the ac not working or you’re getting little or no cold air, check these three things first. Make sure all the registers in the house are wide open. Then be sure the furnace filter is clean. Then go outside and clean off the condenser coils (Photo 2). If several registers were closed or the filter was clogged, the reduced airflow could have caused the evaporator coil to ice up and stop cooling your home. If you’ve changed the filter and opened all the registers and you’re still not getting airflow at the registers, deice the A-coil. Move the thermostat mode switch from “Cooling” to “Off” and move the fan switch from “Auto” to “On.” Let the blower run for at least 30 minutes or until there’s good airflow at the registers. Then turn the AC back on to test it. If it works for the next 12 hours, you’ve solved the problem.
×