Denver HVAC Repair

The employees were on time, professional, and extremely thorough while addressing a particularly difficult situation. The entire time Saul, the supervisor of the team, kept me informed, and educated me about any process that I may have not completely understood. The team was courteous to the residents they encountered, and made sure not to leave evidence that they had even been there. Great job!
If you’re searching for a heating and cooling solution, call us, and we’ll be delighted to talk you through installations, repairs, and more in Mableton. It’s important to us that you are comfortable in your home, and effective heating, air conditioning, and air quality are all crucial aspects of that lifestyle. We’re available through our online scheduler or by phone, every day of the year to handle any emergency hvac repair you may have.
The heat pump gained popularity in the 1950s in Japan and the United States.[13] Heat pumps can extract heat from various sources, such as environmental air, exhaust air from a building, or from the ground. Initially, heat pump HVAC systems were only used in moderate climates, but with improvements in low temperature operation and reduced loads due to more efficient homes, they are increasing in popularity in cooler climates.
I could not have been more pleased with the responsiveness, considerate employees, workmanship, and follow up. We used three divisions of Bill Howe when we had a flood due to a water heater/T&P gauge, Plumbing, Remediation and Reconstruction. It was timely, reasonably priced and finished with attention to detail. Ashley in the office was always polite and responsive and we could not have been happier under the circumstances.
The contactor (relay) and start/run capacitor(s) (see illustration below) fail most often and are inexpensive. So it’s a safe bet to buy and install those parts right away, especially if your air conditioning service unit is older than five years. The condenser fan motor can also fail, but it runs about $150 — hold off buying that unless you’re sure that’s the culprit.
1) Your air conditioner is not working at all. Before calling in a professional to address this issue, you may want to check a few things yourself. Check to see if your thermostat is set to “cool”. Confirm that your designated cooling temperature is less than the temperature of the room or home. If everything is set correctly, check the electrical panel to be sure you do not have a tripped breaker. If these things all check out and your air condition unit is still not working, it is time to call in a professional.
Change the filters regularly: This is one of the most important steps in system maintenance. Dirty filters mean your system has to work harder to move the air, causing poor performance and creating more wear and tear on the system. A clean filter also lowers your energy costs, since the system uses less power to do the same amount of work, and improves indoor air quality.
The compressor-based refrigerant systems are air-cooled, meaning they use air to exchange heat, in the same way as a car radiator or typical household air conditioner does. Such a system dehumidifies the air as it cools it. It collects water condensed from the cooled air and produces hot air which must be vented outside the cooled area; doing so transfers heat from the air in the cooled area to the outside air.

Attic Fan Installation Bathroom Fan Repair Ceiling Fan Installation Ceiling Fan Repair Electric Wall Heater Installation Electrical Panel Installation Electrical Panel Repair Electrical Panel Upgrade Electrical Wiring Installation Electrical Wiring Upgrade Exhaust Fan Installation Holiday Lighting Installation LED Interior Light Conversion Light Fixture Installation Light Fixture Repair Light Fixture Replacement Light Switch Installation Outlet Installation Outlet Repair Spa Wiring Installation
In modern buildings, the design, installation, and control systems of these functions are integrated into one or more HVAC systems. For very small buildings, contractors normally estimate the capacity and type of system needed and then design the system, selecting the appropriate refrigerant and various components needed. For larger buildings, building service designers, mechanical engineers, or building services engineers analyze, design, and specify the HVAC systems. Specialty mechanical contractors then fabricate and commission the systems. Building permits and code-compliance inspections of the installations are normally required for all sizes of building.
From furnaces to full commercial systems and much, much more, we are committed to fantastic service and meeting our customer’s needs. If you’re looking for an emergency AC or heating repair, or just want to have a conversation about your heating and cooling needs, please give us a call at 678-235-9699, or schedule an appointment online and we’d be happy to chat with you! 
Serving the entire High Desert and Inland Empire areas - we are about quality service - giving the customer the best options - and delivering what they want. We are a small fully licensed and insured company specializing in residential heating and air conditioning. We are a small fully licensed and insured company specializing in residential and light commercial heating and air conditioning.
Just like running a marathon, we perform better at full strength. If we’re not feeling great, it’s that much harder to finish the race. Similarly, when you set your thermostat to a certain temperature, the system is tasked with maintaining that temperature throughout the room. Working at full strength, the system can easily maintain that temperature (as long as it’s not below 60 degrees or above 80 degrees). However, when injured, the system may struggle to keep the room at your desired temperature. As such, it’s working harder, which means higher utility bills.
Reinstall the access panel and disconnect block. Turn on the circuit breaker and furnace switch. Then set the thermostat to a lower temperature and wait for the AC to start (see “Be Patient at Startup,” below). The compressor should run and the condenser fan should spin. If the compressor starts but the fan doesn’t, the fan motor is most likely shot. Shut off the power and remove the screws around the condenser cover. Lift the cover and remove the fan blade and motor (photo 7). Reinstall the blade and secure the cover. Then repower the unit and see if the fan starts. If it doesn’t, you’ve given it your best shot—it’s time to call a pro.
×