Denver HVAC Repair

Berkeys is a licensed HVAC contractor and air conditioning company offering AC repair, Air Conditioning tune-up, and air conditioning replacement services in Southlake, TX, Keller, TX, Coppell, TX, Colleyville, TX, Grapevine, TX, Plano, TX, Fort Worth, TX, Arlington, TX, Frisco, TX, Dallas, TX, Addison, TX, Flower Mound, TX, Irving, TX, McKinney, TX, Arlington, TX, Euless, TX, Denton, TX, Highland Village, TX, Grand Prairie, TX, Westlake, TX, Farmers Branch, TX, Lewisville, TX and more. Call to confirm service for your home.
I was able to get a next day appointment with them last week after multiple other providers did not have availability. The tech was on time and did a good job to diagnose and eventually replace the circuit board and get it up running again. The service itself would be 5 stars, although it did take a week to complete the job due to ordering the part.
Your air conditioner’s outside unit is home to the compressor, fan, and condenser coils. These components work to release heat from the air, transferring it out of your home to produce a cool indoor climate. When the outdoor fan isn’t working correctly, the heat transfer process is hindered. Not only will this prevent your air conditioner from adequately cooling your home, a broken fan can cause the system’s compressor to overheat. An overheated compressor could trigger the air conditioner’s safety controls, turning your air conditioner off; overheating can also cause damage to the compressor itself, requiring home AC repair or compressor replacement.
All AC repairs were not created equal. While a new filter could cost as low as $20, a refrigerant leak repair can cost up to $1,600. Just like any aspect of the house, certain repairs will mostly depend on the damage. Clearly, the more serious issues will cost more. That not only means more time for the HVAC pro, but more complexity and materials as well. Sadly, neither come without a hefty markup.
Dichlorodifluoromethane (R-12) was the most common blend used in automobiles in the U.S. until 1994, when most designs changed to R-134A due to the ozone-depleting potential of R-12. R-11 and R-12 are no longer manufactured in the U.S. for this type of application, so the only source for air-conditioning repair purposes is the cleaned and purified gas recovered from other air conditioner systems. Several non-ozone-depleting refrigerants have been developed as alternatives, including R-410A. It was first commercially used by Carrier Corp. under the brand name Puron.[citation needed]
Air conditioning units work by using evaporator and condenser coils to remove heat from the air in your home. Warm household air blows through the evaporator coils, which transfer the heat into refrigerant vapor, which is then moved to the condenser in the outdoor part of the unit. The condenser coils turn the now-warm refrigerant vapor into liquid, allowing the heat to be dispersed outside and away from your home.
In 1758, Benjamin Franklin and John Hadley, a chemistry professor at Cambridge University, conducted an experiment to explore the principle of evaporation as a means to rapidly cool an object. Franklin and Hadley confirmed that evaporation of highly volatile liquids (such as alcohol and ether) could be used to drive down the temperature of an object past the freezing point of water. They conducted their experiment with the bulb of a mercury thermometer as their object and with a bellows used to speed up the evaporation. They lowered the temperature of the thermometer bulb down to −14 °C (7 °F) while the ambient temperature was 18 °C (64 °F). Franklin noted that, soon after they passed the freezing point of water 0 °C (32 °F), a thin film of ice formed on the surface of the thermometer's bulb and that the ice mass was about 6 mm (1⁄4 in) thick when they stopped the experiment upon reaching −14 °C (7 °F). Franklin concluded: "From this experiment one may see the possibility of freezing a man to death on a warm summer's day."[9]

You can count on our analysis of your home’s plumbing, air conditioning & electrical problems as well as our recommendations for installation, and maintenance. We provide state-of-the-art equipment, so all jobs are performed professionally and efficiently. To schedule an appointment with some of the best Houston area plumbers, electricians or air conditioning repair and installation experts, call 713-766-3605713-766-3605.

Just like running a marathon, we perform better at full strength. If we’re not feeling great, it’s that much harder to finish the race. Similarly, when you set your thermostat to a certain temperature, the system is tasked with maintaining that temperature throughout the room. Working at full strength, the system can easily maintain that temperature (as long as it’s not below 60 degrees or above 80 degrees). However, when injured, the system may struggle to keep the room at your desired temperature. As such, it’s working harder, which means higher utility bills.

Stay away front his company!!! In 2008 I had the company send Rick a technician to do warranty work on my new house. I complained about my house being hot in the summer. Tech said that I had a delta t of 14 degrees (the difference of temp coming into the return and out the supply) and that system was functioning properly. Unfortunately I took their word. After 8 years of being hot I called a reputable company to come and check my system again. The HVAC system still operating with a delta t of 14 degrees. The new company looked at my HVAC system owner manual. They calculated my dry bulb temp and wet bulb temp and used the chart in the owners manual to determine that the system wasn't functioning properly. After the new company came a put two pounds of freon into my HVAC system I now have a 20 degree Delta t. Do not do business with this company not trust worthy!
In 1906, Stuart W. Cramer of Charlotte was exploring ways to add moisture to the air in his textile mill. Cramer coined the term "air conditioning", using it in a patent claim he filed that year as an analogue to "water conditioning", then a well-known process for making textiles easier to process. He combined moisture with ventilation to "condition" and change the air in the factories, controlling the humidity so necessary in textile plants. Willis Carrier adopted the term and incorporated it into the name of his company.[10]
Perhaps the most sensible way to cool your home is to use your home's heating apparatus. Heat pumps can work in exactly this fashion. This device exchanges warmer and cooler air particles between your home and the outside air, allowing you to create a comfortable environment inside your home without the need of generating your own source of heat and cold. The one major drawback of heat pumps is that they tend to be inadequate in extremely cold or hot temperatures, which Portland essentially never sees. The only reason many homeowners don't have heat pumps in their homes is that they already have a forced air heating system. Thus, the best time to install air conditioning for your home is when your heating system fails.
If you have an older central air conditioner, you might choose to replace the outdoor compressor with a modern, high-efficiency unit. If you do so, consult a local heating and cooling contractor to assure that the new compressor is properly matched to the indoor unit. However, considering recent changes in refrigerants and air conditioning designs, it might be wiser to replace the entire system.
With the split system, the evaporator coil is connected to a remote condenser unit using refrigerant piping between an indoor and outdoor unit instead of ducting air directly from the outdoor unit. Indoor units with directional vents mount onto walls, suspended from ceilings, or fit into the ceiling. Other indoor units mount inside the ceiling cavity, so that short lengths of duct handle air from the indoor unit to vents or diffusers around the rooms.
When you call Brubaker Inc., you know that your system will be serviced by a team of professional and courteous HVAC repair technicians. They will call when they are leaving their previous appointment, so you’ll know exactly when to expect them. While in your home, our technicians will take time to explain the problem, the recommended solution, and the progress of the repair.
Monday the following week, no phone calls, or follow up.  I call to get an update and am told that they cannot install my system because they don't have time.  I ask what does that mean, one year? One week? Until the end of summer they say.  What does that mean I ask?  They say at the end of September.  I say thank you for wasting 1 month of my time.
AC units and thermostats have built-in delay features when they’re shut down and then repowered. The delay can be as long as 10 minutes. And, if you’ve subscribed to an energy-saving device from your local power utility, the unit can take even longer to reset. If you’ve installed the parts shown and reinstalled the disconnect block, repowered the circuit breaker, turned on the switch at the furnace, moved the thermostat to AC mode and lowered the temperature below the indoor temperature, and the unit doesn’t fire up after 30 minutes, it’s time to call a pro.
×