Denver HVAC Repair

Dehumidification (air drying) in an air conditioning system is provided by the evaporator. Since the evaporator operates at a temperature below the dew point, moisture in the air condenses on the evaporator coil tubes. This moisture is collected at the bottom of the evaporator in a pan and removed by piping to a central drain or onto the ground outside.
AC air handler buzzing sounds. Do you hear a buzzing sound when you turn on the thermostat? The only thing that comes on in the house when you turn on the thermostat is the fan relay and fan in the air handler or furnace. Try switching the thermostat HEAT/COOL switch to OFF. Then switch the fan switch from AUTO to ON. The fan (only) should come on. If the air handler makes a buzzing sound, it probably has a bad fan relay or, more likely, blower fan.

Wow! These guys rock! I had issues with our fireplace for a while and the last company who "fixed" the issue basically charged me a lot of money and literally left me standing in the cold. Next they said it would cost me over $700 to fix the whole thing and they never came back. Finally I was able to find some good guys to fix the issue. Tony and Paul from HVAC were not only really friendly, they diagnosed the issue really fast and fixed it the same day. And it was 7 times less than what the other company asked for!!! Next time I know who to call! 5 Stars!
a/c compressor needed replacing. the A Team Mechanical found a way to return the next day to complete the repairs and made sure the system was running effectively. Even put down another concrete base pad to level the a/c unit. They were professionals and straight forward with the services needed. All the other HVAC companies wanted to charge me three time the amount for the services.
Believe it or not, the evaporator coils inside the AHU (Air Handling Unit) are freezing. You may notice the refrigerant lines on the condenser or at the AHU are frozen with ice build-up. The frost or ice builds up on the evaporator coils and blocks air flow (low air flow and no cooling are a sign of a low charge). A low refrigerant charge will cause the evaporator coil to operate at or below freezing. Since the coil typically operates below the dew point, it draws condensation out of the air. When the evaporator coil begins operating below freezing all this condensation freezes to the evaporator coil and the unit stops cooling.
In the case of heated water or steam, piping is used to transport the heat to the rooms. Most modern hot water boiler heating systems have a circulator, which is a pump, to move hot water through the distribution system (as opposed to older gravity-fed systems). The heat can be transferred to the surrounding air using radiators, hot water coils (hydro-air), or other heat exchangers. The radiators may be mounted on walls or installed within the floor to produce floor heat.
Some service providers may recommend repairs and maintenance tasks that are not needed. A savvy consumer who has researched how an HVAC system works and is familiar with most common maintenance tasks will quickly know the difference between necessary tasks and add-on services that drain the wallet. If a heating or cooling problem occurs, appliance service manuals typically contain troubleshooting tips and other information that may be helpful in identifying or even resolving the problem without calling a repairman. Online HVAC guides may also be helpful to a consumer who wishes to become more familiar with how an HVAC system works and potential signs of disrepair. 
No matter where you bought your air conditioning system, we can repair it. We have years of experience working with all the best central air conditioner brands such as Kenmore, Carrier. Trane, Goodman, and Rheem. As a result, you can rest assured we’re familiar with your air conditioning system and we have the parts you need to complete a successful air conditioner repair.
After my initial meeting with HVAC Service I had really high hopes and thought these guys were going to be my HVAC go to company. However, it did not pan out this way whatsoever. Initial estimate meeting - This was the initial meeting I thought I found the go to company. Alberto was friendly, punctual, and knowledgeable. I asked some very basic questions and Alberto was able to explain the why's and why not's of each of my questions. Overall I felt really comfortable with Alberto and was extremely impressed. Then it goes all downhill..... Alberto said they were busy but could either install on the upcoming Saturday. We were going to be out of town and said unfortunately that day did not work. He then proposed the upcoming Tuesday as a possible solution, but just had to confirm with another appointment. I said great. I will review the estimate and call your office to confirm I want to move forward with the install. Within 1-hour of Alberto leaving (probably more like 30 minutes) I called the office to confirm I wanted to move forward with the install and to please confirm that Tuesday will be the install day. The lady on the phone said that she will get in touch with Alberto and call me back. This was on a Friday. On Monday I had not received a call from HVAC Service so I called to follow up. The lady on the phone said they were not able to secure a crane for Tuesday and that the install would not be taking place. Fine, no problem I understand. Two weeks go by and no phone call from HVAC Service regarding install date, or any update at all. I call them to check in to see if they have put me on the schedule and when I can expect to have the AC installed. You can tell by the discussion I had with the lady on the phone that they completely forgot about me and have not scheduled anything. She says she needs to get in contact with the owner because she has no idea on the availability of the crane. I was told that she would call me back by the end of the day with an update. Surprise, surprise, no phone call. I call to follow up at the end of the next day and she said that she has not been able to get in touch with the owner. By this time, I am starting to get frustrated because I am starting to get the run around. I question her if I am even on the schedule or if they attempted to schedule a crane. She says they are extremely busy and that she does not know. So I say, basically I have waited over 2 weeks and you have not put me on the schedule and I am at the end of the install line. No answer. I tell her to talk to her boss and find out what is happening, and I will think about what direction I want to move in at this point. Monday the following week, no phone calls, or follow up. I call to get an update and am told that they cannot install my system because they don't have time. I ask what does that mean, one year? One week? Until the end of summer they say. What does that mean I ask? They say at the end of September. I say thank you for wasting 1 month of my time. How could they have served me better without serving me? 1. Be honest and let me know as soon as possible that the install was going to be delayed and probably not happen until the end of summer. Don't waste a month of my time. I could have reached out to a different company in the time I was waiting for them. 2. Communicate! the thing that upsets me the most is I was the one making all the calls to them. Not once did they ever call me to say we have not forgot about you, or this is what is happening. 3. Provide recommendations on other contractors who could have helped me once they realized they were too busy. I am pretty disappointed it came to this review because I really liked this company and wanted to do work with them. It is a family run business, and reminded me of the HVAC business my dad owned. Beware once you are the one that has to start calling them for updates, or to follow up; your time is probably best served by calling a different contractor.
Check that the 240-volt circuit breaker (double-pole breaker) controlling the air-conditioning compressor/condensing unit and the 120-volt circuit breaker controlling the furnace blower or separate air handler, is in the "On" positions. If a circuit breaker has tripped or a fuse is blown, then reset the circuit breaker or replace the fuse. If you reset the breaker or replace the fuse and they trip or blow again, stop and call an air-conditioning service technician, as you may have a more serious problem.
At Reliable Comfort Heating & Air Conditioning, we combine skilled workmanship with dedicated customer service to earn your complete satisfaction.  Whether you are in need of new HVAC installation, replacement, maintenance, repair, air quality solutions, or duct sealing, we draw from extensive hands-on experience, quality products, and advanced training to maximize value and rewards.
Air conditioners often use a fan to distribute the conditioned air to an occupied space such as a building or a car to improve thermal comfort and indoor air quality. Electric refrigerant-based AC units range from small units that can cool a small bedroom, which can be carried by a single adult, to massive units installed on the roof of office towers that can cool an entire building. The cooling is typically achieved through a refrigeration cycle, but sometimes evaporation or free cooling is used. Air conditioning systems can also be made based on desiccants (chemicals which remove moisture from the air) and subterraneous pipes that can distribute the heated refrigerant to the ground for cooling.[2]
If you need a furnace repaired or an air conditioner serviced, we'll send a local technician out to diagnose the specific problem and recommend solutions for you and your family. There will be a diagnostic fee for the visit, and any specific repairs will be an additional charge. If replacing your system is the best solution, the fee for the diagnosis will be credited toward the purchase and install of a new system.
Whether you have concerns about your indoor air quality or want to upgrade your air conditioning unit, Aire Serv of Omaha knows how to get the job done. Our Omaha heater repair and AC maintenance experts can tackle problems big and small throughout Bellevue, Carter Lake (IA), St. Columbans, Waterloo, La Vista, and surrounding communities. Trust our team to take care of your heating and air conditioning service needs today.

Berkeys is a licensed HVAC contractor and air conditioning company offering AC repair, Air Conditioning tune-up, and air conditioning replacement services in Southlake, TX, Keller, TX, Coppell, TX, Colleyville, TX, Grapevine, TX, Plano, TX, Fort Worth, TX, Arlington, TX, Frisco, TX, Dallas, TX, Addison, TX, Flower Mound, TX, Irving, TX, McKinney, TX, Arlington, TX, Euless, TX, Denton, TX, Highland Village, TX, Grand Prairie, TX, Westlake, TX, Farmers Branch, TX, Lewisville, TX and more. Call to confirm service for your home.
Most modern air-conditioning systems feature a dehumidification cycle during which the compressor runs while the fan is slowed as much as possible[citation needed] to reduce the evaporator temperature and therefore condense more water. When the temperature falls below a threshold, both the fan and compressor are shut off to mitigate further temperature drops;[clarification needed] this prevents moisture on the evaporator from being blown back into the room.[citation needed] When the temperature rises again,[clarification needed] the compressor restarts and the fan returns to low speed.

Our experienced technicians know how best to repair and maintain an HVAC system, keeping your family safe and your system running efficiently. Our team can also identify potential problems, addressing them before they cause serious damage to your system. Instead of attempting a repair yourself, have one of Brubaker Inc.’s trained technicians look at your system for you.


SEER is related to the coefficient of performance (COP) commonly used in thermodynamics and also to the Energy Efficiency Ratio (EER). The EER is the efficiency rating for the equipment at a particular pair of external and internal temperatures, while SEER is calculated over a whole range of external temperatures (i.e., the temperature distribution for the geographical location of the SEER test). SEER is unusual in that it is composed of an Imperial unit divided by an SI unit. The COP is a ratio with the same metric units of energy (joules) in both the numerator and denominator. They cancel out, leaving a dimensionless quantity. Formulas for the approximate conversion between SEER and EER or COP are available.[34]

Each spring and fall before you start using your air conditioner, furnace, or other heating and cooling systems, you should get a tune-up to ensure your HVAC system is ready for the season. By spending a little twice a year, you can save a lot in energy bills by keeping your system operating at peak efficiency. You also can avoid costly repairs by identifying and fixing minor problems before they turn into big ones. Plus, many homeowners don't realize that their manufacturer's warranties may be considered invalid if they aren't getting their unit serviced twice a year.

Central, "all-air" air-conditioning systems (or package systems) with a combined outdoor condenser/evaporator unit are often installed in North American residences, offices, and public buildings, but are difficult to retrofit (install in a building that was not designed to receive it) because of the bulky air ducts required. (Minisplit ductless systems are used in these situations.) Outside of North America, packaged systems are only used in limited applications involving large indoor space such as stadiums, theatres or exhibition halls.

Architectural acoustics Architectural engineering Architectural technologist Building services engineering Building information modeling (BIM) Deep energy retrofit Duct leakage testing Environmental engineering Hydronic balancing Kitchen exhaust cleaning Mechanical engineering Mechanical, electrical, and plumbing Mold growth, assessment, and remediation Refrigerant reclamation Testing, adjusting, balancing
I awoke to a smoky smell from my heater and called HVAC service Heating & Air . I called HVAC and I was given an appointment that afternoon. Their technician arrived promptly and was totally knowledgeable and courteous. He had the new motor and starter on his truck and after a total replacement I now have my morning heat back!! I would use them over n over and they were very competitive in their pricing.
Air conditioners often use a fan to distribute the conditioned air to an occupied space such as a building or a car to improve thermal comfort and indoor air quality. Electric refrigerant-based AC units range from small units that can cool a small bedroom, which can be carried by a single adult, to massive units installed on the roof of office towers that can cool an entire building. The cooling is typically achieved through a refrigeration cycle, but sometimes evaporation or free cooling is used. Air conditioning systems can also be made based on desiccants (chemicals which remove moisture from the air) and subterraneous pipes that can distribute the heated refrigerant to the ground for cooling.[2]
The use of furnaces, space heaters, and boilers as a method of indoor heating could result in incomplete combustion and the emission of carbon monoxide, nitrogen oxides, formaldehyde, volatile organic compounds, and other combustion byproducts. Incomplete combustion occurs when there is insufficient oxygen; the inputs are fuels containing various contaminants and the outputs are harmful byproducts, most dangerously carbon monoxide, which is a tasteless and odorless gas with serious adverse health effects.[14]
An improperly maintained heating and air conditioning is an inefficient heating and air conditioning system. That’s why we provide appointments for annual inspections with our licensed technicians. It’s our goal to make sure that your home is as comfortable and energy-efficient as possible. For inspections, repairs, and service, contact BGE HOME for quality service.
×