Denver HVAC Repair

With the right equipment and regular maintenance, your heating and cooling systems can pay you back. Our NATE-certified technicians are trained to maintain and repair central air conditioners and heat pumps from Carrier and all other brands. If you are experiencing problems with your furnace or AC system, we’ll make sure that your system is working properly, and we won’t leave until the job is complete and your home is comfortable. In this busy world, we understand the importance of prompt appointment scheduling and reliable service. We even offer 24-hour emergency service and after-hours air conditioner repairs that fit your busy schedule.
Waiting or performing repairs yourself could cause further damage to your system, resulting in more expensive repairs. If you suspect a problem with your air conditioner, schedule an appointment with a licensed, trained HVAC technician at Service Professor right away. When it comes to safe and reliable electrical service and repair, leave it to the friendly, skilled electricians at Service Professor. Your Satisfaction is 100% Guaranteed!

Other workers sometimes help HVACR technicians install or repair cooling and heating systems. For example, on a large air conditioning installation job, especially one in which workers are covered by union contracts, ductwork may be installed by sheet metal workers, electrical work by electricians, and pipework by plumbers, pipefitters, and steamfitters. Boiler systems are sometimes installed by a boilermaker.
The Environmental Protection Agency (EPA) requires that all technicians who open a system containing a controlled refrigerant be certified to do so. There are four levels of certification, one of which is a “universal” certification to allow the HVAC technician to work on any type of equipment containing refrigerant. Your HVAC technician should be certified as “Level II Certified” at a minimum or, preferably, “Universal Certification” to work on your central air conditioner. Obtaining this certification information from your professional HVAC technician may be required in the event you are working with a realtor to sell your home. Costs for certification average $40-$240.
Wow! These guys rock! I had issues with our fireplace for a while and the last company who "fixed" the issue basically charged me a lot of money and literally left me standing in the cold. Next they said it would cost me over $700 to fix the whole thing and they never came back. Finally I was able to find some good guys to fix the issue. Tony and Paul from HVAC were not only really friendly, they diagnosed the issue really fast and fixed it the same day. And it was 7 times less than what the other company asked for!!! Next time I know who to call! 5 Stars!
In order to make your everyday life easier and more enjoyable, Sky Heating & Air Conditioning specializes in state-of-the-art heating and cooling technology, partnering with Trane, Mitsubishi, and Waterfurnace.  We bring you HVAC solutions that represent the best the industry has to offer, ensuring long-term performance and satisfaction.  Whether you’re looking for the design/build of a new system, replacement, or hoping to cut costs and enhance convenience, we answer with proven products.  Our qualified HVAC technicians help you determine the ideal solution for your exact requirements, and make sure you’re happy with every step of the process.  From ductless HVAC to geothermal heating and cooling systems, we offer a wide selection of options and comprehensive services to answer any type of challenge.  Call on Sky Heating & Air Conditioning and let us exceed your expectations today!
1/27/2015 Jim, we are committed to 100% satisfaction so every customer is very important to us.… Jim, we are committed to 100% satisfaction so every customer is very important to us.  Unfortunately, with all companies, there will be times when a customer may feel they have been let down.  If that happens with us, we certainly want to hear from you.  To better address your concerns, please contact Steve, our Customer Relations Specialist, directly by email at [email protected] or give him a call at 925-318-4795. Hopefully we will hear from you soon so that we can promptly understand your issue and address the issue! Thanks Jim Read more
If you hear clicking that is followed by a hum or buzz, you’re probably hearing the fan motor attempting to start without the boost it needs from the capacitor. You can almost always conclude that the capacitor has failed. Sometimes you can get the compressor fan spinning (clockwise) by pushing it with a thin stick or long screwdriver poked through the grille. But the chances are good that this might work for one cycle, but the capacitor will fail next time the AC goes on. It’s best to replace the capacitor.
Air-source heat pumps are more popular in milder winter climates where the temperature is frequently in the range of 4–13 °C (40–55 °F), because heat pumps become inefficient in more extreme cold. This is because ice forms on the outdoor unit's heat exchanger coil, which blocks air flow over the coil. To compensate for this, the heat pump system must temporarily switch back into the regular air conditioning mode to switch the outdoor evaporator coil back to being the condenser coil, so that it can heat up and defrost. A heat pump system will therefore have a form of electric resistance heating in the indoor air path that is activated only in this mode in order to compensate for the temporary indoor air cooling, which would otherwise be uncomfortable in the winter.
Stay away front his company!!! In 2008 I had the company send Rick a technician to do warranty work on my new house. I complained about my house being hot in the summer. Tech said that I had a delta t of 14 degrees (the difference of temp coming into the return and out the supply) and that system was functioning properly. Unfortunately I took their word. After 8 years of being hot I called a reputable company to come and check my system again. The HVAC system still operating with a delta t of 14 degrees. The new company looked at my HVAC system owner manual. They calculated my dry bulb temp and wet bulb temp and used the chart in the owners manual to determine that the system wasn't functioning properly. After the new company came a put two pounds of freon into my HVAC system I now have a 20 degree Delta t. Do not do business with this company not trust worthy!
SEER is related to the coefficient of performance (COP) commonly used in thermodynamics and also to the Energy Efficiency Ratio (EER). The EER is the efficiency rating for the equipment at a particular pair of external and internal temperatures, while SEER is calculated over a whole range of external temperatures (i.e., the temperature distribution for the geographical location of the SEER test). SEER is unusual in that it is composed of an Imperial unit divided by an SI unit. The COP is a ratio with the same metric units of energy (joules) in both the numerator and denominator. They cancel out, leaving a dimensionless quantity. Formulas for the approximate conversion between SEER and EER or COP are available.[34]
Through our relationship with Wells Fargo Financial National Bank, Edwards Heating & Air offers a variety of rewarding options for financing your new Carrier product or system with approved credit.  We facilitate your investment in quality solutions to home comfort without straining your monthly budget.  With convenient monthly payments, competitive interest rates, flexible financing terms, and online account management, you can answer an unexpected need, enjoy superior equipment, and take advantage of innovative features that best suit your home and lifestyle.  Carrier financing allows you to save existing funding sources, like a home equity line of credit, credit card or bank account, for other needs or emergencies.  To learn more about financing options, or to hear about special financing promotions, contact Edwards Heating & Air and speak to an informed and helpful member of our team.
With colder weather on its way back to Waldorf, furnace and heating repair may not be the first thing you think about, but maybe it should be. Sure, it’s easy for us to sit here and tell you to schedule annual furnace service, but it’s only because we want to help you avoid a heating breakdown during the coldest day of the month in Waldorf. Day or night, our HVAC experts are here to make sure you have a comfortable home, and can help get your furnace back running in little time.
Fall is here and winter right around the corner which means soon you will be using your furnace day in and day out. With that said, you cannot expect your heating system to perform at peak levels and provide you with all the warmth and comfort you need if you do not take time out to schedule routine maintenance or an immediate furnace repair should you discover a problem with your system exists.
AC air handler buzzing sounds. Do you hear a buzzing sound when you turn on the thermostat? The only thing that comes on in the house when you turn on the thermostat is the fan relay and fan in the air handler or furnace. Try switching the thermostat HEAT/COOL switch to OFF. Then switch the fan switch from AUTO to ON. The fan (only) should come on. If the air handler makes a buzzing sound, it probably has a bad fan relay or, more likely, blower fan.
Air conditioning (often referred to as AC, A/C, or air con)[1] is the process of removing heat and moisture from the interior of an occupied space, to improve the comfort of occupants. Air conditioning can be used in both domestic and commercial environments. This process is most commonly used to achieve a more comfortable interior environment, typically for humans and animals; however, air conditioning is also used to cool/dehumidify rooms filled with heat-producing electronic devices, such as computer servers, power amplifiers, and even to display and store some delicate products, such as artwork.
Modern air conditioning systems are not designed to draw air into the room from the outside, they only recirculate the increasingly cool air on the inside. Because this inside air always has some amount of moisture suspended in it, the cooling portion of the process always causes ambient warm water vapor to condense on the cooling coils and to drip from them down onto a catch tray at the bottom of the unit from which it must then be routed outside, usually through a drain hole. As this moisture has no dissolved minerals in it, it will not cause mineral buildup on the coils. This will happen even if the ambient humidity level is low. If ice begins to form on the evaporative fins, it will reduce circulation efficiency and cause the development of more ice, etc. A clean and strong circulatory fan can help prevent this, as will raising the target cool temperature of the unit's thermostat to a point that the compressor is allowed to turn off occasionally. A failing thermistor may also cause this problem. Refrigerators without a defrost cycle may have this same issue. Dust can also cause the fins to begin blocking air flow with the same undesirable result: ice.
When central air conditioning service fails during a heat spell, you may have to wait days for an HVAC repair technician or a ac contractor to show up, and you’ll probably pay at least several hundred for the repair. But if you’re comfortable working around electricity and are willing to spend about $50 on parts, you can probably repair your air conditioning service yourself in about two hours and save about $225 on parts markup and labor.
×