Denver HVAC Repair

A specialized air conditioner that is used only for dehumidifying is called a dehumidifier. It also uses a refrigeration cycle, but differs from a standard air conditioner in that both the evaporator and the condenser are placed in the same air path. A standard air conditioner transfers heat energy out of the room because its condenser coil releases heat outside. However, since all components of the dehumidifier are in the same room, no heat energy is removed. Instead, the electric power consumed by the dehumidifier remains in the room as heat, so the room is actually heated, just as by an electric heater that draws the same amount of power.
Energy efficiency can be improved even more in central heating systems by introducing zoned heating. This allows a more granular application of heat, similar to non-central heating systems. Zones are controlled by multiple thermostats. In water heating systems the thermostats control zone valves, and in forced air systems they control zone dampers inside the vents which selectively block the flow of air. In this case, the control system is very critical to maintaining a proper temperature.
If your furnace needs to be repaired, you’ll want to find a qualified heating, ventilating and air conditioning (HVAC) repair technician. Each state has its own licensing requirements; some require all HVAC technicians to have an HVAC license, while others only require someone operating an HVAC service and installation company with employees to hold a contractor’s license. For example, in Alabama, the Alabama Board of Heating Air Conditioning, and Refrigeration Contractors regulates licensing, while in Kansas there is no state regulatory body and HVAC licensing can vary by region. For simple furnace repairs like changing out a filter, a trusted handyman can probably handle the job, but a trained professional should be hired for tasks like replacing a gas valve, installing a new inducer fan motor or other critical furnace repair jobs that involve dealing with gas leaks or other dangerous conditions. For more, check out our tips for smart hiring on Thumbtack.
The myth that most people believe is that if you add more refrigerant to the unit it will cool better. This is only true if the evaporator coil is operating below freezing. The unit must have a balanced charge at the correct refrigerant pressure for the temperature and usually, only an HVAC professional can charge your unit properly. Another misconception about refrigerant is that the unit burns it up and it must be replaced from time to time. This is not true. Furthermore, the refrigerant loop is a closed system and barring any leaks the air conditioning system should never need any refrigerant.
The coil is usually made of copper tubing with aluminum fins, but some manufacturers use aluminum tubing. Its purpose is to transfer heat as rapidly as possible. Pressure inside the coil can exceed 400 psi. during extremely warm weather conditions. The cleaner it is kept, the better it transfers heat. Rinsing with a garden hose occasionally when the unit is not running will help keep it operating efficiently. After many years of use it may be necessary to put special chemicals on to clean it.
At Edwards Heating & Air, our dedication to quality extends to every service and product we provide.  Since first opening our doors in 2001, we have continued to protect home and business owners in Acworth and across Acworth, Alpharetta, Cummings, Cartersville, Kennesaw & Woodstock, GA with conscientious workmanship, honest pricing, and exceptional products.  By never failing to handle every project with care and dedication, we earn your satisfaction, recommendation, and business.  We have continued to expand our list of clients by answering every call promptly, responding with courteous service, and delivering rewarding solutions.  Whether you are in need of new installation, replacement, upkeep or repairs for residential or commercial, heating, cooling, ventilation, and air quality, know that Edwards Heating & Air gets results.
We believe that a quality relationship with an HVAC company goes a long way when it comes to maintaining comfort and air quality in your home. When you call Front Range HVAC for an estimate on a new system or to schedule a repair, you can trust that you’re going to receive top quality service, from honest workers who believe in getting you exactly the right equipment for your home.
If you’re concerned about dust, allergens or mold, it may be time to have your air ducts cleaned. The national average cost for air duct cleaning ranges from $190 to $250. Air duct cleaning costs will vary based on a number of factors such as your location in the country, the age and condition of your air ducts, the number of linear feet to be cleaned, and any repairs your ducts may need. HVAC cleaning companies should clearly outline what is included in their services and at what rate, so always make sure you understand and have a written agreement before work begins. Here are some examples of average air duct cleaning costs:

At Peachtree Service Experts Heating & Air Conditioning, we understand heating and air conditioning, which is why we back up our work with our 100% Satisfaction Guarantee*. Not only does it demonstrate our confidence that you’ll be happy with the furnace repair we have completed, it holds us to a higher standard, making sure that we continue to provide you with amazing service without fail. When it’s time to handle any heating and cooling question or problem you have, know that you can trust the team at Peachtree Service Experts regardless of what the Atlanta weather brings.

I could not have been more pleased with the responsiveness, considerate employees, workmanship, and follow up. We used three divisions of Bill Howe when we had a flood due to a water heater/T&P gauge, Plumbing, Remediation and Reconstruction. It was timely, reasonably priced and finished with attention to detail. Ashley in the office was always polite and responsive and we could not have been happier under the circumstances.

Energy efficiency can be improved even more in central heating systems by introducing zoned heating. This allows a more granular application of heat, similar to non-central heating systems. Zones are controlled by multiple thermostats. In water heating systems the thermostats control zone valves, and in forced air systems they control zone dampers inside the vents which selectively block the flow of air. In this case, the control system is very critical to maintaining a proper temperature.
Most modern air-conditioning systems feature a dehumidification cycle during which the compressor runs while the fan is slowed as much as possible[citation needed] to reduce the evaporator temperature and therefore condense more water. When the temperature falls below a threshold, both the fan and compressor are shut off to mitigate further temperature drops;[clarification needed] this prevents moisture on the evaporator from being blown back into the room.[citation needed] When the temperature rises again,[clarification needed] the compressor restarts and the fan returns to low speed.
RepairClinic.com® is the trusted online parts store with 3,000,000+ appliance parts, lawn mower parts, power tools and heating and cooling parts for over 200 appliance, lawn equipment, power tools and heating & cooling equipment brands. Since our launch in 1999, RepairClinic.com has helped 4,500,000+ people save more than $500 million in repair costs by fixing stuff on their own.

Imagine that you’re taking your time at breakfast, watching the morning news, when you hear a clunk coming from your furnace room, and the furnace breaks. Do you know who can come out to service the furnace in Tucker? Our NATE-certified team can service any model of furnace or boiler, and they have earned the most important training and certification in the industry. While you can never truly prevent your furnace from breaking down forever, you can avoid the scenario above by remembering to schedule annual furnace maintenance visits. When a furnace is taken care of, it will perform more efficiently and use less energy, and there is a better chance that there could be fewer costly repairs moving forward.
Evaporative coolers, sometimes called "swamp coolers", do not have a compressor or condenser. Liquid water is evaporated on the cooling fins, releasing the vapor into the cooled area. Evaporating water absorbs a significant amount of heat, the latent heat of vaporisation, cooling the air. Humans and animals use the same mechanism to cool themselves by sweating.
One of the most important ways to maintain the efficiency of your air conditioner is to check on its efficiency periodically throughout the year. In addition to changing your air filters every three months, having a professional heating and cooling professional service your air conditioner before the peak of summer ensures you're not overlooking potential problems. The thorough inspection and tune up of your air conditioner is well worth the low maintenance cost.

“Air conditioners contain refrigerant, which allows the system to run efficiently, releasing heat from the air to cool it. Air conditioners are charged with refrigerant upon installation; a poor charge or a refrigerant leak can cause the system’s refrigerant level to fall below the proper amount. To remedy this, the home AC repair which is performed is a refrigerant recharge, accompanied by fixing the leak if that was the source causing low refrigerant levels.
I was able to get a next day appointment with them last week after multiple other providers did not have availability. The tech was on time and did a good job to diagnose and eventually replace the circuit board and get it up running again. The service itself would be 5 stars, although it did take a week to complete the job due to ordering the part.
R22 (also known as HCFC-22) has a global warming potential about 1,800 times higher than CO2.[61] It was phased out for use in new equipment by 2010, and is to be completely discontinued by 2020. Although these gasses can be recycled when air conditioning units are disposed of, uncontrolled dumping and leaking can release gas directly into the atmosphere.
We pride ourselves on only hiring experts who are qualified at the height of their skill, as well as friendly, approachable, and trustworthy. Past clients have described our technicians as “just good, trustworthy, honest individuals” and “very courteous and very informative as to how my inspection was going...I liked his personality!” Peachtree Service Experts in Mableton makes an effort to pair technicians with families, and it isn’t out of the ordinary to have the same expert servicing your home for years in a row. Relationships between the customer and our company are important to us, and we don’t hire anyone that we wouldn’t want to have working in our own homes.
Central home air conditioner service systems consist of two major components: a condensing unit that sits outside your house, and the evaporator coil (often referred to as an A-coil) that sits in the plenum of your furnace or air handler. The refrigerant in the A-coil picks up the heat from your home and moves it to the outdoor condensing unit. The condensing unit fan blows outside air through the condensing coil to remove the heat. The condensing unit houses the three parts replaceable by a DIYer: the contactor, the start/run capacitor(s) and the condenser fan motor. The condensing unit also houses the compressor, but only a pro can replace that. The A-coil has no parts that can be serviced by a DIYer.
×