Denver HVAC Repair

Modern air conditioning systems are not designed to draw air into the room from the outside, they only recirculate the increasingly cool air on the inside. Because this inside air always has some amount of moisture suspended in it, the cooling portion of the process always causes ambient warm water vapor to condense on the cooling coils and to drip from them down onto a catch tray at the bottom of the unit from which it must then be routed outside, usually through a drain hole. As this moisture has no dissolved minerals in it, it will not cause mineral buildup on the coils. This will happen even if the ambient humidity level is low. If ice begins to form on the evaporative fins, it will reduce circulation efficiency and cause the development of more ice, etc. A clean and strong circulatory fan can help prevent this, as will raising the target cool temperature of the unit's thermostat to a point that the compressor is allowed to turn off occasionally. A failing thermistor may also cause this problem. Refrigerators without a defrost cycle may have this same issue. Dust can also cause the fins to begin blocking air flow with the same undesirable result: ice.
Check that the 240-volt circuit breaker (double-pole breaker) controlling the air-conditioning compressor/condensing unit and the 120-volt circuit breaker controlling the furnace blower or separate air handler, is in the "On" positions. If a circuit breaker has tripped or a fuse is blown, then reset the circuit breaker or replace the fuse. If you reset the breaker or replace the fuse and they trip or blow again, stop and call an air-conditioning service technician, as you may have a more serious problem.
HVAC professionals in the US can receive training through formal training institutions, where most earn associate degrees. Training for HVAC technicians includes classroom lectures and hands-on tasks, and can be followed by an apprenticeship wherein the recent graduate works alongside a professional HVAC technician for a temporary period.[29] HVAC techs who have been trained can also be certified in areas such as air conditioning, heat pumps, gas heating, and commercial refrigeration.[30]
You can keep your air conditioner running efficiently with some preventative care measures. Shut off the power to your AC before cleaning it or performing any of these tasks:  clean your filter at least twice a year; remove leaves and twigs from cages; clean the fins with a garden hose or special spray, then use a butter knife to straighten any that are crooked; keep your yard clean so the fins won't get blocked; cover the unit up for winter; and make sure it's level or you run the risk of damaging the inner workings of the unit.

When it comes to your indoor winter comfort, you should never settle.  A perfectly warm home is important to your daily life, and the performance of your heating system impacts the safety, air quality, and cost of keeping an enjoyable home.  Sky Heating & Air Conditioning protects your ongoing satisfaction with a diverse range of quality heating products and services, including new system installation, replacement, seasonal maintenance, and repair.  We work to improve efficiency, reliability, and safety, and deliver corner to corner temperature control throughout the rooms of your home.  With 24/7 Emergency Services, you’re never left out in the cold.  Contact Sky Heating & Air Conditioning for heating service in The Dalles and Portland, OR, and we’ll provide the exemplary customer service that sets us apart.

Central, "all-air" air-conditioning systems (or package systems) with a combined outdoor condenser/evaporator unit are often installed in North American residences, offices, and public buildings, but are difficult to retrofit (install in a building that was not designed to receive it) because of the bulky air ducts required. (Minisplit ductless systems are used in these situations.) Outside of North America, packaged systems are only used in limited applications involving large indoor space such as stadiums, theatres or exhibition halls.


The HVAC industry has grown a lot since Brennan’s Heating & Air Conditioning opened. Today, high-tech comfort systems require highly-trained technicians who are NATE-certified and experienced in all areas of air conditioning repair, heating, and indoor air quality. After 35+ years, we’ve changed a lot too. At Brennan’s Heating & Air Conditioning, we still provide good, old-fashioned service, but we also offer the full line of cutting-edge products from the heating and cooling experts at Carrier.
An example of a geothermal heat pump that uses a body of water as the heat sink, is the system used by the Trump International Hotel and Tower in Chicago, Illinois. This building is situated on the Chicago River, and uses cold river water by pumping it into a recirculating cooling system, where heat exchangers transfer heat from the building into the water, and then the now-warmed water is pumped back into the Chicago River.[21]
There is nothing worse than having your air conditioner break in the middle of a long, hot summer. You can ensure your air conditioning unit stays in working order all year long with regular service. Sometimes, however, repairs are necessary whether it’s fixing the evaporator, capacitor, or condenser or recharging the refrigerant. Most air conditioner repairs cost between $163 and $528 with most homeowners reporting that they spend about $344. If you do need a repair, here is some information to help you get it done quickly, professionally, and economically.
It can be hard to make the decision to replace or repair your AC unit. However, in many cases, homeowners call in HVAC professionals to check their units and provide a second opinion. A technician can tell you if there’s plenty of life left in your old air conditioning unit or that it’s time to let it go and get a new one. Your HVAC technician may check out your home’s insulation quality, too. You could increase your system’s effectiveness by improving the insulation.
The selection of indoor units has one restriction - their total power should not exceed the capacity of the outdoor unit. In practice, however, it is very common to see a multi-split system with a total capacity of indoor units greater than the outdoor capacity by at least 20%. However, it is wrong to expect better performance when all indoor units are turned on at the same time, since the total capacity of the whole system is limited by the capacity of the outdoor unit. Simply put, the outdoor unit will distribute all its power to all operating indoor units in such a way that some of the rooms may not have a very comfortable temperature level. However, the calculation of the total power is not simple, since it takes into account not only the nominal power of the units, but also the cooling capacity, heating, dehumidification, humidification, venting, etc.
An air conditioning system, or a standalone air conditioner, provides cooling and humidity control for all or part of a building. Air conditioned buildings often have sealed windows, because open windows would work against the system intended to maintain constant indoor air conditions. Outside, fresh air is generally drawn into the system by a vent into the indoor heat exchanger section, creating positive air pressure. The percentage of return air made up of fresh air can usually be manipulated by adjusting the opening of this vent. Typical fresh air intake is about 10%.
This company was highly recommended to us by our realtor. Corey came out to do some work for us and he was really professional. He was on time, and explained everything he was doing and gave a quote (it actually ended up being cheaper!) before he started. He also looked at other stuff for us, and we got the feeling he was being honest and not pushy with his recommendations. We've already booked another appointment to fix some other things, and we requested Corey to do it.
I have a tankless water heater that began to leak. I called around and settled on Bill Howe. Jason came out on Monday and immediately pinpointed the issue. He called the manufacturer, explained what he saw, took a couple of pictures and said he will be back in a couple of days with replacement parts. A few days later Jason called to say he was on his way. He showed up and completed the work in about an hour.

All AC repairs were not created equal. While a new filter could cost as low as $20, a refrigerant leak repair can cost up to $1,600. Just like any aspect of the house, certain repairs will mostly depend on the damage. Clearly, the more serious issues will cost more. That not only means more time for the HVAC pro, but more complexity and materials as well. Sadly, neither come without a hefty markup.

If your furnace needs to be repaired, you’ll want to find a qualified heating, ventilating and air conditioning (HVAC) repair technician. Each state has its own licensing requirements; some require all HVAC technicians to have an HVAC license, while others only require someone operating an HVAC service and installation company with employees to hold a contractor’s license. For example, in Alabama, the Alabama Board of Heating Air Conditioning, and Refrigeration Contractors regulates licensing, while in Kansas there is no state regulatory body and HVAC licensing can vary by region. For simple furnace repairs like changing out a filter, a trusted handyman can probably handle the job, but a trained professional should be hired for tasks like replacing a gas valve, installing a new inducer fan motor or other critical furnace repair jobs that involve dealing with gas leaks or other dangerous conditions. For more, check out our tips for smart hiring on Thumbtack.


Whether you have concerns about your indoor air quality or want to upgrade your air conditioning unit, Aire Serv of Omaha knows how to get the job done. Our Omaha heater repair and AC maintenance experts can tackle problems big and small throughout Bellevue, Carter Lake (IA), St. Columbans, Waterloo, La Vista, and surrounding communities. Trust our team to take care of your heating and air conditioning service needs today.

Central home air conditioner service systems consist of two major components: a condensing unit that sits outside your house, and the evaporator coil (often referred to as an A-coil) that sits in the plenum of your furnace or air handler. The refrigerant in the A-coil picks up the heat from your home and moves it to the outdoor condensing unit. The condensing unit fan blows outside air through the condensing coil to remove the heat. The condensing unit houses the three parts replaceable by a DIYer: the contactor, the start/run capacitor(s) and the condenser fan motor. The condensing unit also houses the compressor, but only a pro can replace that. The A-coil has no parts that can be serviced by a DIYer.
×