Denver HVAC Repair

The selection of indoor units has one restriction - their total power should not exceed the capacity of the outdoor unit. In practice, however, it is very common to see a multi-split system with a total capacity of indoor units greater than the outdoor capacity by at least 20%. However, it is wrong to expect better performance when all indoor units are turned on at the same time, since the total capacity of the whole system is limited by the capacity of the outdoor unit. Simply put, the outdoor unit will distribute all its power to all operating indoor units in such a way that some of the rooms may not have a very comfortable temperature level. However, the calculation of the total power is not simple, since it takes into account not only the nominal power of the units, but also the cooling capacity, heating, dehumidification, humidification, venting, etc.

Perhaps the most sensible way to cool your home is to use your home's heating apparatus. Heat pumps can work in exactly this fashion. This device exchanges warmer and cooler air particles between your home and the outside air, allowing you to create a comfortable environment inside your home without the need of generating your own source of heat and cold. The one major drawback of heat pumps is that they tend to be inadequate in extremely cold or hot temperatures, which Portland essentially never sees. The only reason many homeowners don't have heat pumps in their homes is that they already have a forced air heating system. Thus, the best time to install air conditioning for your home is when your heating system fails.
We believe that a quality relationship with an HVAC company goes a long way when it comes to maintaining comfort and air quality in your home. When you call Front Range HVAC for an estimate on a new system or to schedule a repair, you can trust that you’re going to receive top quality service, from honest workers who believe in getting you exactly the right equipment for your home.

With the split system, the evaporator coil is connected to a remote condenser unit using refrigerant piping between an indoor and outdoor unit instead of ducting air directly from the outdoor unit. Indoor units with directional vents mount onto walls, suspended from ceilings, or fit into the ceiling. Other indoor units mount inside the ceiling cavity, so that short lengths of duct handle air from the indoor unit to vents or diffusers around the rooms.


Our skilled technicians arrive prepared to handle the scope of even complex malfunctions, with all makes and models of heating and cooling equipment, most often resolving the problem on the spot.  For all your HVAC service, repairs, and installations in Livermore, CA, Pleasanton, CA & Dublin, CA, call the team from Miller’s Air Conditioning & Heating!
"Highly recommend! From the time I contacted them to make an appointment, to them showing up, troubleshooting the issue with my a/c unit, them verifying my warranty and driving to Grapevine to get the part, then back to Fort Worth to install it was LESS than 24 hours. Outstanding service, price and knowledge. I will only use this company from now on. Would give ten stars if possible."
A.J. LeBlanc Heating specializes in the installation and service of heating, air conditioning and plumbing systems for residential homes. Whether you are building a new home, converting your existing heating system to a different fuel, upgrading your old unit to a more efficient system, or just adding air conditioning, LeBlanc Heating can service your needs.
Our A/C was blowing hot air intermittently...it was cold one minute and warm the next. By 8pm I'd have a 90 degree interior temp. After one company just took a cursory glance at our A/C and found nothing wrong, I called HVAC. I called them mostly based on Michael W's post on 8/10/14 where he told us the owner, Alberto, took his feedback and took it SERIOUSLY. That speaks VOLUMES to anyone who has been around long enough to know the characteristics of the serious players are and those who are the wannabes. So HVAC sent Tony Diaz to my house. I was at work so he was subjected to the most excruciatingly exacting woman on the planet (my wife). Tony impressed her with his friendliness, professionalism and the obvious jouneyman-level knowledge of his craft. He found literally --burnt-out-- parts in our system and replaced them. It cost us a bit but I know enough about the parts to see there was no gouging on the parts and a fair rate for the labor. It wasn't cheap but it was fair and worth every dime. And now i have A/C in my house again and a repairman came to my house, actually FIXED something AND managed to do so in a friendly & professional manner. That used to be commonplace...nowadays it deserves a "Wow".. Thank you, Tony!
The Refrigeration Loop is a closed system and refrigerant should never have to be added to the unit unless there is a leak. Most residential units use R-22/R410A refrigerant. Prices of R-22/R410A are rising every year as we get closer to the date when refrigerant manufacturers will no longer be able to make R-22/R410A. Phase-out of R-22, an HCFC, begins in 2010 and expected to be complete by 2020.). Furthermore, make sure you ask what the service company charges for R-22 when you are calling an HVAC contractor.

A multi-split system[44] is a conventional split system, which is divided into two parts (evaporator and condenser) and allows cooling or heating of several rooms with one external unit. In the outdoor unit of this air conditioner there is a more powerful compressor, ports for connecting several traces and automation with locking valves for regulating the volume of refrigerant supplied to the indoor units located in the room.


The federal government is phasing out Freon to conserve energy across the nation. Because of this, Freon costs are increasing significantly. If your AC unit uses Freon, eventually you’ll need to replace it to make the switch to the new R410A refrigerant. It’s most likely a good time to consider a replacement if your unit is breaking down or has problems associated with needing more Freon.
Finally, air conditioning and heating maintenance, provided on a regular schedule, can prevent many air conditioner or heater breakdowns thereby preventing the need for you to call an air conditioning and heating repair person for central air conditioning troubleshooting. Maintenance can save you lots of money in the long run but even so, problems can still occur.

Are you considering whether you need to replace your home’s central heating, ventilation, and air conditioning unit—commonly known as your HVAC system? As a general rule, if your existing HVAC system is more than 15 years old, it’s only a matter of time before it starts to cost more to maintain than it would to replace it with a new system. In addition to higher energy bills brought on by a system that can no longer function at peak efficiency, repair costs will also start to add up as parts are replaced and the ventilation system undergoes major overhauls.
In 1758, Benjamin Franklin and John Hadley, a chemistry professor at Cambridge University, conducted an experiment to explore the principle of evaporation as a means to rapidly cool an object. Franklin and Hadley confirmed that evaporation of highly volatile liquids (such as alcohol and ether) could be used to drive down the temperature of an object past the freezing point of water. They conducted their experiment with the bulb of a mercury thermometer as their object and with a bellows used to speed up the evaporation. They lowered the temperature of the thermometer bulb down to −14 °C (7 °F) while the ambient temperature was 18 °C (64 °F). Franklin noted that, soon after they passed the freezing point of water 0 °C (32 °F), a thin film of ice formed on the surface of the thermometer's bulb and that the ice mass was about 6 mm (1⁄4 in) thick when they stopped the experiment upon reaching −14 °C (7 °F). Franklin concluded: "From this experiment one may see the possibility of freezing a man to death on a warm summer's day."[9]
Ventilation is the process of changing or replacing air in any space to control temperature or remove any combination of moisture, odors, smoke, heat, dust, airborne bacteria, or carbon dioxide, and to replenish oxygen. Ventilation includes both the exchange of air with the outside as well as circulation of air within the building. It is one of the most important factors for maintaining acceptable indoor air quality in buildings. Methods for ventilating a building may be divided into mechanical/forced and natural types.[16]
A career in this field may require you to meet certain licensing, training, and other requirements that can vary by vocation and state. You should check with your state, local government, and/or licensing board to find out which requirements may be applicable in your state. Click here for contact information on state licensing/regulatory boards and certain professional licensing information.
In 1992, a non-governmental organization, Greenpeace, was spurred by corporate executive policies and requested that a European lab find substitute refrigerants. This led to two alternatives, one a blend of propane (R290) and isobutane (R600a), and one of pure isobutane.[18][22] Industry resisted change in Europe until 1993, and in the U.S. until 2011, despite some supportive steps in 2004 and 2008 (see Refrigerant Development above).[27][67]
A mini-split system typically supplies air conditioned and heated air to a single or a few rooms of a building.[38] Multi-zone systems are a common application of ductless systems and allow up to 8 rooms (zones) to be conditioned from a single outdoor unit. Multi-zone systems typically offer a variety of indoor unit styles including wall-mounted, ceiling-mounted, ceiling recessed, and horizontal ducted. Mini-split systems typically produce 9,000 to 36,000 Btu (9,500–38,000 kJ) per hour of cooling. Multi-zone systems provide extended cooling and heating capacity up to 60,000 Btu's.
Heat pumps and electric furnaces usually have steam humidifiers to increase output. They are line voltage powered and must be unplugged or disconnected before servicing to avoid injury. With the exception of some mist type humidifiers, all have a reservoir. Stagnant water sitting in the reservoir during the off season can be a breeding ground for bacteria. Turn the water off and clean the humidifier if possible when heating season has ended.

If the unit isn't turning on, check on it outside to make sure the condenser is still running. It should be fully plugged in and the thermostat should be set. Lower the thermostat by a few more degrees than your typical setting. You should hear it power on after doing so. If that doesn't take care of the problem, check your fuse box. You could have a blown fuse or a tripped circuit that's causing the air conditioner to not turn on.
2) Keep your coils clean. The AC coils and fins on the outside of your unit need to be kept clean and clear of obstructions. Leaves and other debris sometimes accumulate around your unit. If obstructions are present, your unit must work harder to function than it should. You can clean your unit with a regular garden hose and a broom. Do not use a pressure washer, as the strong spray could cause harm to your system. A little bit of housekeeping in this regard goes far toward keeping your air conditioner working optimally. 

Van Haaften Plumbing & Heating offers furnace service appointments that help keep your furnace in tip-top shape and operating efficiently for you all year long. Whether that’s discovering small issues before they become big problems, identifying potential safety hazards or making sure you’re staying in line with your manufacturer’s warranty, our experts have you covered. Our trained technicians complete furnace service with care, checking a number of components in and around your equipment. In fact, our multi-point inspection can help make sure your system operates smoothly all winter long.
We believe in building trust and bringing you value for every dollar you spend. Our proven Enhanced Services Program does just that, providing all of the benefits of a full service maintenance program with none of the draw backs. Our transparent process has no pre-existing issue limitations, no equipment or component exclusions, and ensures you receive value for every dollar of your budget.
It’s a rare occasion for a problem to arise with your heating or cooling equipment at a convenient time. In fact, we’re not even certain such a time exists! That’s why the team at HVAC Unlimited stands ready to provide complete emergency heating and cooling repairs. No matter the time of day or the day itself, we can be on the way and ready to provide prompt, cost-efficient services to our Alexandria clients.

Your system is 10 - 15 years old: Follow this simple rule of thumb from Energy Star—if your current system is over 10 years old, it's time to start looking into an HVAC replacement. Most HVAC systems last for about 15 years, so there’s no immediate need to replace yours if it’s still functioning properly. But by doing your research now, you’ll know just what you want to do should your HVAC system suddenly stop working properly.


We were following up on this review and the service call we did for you. We could not find you in our system of ever having gone out to your home. If you could please provide us with the date we were out and the name under which the call was placed that would be great as we would like to see if there is any way we can rectify the situation. We do offer a 100% Satisfaction Guarantee, we have tried to private message you to no avail. Can you please call us at 925-318-4795?  
The selection of the working fluids (refrigerants) has a significant impact not only on the performance of the air conditioners but on the environment as well. Most refrigerants used for air conditioning contribute to global warming, and many also deplete the ozone layer.[59] CFCs, HCFCs, and HFCs are potent greenhouse gases when leaked to the atmosphere.
The belt should slip right into place. If it seems to be too tight or difficult to set in place, it may be necessary to adjust the motor mount to provide more slack. Then you can re-tighten the tension once the belt is in place. Check the manufacturer’s specifications for proper tension—in most cases, the belt should deflect about an inch when you press down on it.
Just like running a marathon, we perform better at full strength. If we’re not feeling great, it’s that much harder to finish the race. Similarly, when you set your thermostat to a certain temperature, the system is tasked with maintaining that temperature throughout the room. Working at full strength, the system can easily maintain that temperature (as long as it’s not below 60 degrees or above 80 degrees). However, when injured, the system may struggle to keep the room at your desired temperature. As such, it’s working harder, which means higher utility bills.
Its unique feature is the presence of one main external unit that connected to several indoor units. Such systems might be the right solution for maintaining the microclimate in several offices, shops, large living spaces. Just few of outdoor units do not worsen the aesthetic appearance of the building.The main external unit can be connected to several different indoor types: floor, ceiling, cassette, etc.
We have been using Bill Howe Plumbing's service for more than 25 years and have been pleasantly surprised at how consistently they perform an excellent service call. We use them for our home and our rental properties, and their dispatchers and technicians have always been the best at problem solving; our tenants have told us how great the service is as well. When we needed air conditioning service, naturally we called Bill Howe first. There's no reason to call anyone else. I know the job will be done right the first time, with fair pricing and professional service.
Reinstall the access panel and disconnect block. Turn on the circuit breaker and furnace switch. Then set the thermostat to a lower temperature and wait for the AC to start (see “Be Patient at Startup,” below). The compressor should run and the condenser fan should spin. If the compressor starts but the fan doesn’t, the fan motor is most likely shot. Shut off the power and remove the screws around the condenser cover. Lift the cover and remove the fan blade and motor (photo 7). Reinstall the blade and secure the cover. Then repower the unit and see if the fan starts. If it doesn’t, you’ve given it your best shot—it’s time to call a pro.
×