An important component of natural ventilation is air change rate or air changes per hour: the hourly rate of ventilation divided by the volume of the space. For example, six air changes per hour means an amount of new air, equal to the volume of the space, is added every ten minutes. For human comfort, a minimum of four air changes per hour is typical, though warehouses might have only two. Too high of an air change rate may be uncomfortable, akin to a wind tunnel which have thousands of changes per hour. The highest air change rates are for crowded spaces, bars, night clubs, commercial kitchens at around 30 to 50 air changes per hour.
Without proper ventilation, carbon monoxide can be lethal at concentrations of 1000 ppm (0.1%). However, at several hundred ppm, carbon monoxide exposure induces headaches, fatigue, nausea, and vomiting. Carbon monoxide binds with hemoglobin in the blood, forming carboxyhemoglobin, reducing the blood's ability to transport oxygen. The primary health concerns associated with carbon monoxide exposure are its cardiovascular and neurobehavioral effects. Carbon monoxide can cause atherosclerosis (the hardening of arteries) and can also trigger heart attacks. Neurologically, carbon monoxide exposure reduces hand to eye coordination, vigilance, and continuous performance. It can also affect time discrimination.
Our technicians have experience repairing furnaces and will make sure your home is back to keeping you comfortable in no time. From training and certifications to our reputation for getting the job done right time and time again, you can be sure that Van Haaften Plumbing & Heating’s furnace repair technicians will have your troubles taken care of and your furnace running smoothly. Whether it’s emergency furnace repair or service you can schedule some time in advance, our team can provide you peace of mind, knowing that your furnace is in skilled hands. Need a furnace repair? When performing a repair, it's vital to source professional HVAC contractors.
I needed a replacement for my heater. I called Bill Howe and they promptly fitted me into their schedule. The person who arrived, Laurence C. thoroughly tested my furnace and pointed out the problem. I decided to replace it. They arrived on the day to install it. The two men, Jose Gomez and Javier Diaz promptly went to work. They were clean, efficient and respectful of my home. I would gladly recommend Bill Howe for your heating and plumbing needs. They were great!!
I call to follow up at the end of the next day and she said that she has not been able to get in touch with the owner. By this time, I am starting to get frustrated because I am starting to get the run around. I question her if I am even on the schedule or if they attempted to schedule a crane. She says they are extremely busy and that she does not know. So I say, basically I have waited over 2 weeks and you have not put me on the schedule and I am at the end of the install line. No answer. I tell her to talk to her boss and find out what is happening, and I will think about what direction I want to move in at this point.
Ground source, or geothermal, heat pumps are similar to ordinary heat pumps, but instead of transferring heat to or from outside air, they rely on the stable, even temperature of the earth to provide heating and air conditioning. Many regions experience seasonal temperature extremes, which would require large-capacity heating and cooling equipment to heat or cool buildings. For example, a conventional heat pump system used to heat a building in Montana's −70 °F (−57 °C) low temperature or cool a building in the highest temperature ever recorded in the US—134 °F (57 °C) in Death Valley, California, in 1913 would require a large amount of energy due to the extreme difference between inside and outside air temperatures. A few feet below the earth's surface, however, the ground remains at a relatively constant temperature. Utilizing this large source of relatively moderate temperature earth, a heating or cooling system's capacity can often be significantly reduced. Although ground temperatures vary according to latitude, at 6 feet (1.8 m) underground, temperatures generally only range from 45 to 75 °F (7 to 24 °C).
As we all know, San Diego can get pretty warm in the summer and also quite chilly in the winter. So, in order to avoid discomfort, it is important to ensure your heating and air conditioning systems are working properly beforehand. That’s where our HVAC San Diego professionals come in. Our crew members have both the knowledge and expertise to ensure that every heating and air conditioning unit, no matter the make or model, is running at peak performance.
Air conditioners improperly installed will develop air duct leaks and low air flow. Your air conditioner looses its cooling power in hot weather. A lack of maintenance will cause your air conditioner to malfunction. Refrigerant charges and compressors are some of the parts needing regular maintenance. Regular maintenance increases the lifespan and production of your air conditioner.
HVAC repair technicians are properly qualified to take care of anything that relates to installing, maintaining or repairing your heating, air conditioning and refrigeration systems. Our professionals have gone through rigorous training and certification and all our technicians and equipment installers are NATE-certified, which involves demanding testing and indicates a solid understanding of the industry.