Denver HVAC Repair

Air conditioners can create a lot of water because they remove moisture from the air. To get rid of this, they have a [usually plastic] drain pipe that comes out of the side of the air handler. Over time, algae can block this pipe and, when it does, the AC won’t work. In fact, some condensate drains have a float switch that won’t let the AC run if water backs-up. Water can also puddle around the unit or flood the area. To deal with condensate problems, please see Air Conditioner Leaks Water, below.

We service and install forced air systems from all manufacturers, including Trane, Burnham, Heil, Rheem, and many more. If your home needs a new system, we will recommend the best system for your needs and budget. If you have a brand preference, we can recommend and provide qualified installation of a system from that company that fits your home’s needs.
Before opening the electrical cover on the A/C unit, be sure to shut off all power to the compressor unit and the indoor furnace or air handler, and verify that it is off. Note that this may mean shutting off a circuit breaker that serves the furnace and air handler, and then, near the compressor, pulling out the disconnect block (or shutting off the 220-volt power) to the outdoor compressor.
San Jose, CA ServicesLOWE'S OF CENTRAL SAN JOSE - Bathroom Design and RemodelAll Weather Roofing. Roofing Contractor - San Jose, CACuong's Carpet Cleaning. Carpet Cleaner - San Jose, CAE Z Home. Landscaping Company - San Jose, CACrown Plumbing. Plumber - San Jose, CAGardens Alive Landscape MaintenenceMarcone Appliance PartsJet Dry Carpet CleaningPatrick Ross ConstSwat Pest ControlAwr DumpstersTron Air
Replacing a capacitor is easy. Just take a photo of the wires before disconnecting anything (you may need a reference later on). Then discharge the stored energy in the old capacitor (Photo 4). Use needle-nose pliers to pluck one wire at a time from the old capacitor and snap it onto the corresponding tab of the new capacitor. The female crimp connectors should snap tightly onto the capacitor tabs. Wiggle each connector to see if it’s tight. If it’s not, remove the connector and bend the rounded edges of it so it makes a tighter fit on the tab. When you’ve swapped all the wires, secure the new capacitor (Photo 5).
AC units and thermostats have built-in delay features when they’re shut down and then repowered. The delay can be as long as 10 minutes. And, if you’ve subscribed to an energy-saving device from your local power utility, the unit can take even longer to reset. If you’ve installed the parts shown and reinstalled the disconnect block, repowered the circuit breaker, turned on the switch at the furnace, moved the thermostat to AC mode and lowered the temperature below the indoor temperature, and the unit doesn’t fire up after 30 minutes, it’s time to call a pro.
Camera, Video & SurveillanceAction Cameras & Drones,Camcorders,Dash...3504 Car Electronics & GPSCar Audio,Car Mounts & Accessories,Car S...1802 Cell Phones & AccessoriesBackup Batteries,Bluetooth Devices,Cable...12628 Computers & TabletsComputer Accessories,Desktops, Monitors...5511 Musical InstrumentsAccessories,Amplifiers & Effects,Brass &...1909 Office Electronics & SuppliesNetworking,Printers & Scanners,Scanners...2201 Portable AudioBluetooth & Wireless Speakers,Docks, Rad...3233 Smart HomeCameras & Surveillance,Door Locks,Garage...104
Was not satisifed with this company.  This person came out and took 10 minutes only to tell me that my unit would not last for a year and that I needed to have it replaced!  I'm not sure if he was very knowlegable or if he was just plain lazy and do not even try to fix the problem.  He just wanted to install a brand new system because he was both and of course, that's much more money for him!

Air duct cleaning is done by heating, ventilation and air conditioning (HVAC) professionals. The pros use industrial-strength, truck-mounted vacuums and powerful brushes and hoses to clean inside the metal ducts that make up your forced air heating and cooling system. The Environmental Protection Agency recommends duct cleaning if there is “substantial visible mold growth inside hard surface ducts, ducts that are infested with vermin such as rodents or insects, or ducts that are clogged with excessive amounts of dust and debris and/or particles are actually released into the home from your supply registers.”

An improperly maintained heating and air conditioning is an inefficient heating and air conditioning system. That’s why we provide appointments for annual inspections with our licensed technicians. It’s our goal to make sure that your home is as comfortable and energy-efficient as possible. For inspections, repairs, and service, contact BGE HOME for quality service.

Fast forward 1 year and 1 week and the circuit board that HVAC Service had installed has failed again. They came out and said that it failed from water condensation dripping onto it, so we needed to replace it and reroute the pipes to prevent future water damage. That would cost double what I paid last year. Why didn't they fix the problem last year at the initial repair instead of putting in a circuit board that was bound to fail again?!? They were strongly recommending that the furnace be completely replace for a huge fee to avoid the same thing happening again. I paid $59 for them to tell me they didn't fix it right last year. This didn't feel right, so I sought a second opinion. I'm very glad that I found another guy to come replace the circuit board and put it away from the water, fix the water leak, and also find and fix another impending failure. All of that was for much less than HVAC Service wanted to charge for repair or replacement. The other guy did a great repair, so I'm confident it will not break down again, but if it does, I will not call HVAC Service. Don't get suckered by their Yelp Deal.


Van Haaften Plumbing & Heating offers furnace service appointments that help keep your furnace in tip-top shape and operating efficiently for you all year long. Whether that’s discovering small issues before they become big problems, identifying potential safety hazards or making sure you’re staying in line with your manufacturer’s warranty, our experts have you covered. Our trained technicians complete furnace service with care, checking a number of components in and around your equipment. In fact, our multi-point inspection can help make sure your system operates smoothly all winter long.

“We had a great experience with Robinson’s! The office staff, then the gentleman who helped me with questions over the phone and Kyle, our service tech, were all great and very easy to work with. They gave me a time frame for when to expect Kyle the same day. A phone call to let me know he was on his way. A text with picture so I knew who to be expecting. Kyle arrived on time and was very knowledgeable and friendly. He did a great job. You could tell he liked his job. Prices were reasonable. We will be using and recommending Robinson’s Air – Wichita Falls in the future.”
Replacing a capacitor is easy. Just take a photo of the wires before disconnecting anything (you may need a reference later on). Then discharge the stored energy in the old capacitor (Photo 4). Use needle-nose pliers to pluck one wire at a time from the old capacitor and snap it onto the corresponding tab of the new capacitor. The female crimp connectors should snap tightly onto the capacitor tabs. Wiggle each connector to see if it’s tight. If it’s not, remove the connector and bend the rounded edges of it so it makes a tighter fit on the tab. When you’ve swapped all the wires, secure the new capacitor (Photo 5).
×