Denver HVAC Repair

Throughout the coldest months of winter—especially in North America—a heating system repair is probably not something you want on your mind, but it likely will be if you need it on a bone-chilling day. You are in luck though, because Service Experts Heating & Air Conditioning is committed to doing expert quality furnace and heat pump repair, maintenance and installation through North America. It’s our job to make sure you are left with complete comfort in your home.
A career in this field may require you to meet certain licensing, training, and other requirements that can vary by vocation and state. You should check with your state, local government, and/or licensing board to find out which requirements may be applicable in your state. Click here for contact information on state licensing/regulatory boards and certain professional licensing information.
The main problem when installing a multi-split system is the laying of long refrigerant lines for connecting the external unit to the internal ones. While installing a separate split system, workers try to locate both units opposite to each other, where the length of the line is minimal. Installing a multi-split system creates more difficulties, since some of indoor units can be located far from the outside. The first models of multi-split systems had one common control system that did not allow you to set the air conditioning individually for each room. However, now the market has a wide selection of multi-split systems, in which the functional characteristics of indoor units operate separately from each other.

Gas Furnaces Sequence of Operation | Electronic Ignition Gas Furnace Problems Troubleshooting | How To Light a Pilot Light | Heat Pump Breaker Trips | How Heat Pumps Work | Heat Pump Sequence of Operation | Condenser Fan Motor Repair | Air Conditioner Compressor Troubleshooting | Fuel-Gas Code Overview | SEER Definition | Air Conditioner Reviews | Boiler Reviews | Heat Pump Reviews | Heat Pump Problems | How to Wire a Thermostat | Goodman Heat Pump Reviews | Weil-McLain Boiler Reviews | Rheem Package Unit Reviews | Troubleshooting Broken Thermostats | Trane Versus Carrier Gas Furnaces | Carrier Heat Pump Reviews | Rheem Heat Pump Reviews | Trane Gas Furnace Reviews | Amana Gas Furnace Reviews
A heat pump is an air conditioner in which the refrigeration cycle can be reversed, producing heating instead of cooling in the indoor environment. They are also commonly referred to as a "reverse cycle air conditioner". The heat pump is significantly more energy efficient than electric resistance heating. Some homeowners elect to have a heat pump system installed as a feature of a central air conditioner. When the heat pump is in heating mode, the indoor evaporator coil switches roles and becomes the condenser coil, producing heat. The outdoor condenser unit also switches roles to serve as the evaporator, and discharges cold air (colder than the ambient outdoor air).
The use of furnaces, space heaters, and boilers as a method of indoor heating could result in incomplete combustion and the emission of carbon monoxide, nitrogen oxides, formaldehyde, volatile organic compounds, and other combustion byproducts. Incomplete combustion occurs when there is insufficient oxygen; the inputs are fuels containing various contaminants and the outputs are harmful byproducts, most dangerously carbon monoxide, which is a tasteless and odorless gas with serious adverse health effects.[14]
For details about apprenticeships or other work opportunities, contact the offices of the state employment service, the state apprenticeship agency, local contractors, or local union–management HVACR apprenticeship committees. Apprenticeship information is available from the U.S. Department of Labor’s Apprenticeship program online or by phone at 877-872-5627.
This is a very common air conditioning problem. The unit will cool for a few hours and then it stops cooling all together. The next day or several hours later the air conditioning is cooling again but for only a few hours and then the air conditioning stops again. The reason this is happening is because the air conditioning unit is low on refrigerant because you have a refrigerant leak (the unit could freeze because of a few other air conditioning problems but this is the most common reason).
Abacus’ licensed Electricians can troubleshoot any electrical problems you may have and replace or repair items such as electrical panels and circuit boards, electric surge protection, LED lighting, ceiling fans, complex electrical wiring or rewiring, backup or standby electric generators and more. Want an annual electrical inspection on all your lighting and electrical systems? Ask about the AMP Plan that can save you up to 15% on electrical repairs. This plan includes many things such as an annual electrical safety check to make sure that your home is safe and working properly for you and your family. Our licensed electricians will make sure that the electricity in your home is running at maximum efficiency.
If your air conditioner’s condenser coils, which are located in the outdoor unit, freeze up, your system will not run properly. Poor airflow through your cooling system can cause ice to form on the coils. Obstructions are typically the cause – such as dirty air filters or blocked return air ducts. Low refrigerant could also be the cause, requiring a refrigerant charge. A home AC repair technician can diagnose the issue behind your frozen coils, resolve it, and safely thaw your coils to restore cooling in your home.”

Before opening the electrical cover on the A/C unit, be sure to shut off all power to the compressor unit and the indoor furnace or air handler, and verify that it is off. Note that this may mean shutting off a circuit breaker that serves the furnace and air handler, and then, near the compressor, pulling out the disconnect block (or shutting off the 220-volt power) to the outdoor compressor.
This time we had a major issue with our sewage line related to roots. Was terrible. But we called Billy Howe and Mike came and did an Incredible job. Not only he explained really well what was going on but he was careful and knowledgeable. I was so relief that not only we trust in BH team but we were lucky that was Mike coming to execute the service.
In modern buildings, the design, installation, and control systems of these functions are integrated into one or more HVAC systems. For very small buildings, contractors normally estimate the capacity and type of system needed and then design the system, selecting the appropriate refrigerant and various components needed. For larger buildings, building service designers, mechanical engineers, or building services engineers analyze, design, and specify the HVAC systems. Specialty mechanical contractors then fabricate and commission the systems. Building permits and code-compliance inspections of the installations are normally required for all sizes of building.

We are service professionals! As licensed contractors and specialists in the field of heating and air conditioning, we have the tools, the equipment, and the experience to keep your equipment running smoothly all year long. If it is emergency service that you need, we are available to assist you! To help reduce service emergencies, we offer service agreements to keep your comfort system running at peak performance.
Natural ventilation is the ventilation of a building with outside air without using fans or other mechanical systems. It can be via operable windows, louvers, or trickle vents when spaces are small and the architecture permits. In more complex schemes, warm air is allowed to rise and flow out high building openings to the outside (stack effect), causing cool outside air to be drawn into low building openings. Natural ventilation schemes can use very little energy, but care must be taken to ensure comfort. In warm or humid climates, maintaining thermal comfort solely via natural ventilation might not be possible. Air conditioning systems are used, either as backups or supplements. Air-side economizers also use outside air to condition spaces, but do so using fans, ducts, dampers, and control systems to introduce and distribute cool outdoor air when appropriate.
“We had a great experience with Robinson’s! The office staff, then the gentleman who helped me with questions over the phone and Kyle, our service tech, were all great and very easy to work with. They gave me a time frame for when to expect Kyle the same day. A phone call to let me know he was on his way. A text with picture so I knew who to be expecting. Kyle arrived on time and was very knowledgeable and friendly. He did a great job. You could tell he liked his job. Prices were reasonable. We will be using and recommending Robinson’s Air – Wichita Falls in the future.”
I called HVAC on a Saturday morning to come and look at the A/C. The woman answering the phone told… I called HVAC on a Saturday morning to come and look at the A/C. The woman answering the phone told me that she would call the technician and call me back with a service window of when he would be there.  Hours later, she still hadn't called back. When I called back to follow up, the new lady answering the phone told me the original woman had given me miss information. They were a call center and could only text the technician (who of course was supposed to be hadn't called me back)! She texted him again and when he finally called back, he told me I'd have to make an appointment for Tuesday! What's the point of after-hours emergency A/C service if I have to wait until three days later and have them come during normal business hours?! Unbelievably poor service! Read more
Central home air conditioner service systems consist of two major components: a condensing unit that sits outside your house, and the evaporator coil (often referred to as an A-coil) that sits in the plenum of your furnace or air handler. The refrigerant in the A-coil picks up the heat from your home and moves it to the outdoor condensing unit. The condensing unit fan blows outside air through the condensing coil to remove the heat. The condensing unit houses the three parts replaceable by a DIYer: the contactor, the start/run capacitor(s) and the condenser fan motor. The condensing unit also houses the compressor, but only a pro can replace that. The A-coil has no parts that can be serviced by a DIYer.
×