Denver HVAC Repair

The heat-exchanger cools the air that is being forced through it by the furnace blower. As the warm air comes in contact with this cool surface the water in the air condenses. By pulling the water molecules from the air. According to the psychometric chart[42] as relative humidity decreases in order to feel cool you will have to lower the temperature even more. A common way to counteract this effect is by installing a whole-home humidifier.[43] Similarly, installing a high efficient system this need to turn the temperature down wont have such and influence on your energy costs.
After discussing faulty AC system symptoms with you, Jiffy Lube® technicians begin the service by visually inspecting the air conditioning compressor drive belt, serpentine belt and all accessible components for cracks, leaks or damage. Then they check the operation of the air conditioning compressor. If no leaks or damage are found, they evacuate the refrigerant from the system, vacuum test it, and recharge the air conditioning system using the appropriate refrigerant according to your vehicle manufacturer's recommendations.

Not obvious is the fact that they need maintenance routinely, just like any other machine. The filter, usually located behind the front grill, needs to be washed. The condenser coil at the back of the unit can accumulate a lot of debris, and might require a special chemical bath. All air conditioning systems, large or small, need good air flow across the evaporator coil and the condenser coil. Efficiency and performance drop rapidly as air flow decreases. Lose enough air flow and the unit will burn out. Rodents can nest inside when not in use, and can foul up the unit in many ways. Wasps and hornets, as well as the honey bee find finned coils to be comfortable nesting places. Nests and dead insects can ruin the air conditioner.
James Heating & A/C, Inc offers furnace service appointments that help keep your furnace in tip-top shape and operating efficiently for you all winter long. Whether that’s finding small issues before they become big problems, identifying potential safety hazards or making sure you’re maintaining your manufacturer’s warranty, our experts have you covered. Our trained technicians complete furnace service with care, inspecting a number of components in and around your furnace. In fact, our multi-point inspection can help make sure your system runs smoothly throughout the winter.

Reinstall the access panel and disconnect block. Turn on the circuit breaker and furnace switch. Then set the thermostat to a lower temperature and wait for the AC to start (see “Be Patient at Startup,” below). The compressor should run and the condenser fan should spin. If the compressor starts but the fan doesn’t, the fan motor is most likely shot. Shut off the power and remove the screws around the condenser cover. Lift the cover and remove the fan blade and motor (photo 7). Reinstall the blade and secure the cover. Then repower the unit and see if the fan starts. If it doesn’t, you’ve given it your best shot—it’s time to call a pro.
Our A/C was blowing hot air intermittently...it was cold one minute and warm the next. By 8pm I'd have a 90 degree interior temp. After one company just took a cursory glance at our A/C and found nothing wrong, I called HVAC. I called them mostly based on Michael W's post on 8/10/14 where he told us the owner, Alberto, took his feedback and took it SERIOUSLY. That speaks VOLUMES to anyone who has been around long enough to know the characteristics of the serious players are and those who are the wannabes. So HVAC sent Tony Diaz to my house. I was at work so he was subjected to the most excruciatingly exacting woman on the planet (my wife). Tony impressed her with his friendliness, professionalism and the obvious jouneyman-level knowledge of his craft. He found literally --burnt-out-- parts in our system and replaced them. It cost us a bit but I know enough about the parts to see there was no gouging on the parts and a fair rate for the labor. It wasn't cheap but it was fair and worth every dime. And now i have A/C in my house again and a repairman came to my house, actually FIXED something AND managed to do so in a friendly & professional manner. That used to be commonplace...nowadays it deserves a "Wow".. Thank you, Tony!
The most recognized standards for HVAC design are based on ASHRAE data. The most general of four volumes of the ASHRAE Handbook is Fundamentals; it includes heating and cooling calculations. Each volume of the ASHRAE Handbook is updated every four years. The design professional must consult ASHRAE data for the standards of design and care as the typical building codes provide little to no information on HVAC design practices; codes such as the UMC and IMC do include much detail on installation requirements, however. Other useful reference materials include items from SMACNA, ACGIH, and technical trade journals.
The condenser fan is another important HVAC element that must be maintained. Condenser fans that contain oil ports should be lubricated at least annually. The outside condenser should also be shielded from direct sunlight if possible. Keeping vegetation at least two feet away from outdoor HVAC units will also promote higher performance and potentially lower energy bills due to higher efficiency. The further away vegetation is, the better an HVAC unit will operate. 
Fall is here and winter right around the corner which means soon you will be using your furnace day in and day out. With that said, you cannot expect your heating system to perform at peak levels and provide you with all the warmth and comfort you need if you do not take time out to schedule routine maintenance or an immediate furnace repair should you discover a problem with your system exists.
At Sky Heating & Air Conditioning, we understand that HVAC services can really hurt your budget. Many times, you don’t expect to make such large purchases until an emergency arises. We never want you to feel that you cannot afford your comfort and safety. We offer flexible financing options through the Home Project credit card from Wells Fargo, with approved credit. Head over to our financing page to apply, or give us a call for more information!
Central home air conditioner service systems consist of two major components: a condensing unit that sits outside your house, and the evaporator coil (often referred to as an A-coil) that sits in the plenum of your furnace or air handler. The refrigerant in the A-coil picks up the heat from your home and moves it to the outdoor condensing unit. The condensing unit fan blows outside air through the condensing coil to remove the heat. The condensing unit houses the three parts replaceable by a DIYer: the contactor, the start/run capacitor(s) and the condenser fan motor. The condensing unit also houses the compressor, but only a pro can replace that. The A-coil has no parts that can be serviced by a DIYer.
×